不同浓度的尾砂胶结充填体破坏过程 声发射特性试验研究*

制备了3种不同质量浓度的充填体试件，进行了单轴压缩声发射试验，分析了不同浓度的充填体力学特性，重点研究了试件破坏过程中的声发射振铃计数、声发射累计撞击数与声发射累计能量的比值(r值)、主频及其相对高频信号激增响应系数特征。研究表明：随着浓度的增加，充填体的峰值强度与弹性模量呈增大趋势，充填体中出现的声发射累计振铃计数越多；r值先升高再持续减小到一个较低值，随着外载荷的增加，进入缓慢升高阶段，峰值前均保持在该阶段。充填体破裂前兆信息在声发射信号主频分布中呈现主频段增多现象，表现为由加载初期的1~2个主频段，在临界主破裂时增多到3~5个主频段；且随着浓度的增加，声发射信号主频频段分布越宽，声发射相对高频信号(160~180 kHz)的激增响应系数呈递减趋势。以上特征可为不同浓度的尾砂胶结充填体稳定性监测、预测提供依据。     

基于临界状态的砂土本构模型研究

砂土孔隙比及所受压力是其力学特性的重要影响因素. 本文基于砂土临界状态线特性分析,采用以e-(p/p_a)ξ平面内的线性关系描述其等向压缩线. 通过对比分析两种不同压缩线函数 与临界状态线函数之间的关系提出更适合描述砂土在等向压缩下的参考压缩线,并给出了基于参考压缩线的等向硬化规律. 建议了适用于 描述砂土剪切特性的屈服面函数,并给出利用等向压缩和等p路径确定屈服面形状参数μ的方法. 将不同应力比对应的压缩线作为砂土状态参量参考线,以获取潜在强度M_f与特征状态应力比M_c,进而描述砂土压缩与剪切特性;基于等向压缩与等p路径建立了当前应力比与状态参量参考线之间的相关关系,从而实现了砂土状 态参量参考线由参考压缩线向临界状态线平稳过渡. 建立的砂土本构模型共11个参数,均能够通过常规土工试验或经验获取. 基于模型预测与Toyoura砂的等向压缩、三轴不排水剪切试验及排水剪切试验的对比结果,本文建立的砂土本构模型很好地描述了Toyoura 砂在不同孔隙比和不同压力下的压缩与剪切特性.      

表面喷砂对有机玻璃沿面闪络性能影响

绝缘子表面粗糙处理是提升其沿面闪络性能的重要途径,表面粗糙化处理方式不当,极易带来表面结构不均匀,难以获得稳定耐压性能的绝缘材料。为提升绝缘子表面粗糙处理的均匀性,本文利用表面喷砂技术对圆柱形有机玻璃(PMMA)绝缘子进行了粗糙化处理研究,以球形二氧化硅(SiO2)颗粒为工作介质,研究了不同喷砂粒径、氢氟酸后处理等因素对绝缘材料表面形貌和组分的影响,并利用短脉冲高压测试平台对喷砂处理前后有机玻璃绝缘子样品进行了真空沿面闪络性能测试。研究结果表明,喷砂处理在有机玻璃表面形成了较为均匀的凹坑,HF酸能够有效去除表面残留的SiO2颗粒,具有表面喷砂粗糙结构的绝缘子沿面闪络电压得到了稳定提升,相较于未处理的绝缘子闪络电压提升了约80%。     

Investigating the kinetics of liquid-free,OSDA-free ZSM-5 zeolite synthesis from iron ore tailings

In this study, ZSM-5, which is a Mobil-type five-type zeolite with well-defined crystal morphology, is successfully synthesized via a seed-assisted, liquid-free method that uses iron ore tailings as a silica source. The ZSM-5 crystallization kinetics at 423, 433, and 443 K and different synthesis times are investigated to identify the nucleation and crystallization mechanisms of the synthesized ZSM-5 zeolites, and results suggest that the crystallization kinetics follow a Kolmogorov-Johnson-Mehl-Avrami-type behavior. The activation energies for the induction and transition periods are 112.38 and 58.35 kJ mol⁻¹, respectively. Furthermore, the Avrami exponent indicates three-dimensional crystal growth from both sporadic and instantaneous nucleation mechanisms. A comparison of our results with previous reports of the ZSM-5 crystallization mechanism demonstrates that the seed crystals play a significant role in nucleation and crystal growth. Finally, seed surface crystallization and new nuclei crystallization dual mechanism has been proposed to describe the crystallization process of ZSM-5.     

石英砂-聚乙烯二元混合体系的太赫兹光谱特性研究

太赫兹时域光谱技术目前逐渐应用于对岩石的研究中。在制备样品时通常需要将岩石磨碎后与粘合剂混合压片，岩石的含量、粒径等都会对测试结果造成影响。将自然界中常见的石英砂粉末（不同粒径）与聚乙烯（PE）微粒以不同的比例混合，通过压片的手段将其制成适用于太赫兹系统测试的样品，用以探究样品中石英砂的含量以及其粒径对实验结果的影响。首先研究石英砂含量对实验结果造成的影响。在保持样品中石英砂的粒径不变的情况下，发现不同石英砂含量样品的时域光谱图中，时间延迟以及峰值都呈现出非单调的变化趋势。为了探究出现这种现象的原因，对样品的折射率以及吸收系数做了进一步的分析。结果表明样品的折射率会随着样品中石英砂含量的增加而逐渐增大，通过适用于本实验的有效介质理论能够解释这一现象。样品对于太赫兹波段的吸收系数随着石英砂含量的增加呈现出先增大后减小的现象，并且在石英砂质量分数为60%时达到最大值。为了解释这一现象产生的原因，利用扫描电子显微镜对样品的微观形貌进行观察，发现随着石英砂含量的增加，在压制样品时PE颗粒破碎程度加剧，导致PE的粒径变小。根据米氏散射以及瑞利散射的原理，石英砂粒径不变而PE粒径减小，随之降低的散射强度与石英砂的吸收效应发生竞争，从而导致了吸收系数先增大后减小的现象。进一步研究了石英砂粒径对实验结果的影响，对不同粒径的石英砂样品进行测试，发现折射率不随石英砂粒径的变化而改变，但其吸收系数随着石英砂粒径的减小而逐渐减小。根据米氏散射，样品吸收系数的变化是由于散射强度随石英砂粒径的减小而逐渐减小。研究表明，样品中石英砂的含量和粒径都会对实验结果产生影响。石英砂粒径相同时，样品的吸收系数随石英砂含量的增加呈现先增大后减小的趋势，样品的折射率随石英砂含量的增加而逐渐增大；石英砂含量相同时，样品的吸收系数随石英砂粒径的减小而逐渐减小，而样品的折射率基本不变。这一结论对矿物样品的制备以及对混合物的实验结果分析有一定程度的指导意义。     

Physicochemical Interaction of ZnO Fine Particles with 5‐Mono‐(4‐carboxyphenyl)‐10,15,20‐Triphenylporphyrin

This study deals with an investigation on the preparation and physicochemical interactions of ZnO nanoparticles with acid functionalized porphyrin [5‐mono‐(4‐carboxyphenyl)‐10,15,20‐triphenylporphyrin (CPTPP)] for photovoltaic applications in a detailed manner. Zinc acetate and sodium hydroxide were used as the starting materials for the synthesis of ZnO nanoparticles at 60 °C in an alcoholic medium. The freshly prepared fine particles were then functionalized with CPTPP. Both the virgin and pregnant ZnO particles were characterized by using UV‐Visible spectrophotometry (UV), fluorescence emission (PL), Fourier transform infrared spectroscopy (FTIR), X‐ray diffraction (XRD) and scanning electron microscopy (SEM). The band gap energy obtained for ZnO particles, having a value of 3.47 eV, shows significant quantum confinement effect and enhanced photophysical activity. FTIR analysis of the doped ZnO nanostructures showed the presences of some chemical species. SEM analysis revealed a clear change in the surface morphologies of undoped ZnO. The average crystallite size of nanoparticles, calculated from XRD peaks, was found in the nano regime. The lattice parameters calculated for ZnO nanocrystals were also found in good agreement with those given in the literature. From the enhancement in the red shift of the UV‐Vis spectra, it is concluded that hybridization of acid functionalized porphyrin can cause a significant expansion in the total absorption region of ZnO semiconductor for photovoltaic applications.     

气基磁化焙烧回收包头稀土尾矿中铁的研究

试验采用磁化焙烧-磁选的方法来回收包头稀土尾矿中的Fe。考察了还原球团的粒径、焙烧温度、还原气体的成分、还原气气体流量、焙烧时间对于磁化焙烧回收Fe的影响。在焙烧温度为580℃,CO与CO2的浓度比为40∶60,还原气体气流量为1.2 L·min-1,焙烧时间为60 min的条件下对球团进行磁化焙烧,并将焙烧后的球团进行磨矿,使得-200目的物料占物料总重量的95%。将磨矿后的物料置于磁场强度为233 k A·m-1的磁选管中进行磁选,可以得到品位为60%左右的铁精矿,其铁回收率达到70%左右。     

Experimental analysis of sand particles'' lift-off and incident velocities in wind-blown sand flux

The probability distributions of sand particles' lift-off and incident velocities in a wind-blown sand flux play very important roles in the simulation of the wind-blown sand movement. In this paper, the vertical and the horizontal speeds of sand particles located at 1.0 mm above a sand-bed in a wind-blown sand flux are observed with the aid of Phase Doppler Anemometry (PDA) in a wind tunnel. Based on the experimental data, the probability distributions of not only the vertical lift-off speed but also the lift-off velocity as well as its horizontal component and the incident velocity as well as its vertical and horizontal components can be obtained by the equal distance histogram method. It is found, according to the results of the χ²-test for these probability distributions, that the probability density functions (pdf's) of the sand particles' lift-off and incident velocities as well as their vertical components are described by the Gamma density function with different peak values and shapes and the downwind incident and lift-off horizontal speeds, respectively, can be described by the lognormal and the Gamma density functions. These pdf's depend on not only the sand particle diameter but also the wind speed. The project supported by the National Natural Science Foundation of China (10532040) and the Hundred Talents Project, the Knowledge Innovation Project of Chinese Academy of Sciences (KZCX2-304). The English text was polished by Keren Wang.     

Probing the nature of the contact between fine particles by using ultrasound propagation

The propagation velocity (vs) of an ultrasonic signal through a granular material depends on the type of interparticle contact. For noncohesive glass beads, a power law behavior for consolidation stresses applied (σc) above 1 MPa has been measured in previous work. This equation is compatible with Hertz's interaction law between elastic solids. In the present work, we have tested the propagation velocity of ultrasound signals through a sample of fine powder. The tensile strength and compactivity of the powder were previously measured by means of the Seville powder tester (SPT), indicating plastic deformation of the surface asperities in contact for small to moderate consolidation stresses. However, the measurements of ultrasound propagation at high consolidations presented here are compatible with Hertz's law. This finding suggests that for high consolidation stresses, surface asperities are flattened, and it is therefore the elastic deformation of the bulk of the particles that determines the transmission of ultrasonic pulses.