一种通过梯形PPMgLN波导倍频实现带宽可调谐光源的理论研究

本文设计了一种梯形的周期极化掺镁铌酸锂(PPMgLN)波导,并通过在传播方向上引入温度梯度来拓宽其倍频(SHG)过程的泵浦光源可接收带宽。通过有限差分的光束传输法,计算波导的有效折射率,并进行波导尺寸的设计。结果表明,通过改变梯形波导不同位置的温度,使其形成一个温度梯度,可拓宽泵浦光源的波长可接收带宽。本文所设计的PPMgLN波导最大泵浦光源可接收带宽为C波段,即1 530~1 565 nm,该波导可倍频C波段,得到输出波段带宽为765~782.5 nm,温度调谐范围为30~150 ℃。     

Effect of thickness variations of lithium niobate on insulator waveguide on the frequency spectrum of spontaneous parametric down-conversion

We study the effect of waveguide thickness variations on the frequency spectrum of spontaneous parametric down-conversion in the periodically-poled lithium niobate on insulator (LNOI) waveguide. We analyze several variation models and our simulation results show that thickness variations in several nanometers can induce distinct effects on the central peak of the spectrum, such as narrowing, broadening, and splitting. We also prove that the effects of positive and negative variations can be canceled and thus lead to a variation-robust feature and an ultra-broad bandwidth. Our study may promote the development of on-chip photon sources in the LNOI platform, as well as opens up a way to engineer photon frequency state.     

Highly stable dielectric frequency response of chemically synthesized Mn-substituted ZnFe2O4

The tenacity of the present study was to develop a material using an economical chemical route, having balance between magnetic and dielectric order parameters for maximum transmittance of electromagnetic waves in order to use them in shielding materials. In this context, Mn-Zn ferrites were prepared using a wet chemical based sol-gel auto-combustion technique. X-ray diffraction confirmed the pure phase formation of samples, while some impurity peaks were also present for the higher value of Mn substitution. Field emission scanning electron microscopy revealed a decrease in grain size with increasing Mn substitution. While energy dispersive X-ray spectroscopy confirmed the elemental composition of pure and Mn substituted samples, the dielectric constant, dielectric loss and tangent loss were decreased with increasing frequency and increasing Mn substitution. The complex electric modulus was found to be a function of frequency and values of complex electric modulus were increased with increasing frequency and Mn substitution. The complex impedance of RC series circuit and RC parallel circuit was also decreased with increasing both the parameters while AC conductivity was increased in the series. Dielectric frequency response was also studied for the prepared samples and the best match was found with expected results. The Nyquist and Cole-Cole plots revealed the semi-conductive behavior at higher frequency and Mn substitution also yielded the same results. The relative stability of the samples to be used as dielectric materials was also studied using Bode and Nichols plots, and a comparatively high gain margin was observed, well suitable for potential applications in electromagnetic shielding.     

Parameter settings in a compact laser-nitriding system for titanium composed of a focused pulsed Nd:YAG laser and nitrogen gas blow

The aim of the present study was to form a nitride layer on a titanium (Ti) substrate through a compact laser-nitriding system comprising a focused pulsed Nd:YAG laser and nitrogen gas blow. To obtain a high-quality layer, the effects of pulse frequency and gas flow rate on the surface characteristics were investigated by using plasma emission analysis as well as X-ray analyses. Optical emission spectra from the laser-induced plasma mainly consisted of ionic Ti lines, and their intensities when the pulse frequency was 15 Hz were much higher than those for 8 Hz. Similarly, the reflections from the δ-TiN phase in the X-ray diffraction (XRD) pattern were enhanced when using 15 Hz. On the other hand, the flow rate of nitrogen gas blow had a significant effect on the thickness of the thin oxide layer that formed above the nitride layer. Using a lower flow rate resulted in the formation of a thicker oxide layer. The higher pulse frequency and the faster flow rate were beneficial for obtaining a higher-quality layer because of the enhancement of nitridation and the suppression of oxidation, respectively.     

不同浓度的尾砂胶结充填体破坏过程 声发射特性试验研究*

制备了3种不同质量浓度的充填体试件，进行了单轴压缩声发射试验，分析了不同浓度的充填体力学特性，重点研究了试件破坏过程中的声发射振铃计数、声发射累计撞击数与声发射累计能量的比值(r值)、主频及其相对高频信号激增响应系数特征。研究表明：随着浓度的增加，充填体的峰值强度与弹性模量呈增大趋势，充填体中出现的声发射累计振铃计数越多；r值先升高再持续减小到一个较低值，随着外载荷的增加，进入缓慢升高阶段，峰值前均保持在该阶段。充填体破裂前兆信息在声发射信号主频分布中呈现主频段增多现象，表现为由加载初期的1~2个主频段，在临界主破裂时增多到3~5个主频段；且随着浓度的增加，声发射信号主频频段分布越宽，声发射相对高频信号(160~180 kHz)的激增响应系数呈递减趋势。以上特征可为不同浓度的尾砂胶结充填体稳定性监测、预测提供依据。     

薄板结构加筋布局优化设计方法研究

提出一种两步优化策略，以加筋板结构的固有频率最大化为目标函数，以结构所受外载荷作用的最大静变形为约束条件，开展薄板结构加筋构件的布局优化设计研究。为了降低加筋布局优化的难度，提高优化设计的效率，将加筋等效为一系列弹性铰（点）支撑，以便快速获得加筋横向移动的灵敏度信息。在基本不改变结构重量的情形下，通过合理布局加筋位置，能显著改善结构的刚度分布，提高结构的整体承载能力。随后，小幅调整加筋的截面尺寸，以满足对结构最大变形的设计要求。最后，用两个算例验证了所提优化方法的可行性和有效性。     

Everything you wanted to know about phase and reference frequency in one- and two-dimensional NMR spectroscopy

The fundamental concept of phase discussed in this tutorial aimed at providing students with an explanation of the delays and processing parameters they may find in nuclear magnetic resonance (NMR) pulse programs. We consider the phase of radio-frequency pulses, receiver, and magnetization and how all these parameters are related to phases and offsets of signals in spectra. The impact of the off-resonance effect on the phase of the magnetization is discussed before presenting an overview of how adjustment of the time reference of the free induction decay avoids first-order correction of the phase of spectra. The main objective of this tutorial is to show how the relative phase of a pulse and the receiver can be used to change the reference frequency along direct and indirect dimensions of NMR experiments. Unusual of phase incrementation with non-90° angles will be illustrated on one- and two-dimensional NMR spectra.     

竖直恒温面自然对流边界层不稳定性研究

在无扰动、随机式扰动以及正弦式扰动下,通过对竖直恒温面处状态Ra为1.328×10^9、Pr为6.24的自然对流进行模拟,探索了热边界层的不稳定性和共振强化自然对流换热。结果表明:(1)竖直自然对流边界层上游位置的随机式扰动对热边界层的影响主要体现在稳定阶段;(2)该状态下的竖直自然对流边界层的特征频率为15 067,且相比于无扰动状态,频率为15 067的正弦式扰动能在竖直恒温面处提高5.15%的换热量;(3)在竖直自然对流边界层上游位置加入特征频率的正弦式扰动,竖直恒温面处的局部努塞尔数Nu均出现明显波动,且波动随着边界层高度的增加而增大。     

埋层界面和空气表面和频光谱信号贡献的调控

本文研究表明通过膜厚控制和表面等离激元增强方法可有效区分隐藏界面和空气表面的和频振动光谱信号. 以氟化钙基底支撑的PMMA薄膜为模型，观察到隐藏界面和空气表面对和频信号贡献的变化. 通过监控羰基和甲基伸缩振动基团，发现薄PMMA膜的和频信号来自PMMA/空气表面的化学基团-CH₂、-CH₃、-OCH₃和C=O，而厚PMMA膜的和频信号则来自基底/PMMA埋层界面的-OCH₃和C=O基团. 随制膜浓度增大，埋层界面C=O基团的取向角从65°下降到43°，且浓度大于或等于0.5 wt%时，取向角等于45°±2°. 相比之下，空气表面C=O的取向角落在21°∽38°之间. 在金纳米棒存在条件下，表面等离激元可以极大地增强和频信号，尤其是来自埋层界面信号.     

考虑制动力影响的大型客车舒适性分析

利用有限元法和动力平衡原理,建立了具有层间接触的沥青路面和13个自由度的大型客车人体三维模型。以不平顺作为激励,随机模拟车流分布,在不同制动情况下,从时域和频域两方面分析人-车-路耦合振动下车辆和人体的动力响应。时域分析采用客观评价标准和主观烦恼率相结合的方法,频域分析考虑人体共振、人的心理和生理因素。结果表明:随着制动力增大,人体的竖向加速度幅值不变,俯仰、侧倾加速度幅值都增大,但是俯仰加速度增幅远大于侧倾加速度的情况,人的舒适性变差,烦恼率增高;在紧急制动时,主频段对人体共振、心理和生理产生的影响很小,但是次主频段与人体某些器官固有频段重合,对人体共振、心理和生理产生的影响是不容忽视的。