Imposing accurate wall boundary conditions in corrective‐matrix‐based moving particle semi‐implicit method for free surface flow

Corrective matrix that is derived to restore consistency of discretization schemes can significantly enhance accuracy for the inside particles in the Moving Particle Semi‐implicit method. In this situation, the error due to free surface and wall boundaries becomes dominant. Based on the recent study on Neumann boundary condition (Matsunaga et al, CMAME, 2020), the corrective matrix schemes in MPS are generalized to straightforwardly and accurately impose Neumann boundary condition. However, the new schemes can still easily trigger instability at free surface because of the biased error caused by the incomplete/biased neighbor support. Therefore, the existing stable schemes based on virtual particles and conservative gradient models are applied to free surface and nearby particles to produce a stable transitional layer at free surface. The new corrective matrix schemes are only applied to the particles under the stable transitional layer for improving the wall boundary conditions. Three numerical examples of free surface flows demonstrate that the proposed method can help to reduce the pressure/velocity fluctuations and hence enhance accuracy further.     

基于共轭梯度法的感知矩阵优化方法

压缩感知理论中降低信号维数的关键问题是构造有效的测量矩阵。在已知稀疏基的情况下，基于ETF（Equiangular Tight Frame）框架的测量矩阵构造方法和稀疏信号重构过程均依赖于感知矩阵。为此，设计了一种基于共轭梯度法的感知矩阵优化方法，该方法简单易行，且所求结果的Gram矩阵与目标Gram矩阵更接近。 实验结果表明，此感知矩阵优化方法在理论分析、实际图像应用及算法有效性上均具优势。     

Structural and phase characteristics of the diamond/matrix interfacial zone in high-resistant diamond composites

The structural-phase state of the contact zone and the factors that influence on the strength of diamond retention in the diamond carbide composites were determined. Composites were obtained by the new hybrid technology that eliminates the reheating of the metalized coating. The elaborated technology combines the thermal diffusion metallization of a diamond and the sintering by the scheme of self-dosed impregnation in a one-stage technological cycle. By the methods of electron microscopy, X-ray diffraction analysis, and Raman spectroscopy the structural and phase characteristics of the interphase boundary were investigated. The improvement of chemical and mechanical adhesion between the diamond and carbide matrix was obtained. It was shown that the specific productivity of the samples with a metalized diamond component is 39% higher than those without metallization.     

Ring-Stacking Water Clusters: Morphology and Stabilities

The structures and interaction energies of water clusters with ring stacking motifs are studied by using ab initio calculations. The structures of the water clusters are constructed by stacking either single rings or multi-rings of tetramer, pentamer, and hexamer. We found that, in the single-ring-stacking motif, the most stable isomers exhibit an alternative clockwise-anticlockwise stacking pattern. We also show that four-layer single-ring-stacking isomers are not energetically favorable in comparison with those of two-layer multi-ring-stacking isomers. The relative stability of the isomers is also analyzed in terms of H-bond strength and elastic distortions of the water molecules.     

Divagations about the periodic table: Boolean hypercube and quantum similarity connections

In this study, several simple aspects associated with the periodic table (PT) of the elements are commented. First, the connection of the PT with the structure of a seven-dimensional Boolean hypercube leads afterward to discuss the nature of those PT elements bearing prime atomic numbers. Second, the use of quantum similarity (QS) to obtain an alternative insight on the PT element relations will be also developed. The foundation of the second part starts admitting that any element of the PT can be attached to a schematic electronic density function, constructed with a single Gaussian function: a Gaussian atomic density function, allowing to consider the PT elements as a set of quantum objects, and permits a straightforward construction of a QS matrix. Such QS scheme can be applied to the whole PT or to any subset of it. Manipulation of the QS matrices attached to any quantum object set allows the evaluation of statistical-like values, acting as coordinates to numerically or graphically represent the chosen PT atomic element sets. © 2019 Wiley Periodicals, Inc.     

The martingale problem for a class of nonlocal operators of diagonal type

We consider systems of stochastic differential equations of the form $$\begin{array}{c}\hfill d{X}_t^i=\sum _{j=1}^d{A}_{ij}\left(X_{t?}\right)d{Z}_t^j\end{array}$$ for $i=1,?,d$ with continuous, bounded and non‐degenerate coefficients. Here $Z_t^1,?,Z_t^d$ are independent one‐dimensional stable processes with ${\alpha }_1,?,{\alpha }_d\in (0,2)$. In this article we research on uniqueness of weak solutions to such systems by studying the corresponding martingale problem. We prove the uniqueness of weak solutions in the case of diagonal coefficient matrices.