阳离子交换皂石黏土在基质辅助激光解吸电离飞行时间质谱分析中的应用

将一种人工合成的无机聚合物——蒙脱石皂石黏土（smectite，Sm）应用于基质辅助激光解吸电离飞行时间质谱分析（matrix-assisted laser desorption/ionization time of flight mass spectrometry, MALDI-TOF-MS），以检测糖类化合物。 将传统的有机基质2，4，6-三羟基苯乙酮（trihydroxyacetophenone, THAP）与阳离子交换后的皂石黏土混合制备成新型复合基质，应用于糖类化合物的检测。通过比较不同的制样方法，测定不同分子直径的糖类化合物，发现由于受复合基质晶面间距的限制，只有小分子糖类化合物能进入晶面间隙充分接触有机基质并被离子化，从而实现对小分子糖类化合物的选择性检测。     

热解吸反压低温等离子体电离源质谱检测食品中的邻苯二甲酸酯EI北大核心CSCD

基于低温等离子体设计并实现了一套热解吸反压低温等离子体电离(TD-iLTPI)装置。TD-iLTPI装置由热解吸模块和电离源模块集成在一个π型四通管上组成,进样探针取得样品后插入热解吸模块使其气化,之后随载气进入电离区域被电离。iLTPI内部的针电极接交流电,外部的环形电极接地,电极连接方式与LTP相反。该文对热解吸反压低温等离子体电离源进行了参数的优化,并与三重四极杆质谱联用检测了12种代表性的邻苯二甲酸酯,同时考察了TD-iLTPI-MS的分析性能,并对含有邻苯二甲酸酯的实际样品进行了检测。结果表明,邻苯二甲酸丁苄酯(BBP)的标准曲线具有良好的线性相关系数(R;=0.9958),加标回收率为89.7%~116.8%,相对标准偏差为4.5%~8.2%,对邻苯二甲酸酯的检出限也远低于其他敞开式离子源。对白酒、果汁、面包、奶酪和黄油中的邻苯二甲酸酯进行了快速筛查,并定量检测了果汁中的邻苯二甲酸丁苄酯。     

Mass spectrometry imaging of latent fingerprints using titanium oxide development powder as an existing matrix

Recent research has focused on increasing the evidentiary value of latent fingerprints through chemical analysis. Although researchers have optimized the use of organic and metal matrices for matrix‐assisted laser desorption/ionization‐mass spectrometry imaging (MALDI‐MSI) of latent fingerprints, the use of development powders as matrices has not been fully investigated. Carbon forensic powder (CFP), a common nonporous development technique, was shown to be an efficient one‐step matrix; however, a high‐resolution mass spectrometer was required in the low mass range due to carbon clusters. Titanium oxide (TiO₂) is another commonly used development powder, especially for dark nonporous surfaces. Here, forensic TiO₂ powder is utilized as a single‐step development and matrix technique for chemical imaging of latent fingerprints without the requirement of a high‐resolution mass spectrometer. All studied compounds were successfully detected when TiO₂ was used as the matrix in positive mode, although, generally, the overall ion signals were lower than the previously studied CFP. TiO₂ provided quality mass spectrometry (MS) images of endogenous and exogenous latent fingerprint compounds. The subsequent addition of traditional matrices on top of the TiO₂ powder was ineffective for universal detection of latent fingerprint compounds. Forensic TiO₂ development powder works as an efficient single‐step development and matrix technique for MALDI‐MSI analysis of latent fingerprints in positive mode and does not require a high‐resolution mass spectrometer for analysis.     

High Valent Mercury Fluoride Ions

Mercury fluoride ions formed during the laser ablation of HgF_{2( s )} show the formation of six different cluster ion series viz., HgF_n^±, Hg_nF_n–2^±, Hg_nF_n–1^±, (HgF)_n^±, Hg_nF_n+1^±, and Hg_nF_n+2^±. Among the different ion series, the observation of high valent HgF_n^±_(n^±_{=3,4; n}⁻_=6–8) indicates the existence of corresponding molecules which signify the remarkable participation of 5d Hg electrons in the chemical bonding with F atoms and thus make Hg a truly transition metal. Further, molecular orbital calculations show a large HOMO-LUMO energy gap (≥3 eV) and high electron affinity (≥5 eV) that indicates highly stable HgF_n=3,4,6,8 with super halogen properties.     

几种常用激光解吸电离/质谱基质的基质簇峰行为研究

以常用于DNA分析的基质3-羟基吡啶甲酸(3-HPA),以及常用于高分子聚合物分析的基质2-(4-羟基苯基偶氮)苯甲酸(HABA)、反式-3-吲哚基丙烯酸(IAA)和1,8,9-三羟基蒽(Dithranol)为研究对象,考察了基质溶剂、浓度及激光强度对基质本身在激光解吸电离/质谱(LDI/MS)过程中产生基质簇峰的影响,对基质簇峰可能形成的过程进行了推测,并对各基质簇峰进行了归属,提出了基质簇离子峰m/z值遵循的计算公式。     

顶空气相色谱法测定工作场所空气中的乙酸乙酯

采用顶空气相色谱法测定工作场所空气中的乙酸乙酯。气态乙酸乙酯用活性炭管吸附,二氯甲烷解吸,顶空进样,HP–FFAP毛细管柱分离,FID检测器测定,峰面积定量。乙酸乙酯的质量浓度在1.76~880.0μg/m L范围内与色谱峰面积呈良好的线性,相关系数r=0.999 4。不同浓度样品批内测定结果的相对标准偏差为1.34%~3.61%(n=7),批间测定结果的相对标准偏差为1.04%~4.78%(n=7),加标回收率为91.02%~100.29%,方法检出限为0.32μg/m L,解吸效率为91.28%~95.19%。对于100 mg活性炭,乙酸乙酯的穿透容大于2.2 mg,当其浓度在17.6~17 600 mg/m3时,采样效率为91.23%~97.40%,常温下可以保存10 d。该方法各项指标均达到《工作场所空气中有毒物质检测方法研制规范》的要求,适用于工作场所空气中乙酸乙酯的现场监测。     

Square‐Wave Voltammetry of Electroinactive Surfactants

Under the influence of previously published and some new theoretical results, potential‐ dependent adsorption and desorption of model electroinactive surfactants Triton X‐100 (T‐X‐100 or polyethylene glycol p‐(1,1,3,3‐tetramethylbutyl)‐phenyl ether) and sodium dodecyl sulfate (SDS) on the static mercury drop electrode (SMDE) were studied by square‐wave voltammetry (SWV). Although (according to the theory) the resulting current – potential curve should consist of two highly separated peaks, only desorption signal could be seen on each experimentally obtained voltammogram, most probably because of the limitations concerning the available potential range. Different properties of the recorded peak are in good agreement with the theory indicating that square‐wave voltammetry could be treated as a potential tool for tensammetric studies of electroinactive surface active substances.     

Adsorption on Mesoporous Metal–Organic Frameworks in Solution: Aromatic and Heterocyclic Compounds

Adsorption and desorption play major roles in separations, purification of water, waste streams, liquid fuels, catalysis, biomedicine and chromatography. Mesoporous metal–organic frameworks (MOFs) with pore sizes 2–50 nm are particularly suitable for adsorption of organic compounds in solution. Tens of thousands of aromatic and heterocyclic compounds are major components of liquid fuels, feedstock for industrial synthesis, solvents, dyestuffs, agricultural chemicals, medicinal drugs, food additives, and so forth. This Review provides a systematization and analysis of studies on adsorption/desorption on mesoporous MOFs in solution and their underlying chemical mechanisms. The (in)stability of mesoporous MOFs in water is critically discussed. Adsorption capacity and selectivity are covered for organic dyes, medicinal drugs, major components of liquid fuels, and miscellaneous industrial chemicals. Ionic interactions, Brønsted acid–base interactions, hydrogen bonding, coordination bonding, π–π interactions, and non‐specific interactions are covered amongst adsorption mechanisms. The effects of post‐synthetic modifications of mesoporous MOFs on their stability, adsorption capacity, selectivity, and mechanisms of adsorption and desorption are analyzed. To encourage research in this quickly growing field, we identify “niches” for which no application‐oriented and/or mechanistic studies were reported. Perspectives and limitations of a wide use of mesoporous MOFs as industrial sorbents are discussed.