首页 | 本学科首页   官方微博 | 高级检索  
文章检索
  按 检索   检索词:      
出版年份:   被引次数:   他引次数: 提示:输入*表示无穷大
  收费全文   17篇
  免费   13篇
  国内免费   6篇
化学   5篇
力学   13篇
数学   1篇
物理学   17篇
  2022年   1篇
  2019年   2篇
  2018年   1篇
  2015年   1篇
  2014年   5篇
  2013年   3篇
  2006年   2篇
  2005年   1篇
  2003年   4篇
  2002年   4篇
  2001年   4篇
  2000年   2篇
  1999年   1篇
  1997年   1篇
  1991年   1篇
  1990年   1篇
  1988年   1篇
  1986年   1篇
排序方式: 共有36条查询结果,搜索用时 15 毫秒
1.
We investigate niobium thin film superconducting quantum interference devices (SQUIDs) with different Steward- McCumber parameters βc operated in both current- and voltage-bias modes. We experimentally prove that there is no difference between the two bias modes with respect to the SQUID intrinsic noise and the noise contribution from the preamplifier. Furthermore, the relationships of the SQUID dynamic parameters, (Rd)current bias ≈ (Rd)voltage bias and (σV/σФ)current bias ≈ [σi/σФ)Rd]voltage bias, are always satisfied. For a strongly damped SQUID withβc ≈ 0.25, addi- tional positive feedback (APF) and noise cancellation (NC) were employed to enhance σV/σФ, the former showing a degradation in the linear flux range but otherwise the same with NC. For a weakly damped SQUID with βc ≈ 3, it is di- rectly connected to the preamplifier without APF or NC, and a low SQUID system noise of about 4μФ0/x/Hz is measured, which is close to its intrinsic noise.  相似文献   
2.
在多通道超导量子干涉器件(SQUID)磁探测系统中,磁场电压转换系数(∂ B/∂ V)是系统的一个重要参数由于SQUID器件和读出电路之间不可避免地存在差异性因此对传感器系统进行系统标定(每个通道的单独标定)显得十分重要本文采用(PCB) 板印制圆形线圈对36通道心磁系统进行标定,并与传统的亥姆霍兹方形线圈产生均匀场的标定方法进行比较结果显示PCB圆形线圈的标定结果 在1.46–1.73 pT·mV-1 之间,亥姆霍兹方形线圈标定的结果大都在1.56–1.64 pT·mV-1之间,结果基本一致. 关键词: 超导量子干涉器件 磁探测 磁场-电压转换系数 系统标定  相似文献   
3.
A dual-washer superconducting quantum interference device(SQUID) with a loop inductance of 350 pH and two onwasher integrated input coils is designed according to conventional niobium technology. In order to obtain a large SQUID flux-to-voltage transfer coefficient, the junction shunt resistance is selected to be 33 ?. A vertical SQUID gradiometer module with a baseline of 100 mm is constructed by utilizing such a SQUID and a first-order niobium wire-wound antenna.The sensitivity of this module reaches about 0.2 fT/(cm·Hz1/2) in the white noise range using a direct readout scheme, i.e.,the SQUID is directly connected to an operational amplifier, in a magnetically shielded room. Some magnetocardiography(MCG) measurements with a sufficiently high signal-to-noise ratio(SNR) are demonstrated.  相似文献   
4.
非线性振动一种稳定的模糊控制方法研究   总被引:2,自引:0,他引:2  
由于非线性振动系统的非线性本质,在于传统控制理论的线性控制器用于非线性振动控制效果不佳。本文针对非线性振动系统提出了一种模糊自适应滑模控制方案。  相似文献   
5.
The dependence of emission direction of fast electrons on the laser intensity has been investigated. The experimental results show that, at nonrelativistic laser intensities, the emission of fast electrons is mainly in the polarization plane. With the increase of the laser intensity, fast electrons emit towards the laser propagation direction from laser polarization direction. At relativistic laser intensities, fast electrons move away from the laser polarization plane, closely to the reflection direction of the incident laser beam.  相似文献   
6.
SQUID gradiometer techniques are widely used in noise cancellation for biomagnetic measurements.An appropriate gradiometer baseline is very important for the biomagnetic detection with high performance.By placing several magnetometers at different heights along the vertical direction,we could simultaneously obtain the synthetic gradiometers with different baselines.By using the traditional signal-to-noise ratio(SNR) as a performance index,we successfully obtain an optimal baseline for the magnetocardiography(MCG) measurement in a magnetically shielded room(MSR).Finally,we obtain an optimal baseline of 7 cm and use it for the practical MCG measurement in our MSR.The SNR about 38 dB is obtained in the recorded MCG signal.  相似文献   
7.
利用光子晶体光纤产生超连续飞秒激光光谱   总被引:8,自引:3,他引:5  
将单脉冲能量约为2.5nJ、脉宽为25fs、对应峰值功率为0.1MW的的800nm钛宝石激光耦合到长为10mm,芯径为1.8μm的光子晶体光纤中,产生了耦合效率约为17%、谱宽覆盖可见光及近红外波段的超连续光谱。  相似文献   
8.
目的:本研究建立股骨端髋关节置换有限元模型,并进行了静力学模拟计算,为寻求假体的个体化和假体加长、加粗等设计起到指导作用。方法:运用逆向工程与有限元的基本概念和理论,采用ANSYS V6.1对股骨进行静应力的计算。结果:通过完全适应髓腔假体和股骨的共同受力分析,发现股骨受力的主要部位在股骨距。结论:该模型符合国人的股骨上端生物力学特性,是一个较好的髋关节置换有限元模型,为进一步模拟翻修关节的临床实际奠定基础。  相似文献   
9.
粘弹复合结构特征问题的迭代算法   总被引:13,自引:1,他引:12  
本文研究由弹性材料和粘弹性材料构成复合结构的动力学问题。引入耗散位移概述,将复合材料的动力学方程变换为状态方程,进一步研究了状态方程特征解的性质。为了求复合结构的模态参数,定义了复合结构的保守粘性结构的概念,提出了计算复合结构特值问题的一个实用算法。最后讨论了复合结构的动力响应。  相似文献   
10.
邱阳  张景绘 《实验力学》1991,6(2):156-163
本文首先讨论工程振动信号频谱再分析技术,针对所存在问题,提出模糊式识别再分析方法,以滚动轴承振动成因研究中的谱分析为例,具体介绍了频谱的峰值频率分布模式,模糊子集及隶属函数的确定,以及综合评判的识别过程,最后给出一具体计算结果。  相似文献   
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号