Controlling thermomechanical behavior of semicrystalline hydrogenated polynorbornene through the cis- to trans-cyclopentylene ratio

Though polynorbornene synthesized by ring-opening metathesis polymerization has an intrinsically all-cis configuration of the cyclopentylene backbone rings, a fraction of these rings can be epimerized to the trans configuration during hydrogenation over suitable catalysts. By varying the method of hydrogenation, semicrystalline hydrogenated polynorbornenes (hPNs) with trans levels between 0 and 36% were obtained. With increasing trans content, the glass transition temperature, melting point, and enthalpy of melting decrease modestly. By contrast, the temperature at which the hPN crystal transitions into a rotationally disordered polymorph varies strongly with trans content, ranging from 126 °C (all-cis) to 71 °C at 27% trans; at trans contents of 34% and above, no rotationally-ordered phase is observed at any temperature. The room-temperature Young's modulus shows no dependence on trans content, while the yield stress drops by 20% at 1% trans content and slowly decreases further with additional epimerization. The temperature dependence of the Young's modulus differs for trans-containing versus all-cis polymers, while the temperature dependence of the yield stress is set by the polymorph type (rotationally ordered vs. disordered).     

基于应变梯度理论的微尺度蜂窝等效模量计算方法

本文提出了一种新的能够计及尺度效应的微纳米蜂窝等效模量的计算方法。将一种单参数应变梯度理论引入到本构方程当中,并基于能量等效原理推导了蜂窝面内等效模量地计算公式。算例分析表明,本文方法能够有效地计及尺度效应对蜂窝等效模量的影响。尺度效应与胞壁厚度和长度的值都有关,当胞壁厚度较小时,尺度效应显著,本文方法预测的模量会明显高于传统方法;而当胞壁厚度较大时,尺度效应变得微弱乃至可以忽略不计。但如果胞壁的长度/厚度比很大,则面内等效模量会趋近于0,此时是否考虑尺度效应意义不大。     

超声共振法测定圆柱体材料弹性常数的影响因素分析

为明确超声共振频谱分析法(RUS)测定圆柱体试样弹性常数的影响因素, 由此针对各向同性圆柱体开展实验, 观察圆柱体试样测量结果的分散性和稳定性, 且主要研究横纵比和有效模态数量对测量结果的影响, 并与拉伸试验的结果进行比较. 以测量结果标准差、变异系数和95%置信度下均值的区间估计3个指标来衡量结果的稳定性和分散性, 且从模态简并角度对实验结果进行分析. 最终结果表明, 当超声共振频谱分析法的有效模态数量在17左右、试样横纵比接近1时, 测量结果的稳定性和分散性较小.     

New measurements and reanalysis of 14N elastic scattering on 10B target

The angular distributions of elastic scattering of ¹⁴N ions on ¹⁰B targets have been measured at incident beam energies of 21.0 and 24.5 MeV. Angular distributions at higher energies 38–94.0 MeV (previously measured) were also included in the analysis. All data were analyzed within the framework of the optical model and the distorted waves Born approximation method. The observed rise in cross sections at large angles was interpreted as a possible contribution of the α-cluster exchange mechanism. Spectroscopic amplitudes SA₂ and SA₄ for the configuration ¹⁴N→ ¹⁰B +α were extracted. Their average values are 0.58±0.10 and 0.81±0.12 for SA₂ and SA₄, respectively, suggesting that the exchange mechanism is a major component of the elastic scattering for this system. The energy dependence of the depths for the real and imaginary potentials was found.     

Applicability of ~9Be global optical potential to reactions of ~(7,10,11,12)Be

Elastic scattering angular distributions and total reaction cross-sections of ~(7,10,11,12)Be projectiles are predicted by the systematic ~9 Be global phenomenological optical model potential for target mass numbers ranging from24 to 209. These predictions provide a detailed analysis by their comparison with the available experimental data.Furthermore, these elastic scattering observables are also predicted for some targets out of the mass number range.The results are in reasonable agreement with the existing experimental data, and they are presented in this study.     

Fluid‐structure coupling of linear elastic model with compressible flow models

Cavitation erosion is caused in solids exposed to strong pressure waves developing in an adjacent fluid field. The knowledge of the transient distribution of stresses in the solid is important to understand the cause of damaging by comparisons with breaking points of the material. The modeling of this problem requires the coupling of the models for the fluid and the solid. For this purpose, we use a strategy based on the solution of coupled Riemann problems that has been originally developed for the coupling of 2 fluids. This concept is exemplified for the coupling of a linear elastic structure with an ideal gas. The coupling procedure relies on the solution of a nonlinear equation. Existence and uniqueness of the solution is proven. The coupling conditions are validated by means of quasi‐1D problems for which an explicit solution can be determined. For a more realistic scenario, a 2D application is considered where in a compressible single fluid, a hot gas bubble at low pressure collapses in a cold gas at high pressure near an adjacent structure.     

闪长岩单轴加载过程中声发射和弹性波速度变化规律的研究

为研究闪长岩在单轴加载过程中的声发射和各向波速变化规律,在单轴阶段加载和循环阶段加载条件下,对闪长岩岩样破裂过程中的声发射累计数、不同应力水平不同方向的波速、切线模量、轴向应变速率进行了研究。实验结果表明:(1)随着应力水平的增高,声发射事件数不断增加,在高应力水平(约80%峰值强度)时,声发射累计数急剧增多,随后切线模量出现震荡变化。(2)在加载过程中,压密程度及裂纹扩展方向对波速产生了巨大的影响,导致不同方向波速在不同的应力水平呈现出不同的变化规律,由此可以推测破裂面位置和破裂模式。在较高应力水平下(约60%峰值强度),平行于加载方向的波速趋于稳定,而垂直于加载方向的波速则持续下降,故用垂直于加载方向传播的波速预测岩石的破坏更具可靠性。(3)随着应力的增加,应变速率有逐渐减小的趋势,但临近岩石破裂时无异常变化出现,说明利用变形观测难以预测此类岩石的破坏。以上研究表明,根据纵波波速、声发射累计数和切线模量的变化可以有效预测岩石的破坏。     

Strain induced strengthening of soft thermoplastic polyurethanes under cyclic deformation

We investigate the cyclic mechanical behavior in uniaxial tension of three different commercial thermoplastic polyurethane elastomers (TPU) often considered as a sustainable replacement for common filled elastomers. All TPU have similar hard segment contents and linear moduli but sensibly different large strain properties as shown by X-ray analysis. Despite these differences, we found a stiffening effect after conditioning in step cyclic loading which greatly differs from the common softening (also referred as Mullins effect) observed in chemically crosslinked filled rubbers. We propose that this self-reinforcement is related to the fragmentation of hard domains, naturally present in TPU, in smaller but more numerous sub-units that may act as new physical crosslinking points. The proposed stiffening mechanism is not dissimilar to the strain-induced crystallization observed in stretched natural rubber, but it presents a persistent nature. In particular, it may cause a local reinforcement where an inhomogeneous strain field is present, as is the case of a crack propagating in cyclic fatigue, providing a potential explanation for the well-known toughness and wear resistance of TPU.