Coupling characteristics of laterally coupled gratings with slots

Laterally-coupled ridge-waveguide distributed feedback lasers fabricated without epitaxial regrowth steps have the advantages of process simplification and low cost. We present a laterally coupled grating with slots. The slots etched between the ridge and grating area are designed to suppress the lateral diffusion of carriers and to reduce the influence of the aspect-ratio-dependent-etching effect on the grating morphology in the etching process. Moreover, the grating height in this structure can be decreased to lower the aspect ratio significantly, which is advantageous over the conventional laterally coupled ridge waveguide gratings. The effects of five main structural parameters on the coupling characteristics of gratings are studied by MODE Solutions. It is found that varying the lateral width of the grating can be used as an effective way to tune the coupling strength; narrow slots (100 nm and 300 nm) and wide ridge (2 μm-4 μm) promote the stability of grating coupling coefficient and device performance. It is important to note that the grating bottom should be fabricated precisely. The comparative study of carrier distribution and mode field distribution shows that the introduction of narrow slots can strengthen the competitive advantage and stability of the fundamental mode.     

Periodic solutions of a periodic stochastic human immunodeficiency virus model with distributed delay and cytotoxic T lymphocytes immune response

In this paper, a periodic stochastic human immunodeficiency virus (HIV) model with distributed delay and cytotoxic T lymphocytes (CTL) immune response is investigated. First, by It $ô$'s formula, we show that the solution with any positive initial value is global and positive. Then, by the stochastic comparison theorem, we obtain the sufficient conditions guaranteeing the existence and global attractivity of infection-free periodic solution. Furthermore, we discuss the existence of the infective periodic solution by Has'minskii theory. Finally, numerical examples are given to illustrate the results.     

A unified theory for brittle and ductile shear mode fracture

A unified theory captures both brittle and ductile fracture. The fracture toughness is proportional to the applied stress squared and the length of the crack. For purely brittle solids, this criterion is equivalent to Griffith's theory. In other cases, it provides a theoretical basis for the Irwin-Orowan formula. For purely ductile solids, the theory makes direct contact with the Bilby-Cottrell-Swinden model. The toughness is highest in ductile materials because the shielding dislocations in the plastic zone provide additional resistance to crack growth. This resistance is the force opposing dislocation motion, and the Peach-Koehler force overcomes it. A dislocation-free zone separates the plastic zone from and the tip of the crack. The dislocation-free zone is finite because molecular forces responsible for the cohesion of the surfaces near the crack tip are not negligible. At the point of crack growth, the length of the dislocation-free zone is constant and the shielding dislocations advance in concert. As in Griffith's theory, the crack is in unstable equilibrium. The theory shows that a dimensionless variable controls the elastoplastic behaviour. A relationship for the size of the dislocation-free zone is derived in terms of the macroscopic and microscopic parameters that govern the fracture.     

The deformation and fracture of balloons

Inflation of balloons provides a straightforward way of achieving large biaxial deformations. Previous studies have shown that when a balloon bursts, crack propagation occurs at very high speed – much higher than would be expected from the low strain modulus and elastic wave velocity of the rubber. The present paper is concerned with studies of the deformation and fracture of cylindrical balloons. On inflation, the deformations of such a balloon pass through an unstable region but subsequently increase monotonically with pressure. In this relatively high pressure region, the ratio of the longitudinal and circumferential extension ratios is broadly in accord with expectations from high-strain elasticity theory when the ratio of the corresponding stresses is taken into account. On bursting, crack speeds up to around 300 m/s in this region. It is shown that these speeds are in accord with large increase in incremental moduli for the highly-strained rubber. Marked changes in crack tip profile observed at very high crack speeds are consistent with control of the rate of growth by inertia rather than by the viscoelastic properties of the rubber (as is believed to be the case at lower speeds). Consistent with this, various elastomers having different glass transition temperatures show similar crack growth behaviour in the very high speed region.     

Fatigue Behavior of Composite Sandwich Panels Under Three Point Bending Load

In this paper, the bending fatigue tests of honeycomb sandwich panels are carried out by using an improved three-point bending test fixture, and the S-N curves at different stress ratios are obtained. Through the records of fatigue damage in the experiment, the failure mode of the honeycomb sandwich panels and the source of fatigue damage are determined. At the same time, through the calculation of the shear stress distribution on the honeycomb wall, the reasons for the difference in the failure morphology of the L-direction and W-direction sandwich panels are clarified. Besides, a life prediction method is proposed and its effectiveness in predicting the fatigue life of sandwich panels has been verified.     

含分布时滞的时滞微分系统多步龙格-库塔方法的时滞相关稳定性

本文研究了一类含分布时滞的时滞微分系统的多步龙格-库塔方法的稳定性.基于辐角原理，本文给出了多步龙格-库塔方法弱时滞相关稳定性的充分条件，并通过数值算例验证了理论结果的有效性.     

High refractive index hyperbranched polyvinylsulfides for planar one‐dimensional all‐polymer photonic crystals

We report on the growth and characterization of one‐dimensional (1D) planar all‐polymer photonic crystals (PhC) with high dielectric contrast (Δn = 0.3) prepared by spin coating using hyperbranched polyvinylsulfide polymers (HB‐PVS) as high refractive index material and cellulose acetate as low refractive index material. Solution processable HB‐PVS show a near ultraviolet absorption inducing an increased refractive index in the visible‐near infrared (n = 1.68, λ = 1000 nm). HBPVS:Cellulose Acetate Distributed Bragg Reflectors show a very clear fingerprint of the photonic band gap possessing the expected polarized dispersion properties as a function of the incidence angle. Moreover, engineered microcavities tuned on the weak fluorescence spectrum of the HB‐PVS show directional fluorescence enhancement effects due to spectral redistribution of the emission oscillator strength. The combination of all these properties testifies the high optical quality of the obtained photonic structures thus indicating HB‐PVS as an interesting material for the preparation of such PhC. © 2015 Wiley Periodicals, Inc. J. Polym. Sci., Part B: Polym. Phys. 2016 , 54, 73–80     

Distributed subgradient method for multi‐agent optimization with quantized communication

This paper focuses on a distributed optimization problem associated with a time‐varying multi‐agent network with quantized communication, where each agent has local access to its convex objective function, and cooperatively minimizes a sum of convex objective functions of the agents over the network. Based on subgradient methods, we propose a distributed algorithm to solve this problem under the additional constraint that agents can only communicate quantized information through the network. We consider two kinds of quantizers and analyze the quantization effects on the convergence of the algorithm. Furthermore, we provide explicit error bounds on the convergence rates that highlight the dependence on the quantization levels. Finally, some simulation results on a l₁‐regression problem are presented to demonstrate the performance of the algorithm. Copyright © 2016 John Wiley & Sons, Ltd.     

Threshold dynamics of a nonlinear multi‐group epidemic model with two infinite distributed delays

The global stability of equilibria is investigated for a nonlinear multi‐group epidemic model with latency and relapses described by two distributed delays. The results show that the global dynamics are completely determined by the basic reproduction number under certain reasonable conditions on the nonlinear incidence rate. Moreover, compared with the results in Michael Y. Li and Zhisheng Shuai, Journal Differential Equations 248 (2010) 1–20, it is found that the two distributed delays have no impact on the global behaviour of the model. Our study improves and extends some known results in recent literature. Copyright © 2016 John Wiley & Sons, Ltd.