Expected reliability of communication protocols

We consider the problem of sending a message from a sender $s$ to a receiver $r$ through an unreliable network by specifying in a protocol what each vertex is supposed to do if it receives the message from one of its neighbors. A protocol for routing a message in such a graph is finite if it never floods $r$ with an infinite number of copies of the message. The expected reliability of a given protocol is the probability that a message sent from $s$ reaches $r$ when the edges of the network fail independently with probability $1?p$.We discuss, for given networks, the properties of finite protocols with maximum expected reliability in the case when $p$ is close to 0 or 1, and we describe networks for which no one protocol is optimal for all values of $p$. In general, finding an optimal protocol for a given network and fixed probability is challenging and many open problems remain.     

航空导管弯曲试验的疲劳裂纹萌生寿命

飞行器液压导管受接头和卡箍等约束，在使用的振动环境中，会因弯曲应力而导致破裂，影响到飞行安全．本文对飞行器液压系统通用的不锈钢导管的裂纹萌生寿命进行了试验研究．首先在对8 mm、12 mm 无缺陷导管和含U 型缺口8 mm 导管的疲劳试验和有限元分析的基础上，得到了导管的最大拉应变-裂纹萌生寿命数据．然后采用基于强度极限和弹性模量估算法的Manson-Coffin 公式来预测导管裂纹萌生寿命．最后引入加载类型修正系数、表面质量修正系数、试样尺寸修正系数、应力集中敏感系数和有效应力集中系数，使修正后的公式对三种类型的导管均有较好的裂纹萌生寿命预测精度．     

基于SWT方法的钢绞线索微动疲劳特性分析

为得到钢绞线索丝间接触区的应力场分布并预测微动疲劳裂纹萌生位置和微动疲劳寿命，本文利用参数化方法建立了精细化的钢绞线拉索有限元模型，包括整索模型和不同层丝间接触区域的局部精细化子模型．分析了钢绞线索在两种交变荷载工况下的应力场变化情况，并基于多轴疲劳SWT(Smith-Watson-Topper)临界平面法进行了疲劳特性分析和疲劳寿命预测．主要结论如下：钢绞线索内接触区边缘处的微动幅值较大，中心处几乎没有相对滑动，微动疲劳的初始裂纹萌生点位于接触区域边缘；经不同区域子模型分析比较，在轴向循环荷载作用下，外层钢丝的接触区域比内层钢丝更易发生微动疲劳损伤；在横向位移循环荷载作用下，同层钢丝因位置角度不同而产生了较大的疲劳特性差异，且相比轴向循环拉伸，该工况下最不利单丝的微动疲劳寿命更低；与非接触区域相比，接触区的疲劳寿命大幅降低，微动现象对钢绞线索的抗疲劳性能有明显降低作用．     

一种轿车车轮应力状态测量与分析方法

基于台架应变测试试验方法,研究轿车车轮在疲劳试验中的应力状态。结果表明:车轮的径向疲劳试验时,轮胎会对车轮的载荷产生较大的影响,轮胎与转鼓的挤压变形以及正反转动都会对车轮的应力状态产生影响;车轮径向疲劳试验时,最大应变出现在轮辋与轮胎接触位置沿车轮圆周方向,而在靠近轮心位置的应变较小;车轮弯曲疲劳试验时,最大应变出现在轮辐靠近轮心的位置,最大应变出现在轮辐的长度方向;不同的载荷对车轮应变的变化规律并没有影响,但是会对最大和最小峰值产生影响。     

Fatigue damage behavior of a surface-mount electronic package under different cyclic applied loads

This paper studies and compares the effects of pull-pull and 3-point bending cyclic loadings on the mechanical fa- tigue damage behaviors of a solder joint in a surface-mount electronic package. The comparisons are based on experimental investigations using scanning electron microscopy （SEM） in-situ technology and nonlinear finite element modeling, respec- tively. The compared results indicate that there are different threshold levels of plastic strain for the initial damage of solder joints under two cyclic applied loads; meanwhile, fatigue crack initiation occurs at different locations, and the accumulation of equivalent plastic strain determines the trend and direction of fatigue crack propagation. In addition, simulation results of the fatigue damage process of solder joints considering a constitutive model of damage initiation criteria for ductile materials and damage evolution based on accumulating inelastic hysteresis energy are identical to the experimental results. The actual fatigue life of the solder joint is almost the same and demonstrates that the FE modeling used in this study can provide an accurate prediction of solder joint fatigue failure.     

应力为SGBVE分布强度为指数分布下结构可靠度的估计

考虑了应力服从SGBVE分布,强度服从指数分布的应力—强度模型,分别在应力参数未知和部分强度参数未知的情形下给出了该模型可靠度的估计,并讨论了其性质.     

High throughput N-modular redundancy for error correction design of memristive stateful logic

Memristive stateful logic is one of the most promising candidates to implement an in-memory computing system that computes within the storage unit. It can eliminate the costs for the data movement in the traditional von Neumann system. However, the instability in the memristors is inevitable due to the limitation of the current fabrication technology, which incurs a great challenge for the reliability of the memristive stateful logic. In this paper, the implication of device instability on the reliability of the logic event is simulated. The mathematical relationship between logic reliability and redundancy has been deduced. By combining the mathematical relationship with the vector-matrix multiplication in a memristive crossbar array, the logic error correction scheme with high throughput has been proposed. Moreover, a universal design paradigm has been put forward for complex logic. And the circuit schematic and the flow of the scheme have been raised. Finally, a 1-bit full adder (FA) based on the NOR logic and NOT logic is simulated and the mathematical evaluation is performed. It demonstrates the scheme can improve the reliability of the logic significantly. And compared with other four error corrections, the scheme which can be suitable for all kinds of R-R logics and V-R logics has the best universality and throughput. Compared with the other two approaches which also need additional complementary metal-oxide semiconductor (CMOS) circuits, it needs fewer transistors and cycles for the error correction.     

数学模型在高校领军人才评审中的应用

教育评估的可靠性决定了评估结果的可信性,影响着教育评估的声誉和发展.结合高校领军人才评审探讨了数学可靠性模型在教育评估中的应用,通过建立数学可靠性模型,计算评审系统的可靠性,并结合可靠性计算结果分析了影响评审系统可靠性的因素.     

Computational analysis for the determination of deleterious nsSNPs in human MTHFD1 gene

Single nucleotide polymorphisms (SNPs) are the most common genetic polymorphisms and play a major role in many inherited diseases. Methylenetetrahydrofolate dehydrogenase 1 (MTHFD1) is one of the enzymes involved in folate metabolism. In the present study, the functional and structural consequences of nsSNPs of human MTHFD1 gene was analyzed using various computational tools like SIFT, PolyPhen2, PANTHER, PROVEAN, SNAP2, nsSNPAnalyzer, PhD-SNP, SNPs&GO, I-Mutant, MuPro, ConSurf, InterPro, NCBI Conserved Domain Search tool, ModPred, SPARKS-X, RAMPAGE, FT Site and PyMol. Out of 327 nsSNPs form human MTHFD1 gene, total 45 SNPs were predicted as functionally most significant SNPs, among which 17 were highly conserved and functional, 17 were highly conserved and structural residues. Among 45 most significant SNPs, 15 were predicted to be involved in post translational modifications. The p.Gly165Arg may interfere in homodimer interface formation. The p.Asn439Lys and p.Asp445Asn may interfere in binding interactions of MTHFD1 protein with cesium cation and potassium. The two SNPs (p.Asp562Gly and p.Gly637Cys) might interfere in interactions of MTHFD1 with ligand.