Improved Method for the Total Synthesis of Azaperone and Investigation of Its Electrochemical Behavior in Aqueous Solution

Azaperone, with anti-anxiety and anti-aggressive activities used in veterinary medicine, is a member of the butyrophenone class. It is ordinarily utilized for a wide range of indications, such as sedation, obstetrics, and anesthesia. In this research, an improved synthetic route is presented for azaperone using a phase-transfer catalyst(PTC). In general, it was synthesized as a dopamine antagonist in four steps. The bis(2-chloroethyl) amine intermediate is easily obtained after the conversion of the alcohol groups into the chloride leaving group using thionyl chloride(95% yields). The alkylation of commercially available 2-amino pyridine in the presence of PTC was then carried out, giving 1-(pyridin-2-yl) piperazine with 75% yield. 1-(Pyridin-2-yl) piperazine was finally alkylated using 4-chloro-1-(4-fluorophenyl) butan-1-one to achieve azaperone with 60% yield. The butyrophenone intermediate was obtained via the Friedel-Crafts reaction of fluorobenzene with 4-chlorobutyryl chloride in the presence of AlCl₃. High efficiency, gentle reaction conditions, and fast and simple procedure are the advantages of this method. Also, the electrochemical oxidation behaviour of azaperone was investigated using cyclic and differential pulse voltammetry techniques. Cyclic voltammetric studies indicated an irreversible process for azaperone electro-oxidation with a peak potential of 0.78 V in a phosphate buffer solution(pH=7.0) vs. Ag/AgCl(saturated KCl) electrode. The value of the peak current vs. the azaperone concentration was enhanced linearly in the range of 10―70 μmol/L, and the detection limit was found to be 3.33 μmol/L.     

基于摩擦磨损的KDP晶体固结磨料抛光垫优化

本文通过固结磨料球与KDP晶体对磨的单因素试验探究固结磨料球中反应物种类、磨粒浓度、反应物浓度、基体硬度对摩擦系数、磨痕截面积和磨痕处粗糙度的影响,试验结果表明:KHCO₃固结磨料球对磨后磨痕对称性好,磨痕处的粗糙度值低;磨痕截面积随磨粒和反应物浓度的增加而增大,随基体硬度的增大而降低;磨痕处粗糙度随磨粒和反应物浓度的增加先降低后上升,随基体硬度的增大先上升后降低;摩擦系数受磨粒和反应物浓度影响不明显,随基体硬度的增大而降低。选择KHCO₃作为反应物,Ⅰ基体,磨粒浓度为基体质量的100%,反应物浓度为15%制备固结磨料球与KDP晶体对磨后的磨痕轮廓对称度好且磨痕处粗糙度值低,以该组分制备固结磨料垫干式抛光KDP晶体,可实现晶体表面粗糙度Sa值为18.50 nm,材料去除率为130 nm/min的高效精密加工。     

INFLUENCE OF FRICTION ON THE MOTION OF BASE WITH AN ECCENTRIC ROTOR

偏心转子惯性力引起的底座运动受到地面摩擦的影响，与光滑情形的理论结果存在定性差异。转子逆时针匀速旋转的惯性力若小于构件总重，则底座随摩擦因子增加而出现连续、一次停顿和两次停顿的振动及完全静止的4种状态。因惯性力对正压力及摩擦力的影响，底座在连续及一次停顿的振动时右向位移较大；而底座跳起时如``蛤蟆夯'则整体向左移动。     

Polymer chain diffusion in polymer blends: A theoretical interpretation based on a memory function formalism

The diffusion of polymer chains in miscible polymer blends with large dynamic asymmetry—those where the two blend components display very different segmental mobility—is not well understood yet. In the extreme case of the blend system of poly(ethylene oxide) (PEO) and poly(methyl methacrylate)(PMMA), the diffusion coefficient of PEO chains in the blend can change by more than five orders of magnitude while the segmental time scale hardly changes with respect to that of pure PEO. This behavior is not observed in blend systems with small or moderate dynamic asymmetry as, for instance, polyisoprene/poly(vinyl ethylene) blends. These two very different behaviors can be understood and quantitatively explained in a unified way in the framework of a memory function formalism, which takes into account the effect of the collective dynamics on the chain dynamics of a tagged chain. © 2019 Wiley Periodicals, Inc. J. Polym. Sci., Part B: Polym. Phys. 2019 , 57, 1239–1245     

Hitherto-Unexplored Photodynamic Therapy of Ag2S and Enhanced Regulation Based on Polydopamine In Vitro and Vivo

Given their superior penetration depths, photosensitizers with longer absorption wavelengths present broader application prospects in photodynamic therapy (PDT). Herein, Ag₂S quantum dots were discovered, for the first time, to be capable of killing tumor cells through the photodynamic route by near-infrared light irradiation, which means relatively less excitation of the probe compared with traditional photosensitizers absorbing short wavelengths. On modification with polydopamine (PDA), PDA-Ag₂S was obtained, which showed outstanding capacity for inducing reactive oxygen species (increased by 1.69 times). With the addition of PDA, Ag₂S had more opportunities to react with surrounding O₂, which was demonstrated by typical triplet electron spin resonance (ESR) analysis. Furthermore, the PDT effects of Ag₂S and PDA-Ag₂S achieved at longer wavelengths were almost identical to the effects produced at 660 nm, which was proved by studies in vitro. PDA-Ag₂S showed distinctly better therapeutic effects than Ag₂S in experiments in vivo, which further validated the enhanced regulatory effect of PDA. Altogether, a new photosensitizer with longer absorption wavelength was developed by using the hitherto-unexplored photodynamic function of Ag₂S quantum dots, which extended and enhanced the regulatory effect originating from PDA.     

Entropic effect implication for change in polymer coils swelling state in the demixing enthalpy recovery of aqueous poly(vinyl methyl ether) solutions

Time‐dependent demixing enthalpy recovery behavior of aqueous poly(vinyl methyl ether) (PVME) solutions exhibits distinct recovery characteristics in three concentration regions. The absence of recovery behavior below a water concentration of 38.3 wt % indicates that the PVME coil is in a globular state. The typically sigmoidal recovery behavior of demixing enthalpy above 38.3 wt % is ascribed to the reswelling of the collapsed polymer coils induced by the entropic effect. The increase in difference between the upper and lower limits indicates the continued swelling of the PVME coils. Above 65 wt %, a dominant diluting effect can be observed, and a much longer phase separation time is needed to reach the expected lower limit. In contrast, the recovery of demixing enthalpy in a wide range of water concentration (from 38.3 to 90 wt %) exhibits the same feature. The infrared spectroscopy results are in agreement with the above macroscopic differential scanning calorimetry results. © 2018 Wiley Periodicals, Inc. J. Polym. Sci., Part B: Polym. Phys. 2019 , 57, 142–151     

Convergence of solutions for the fractional Cahn–Hilliard system

This paper deals with the Cauchy–Dirichlet problem for the fractional Cahn–Hilliard equation. The main results consist of global (in time) existence of weak solutions, characterization of parabolic smoothing effects (implying under proper condition eventual boundedness of trajectories), and convergence of each solution to a (single) equilibrium. In particular, to prove the convergence result, a variant of the so-called ?ojasiewicz–Simon inequality is provided for the fractional Dirichlet Laplacian and (possibly) non-analytic (but $C^1$) nonlinearities.     

Structure and Mechanical Stability of Epoxy Modified Polyurethane Foam Under Heat and Stress

A series of phenolic epoxy resin (PEP) modified polyurethane foams (PUF) were prepared via an in-situ polymerization, one step process. It was found that the epoxy modified PUF foam exhibited a perforated network structure with larger cell size, higher open cell porosity and enhanced ovality compared with pure PUF. With increasing content of PEP, the tensile strength, elongation at break and low temperature modulus of PUF decreased. A single T_g was observed for PEP modified PUF, indicating that the two component phases of the polyurethane-epoxy were miscible. With increasing PEP content, the T_g of PUF shifted slightly to higher temperature, tan δ_max dropped to lower values, and the retention value of the storage modulus at ?20 and ?10?°C increased. For pure PUF, the cell walls degraded and the structure became disordered after aging under heat and stress, while for PUF/20wt%PEP, the degradation degree was obviously reduced, and an orientation of the cells along the stress direction and a density increase was observed. During aging at 200?°C, the retention of the mechanical properties of PUF/20wt% PEP was much higher than that of pure PUF, and it showed superior stability under heat and stress, attributed to incorporation of the thermally resistant oxazolidone rings and benzene rings in the PU backbones, the highly cross-linked networks of the polyurethane-epoxy systems and the obvious orientation of the cells under stress.