X射线荧光光谱法测定地质样品中的硫和氟

采用粉末压片制样-X射线荧光光谱法研究地质样品中硫(S)和氟(F)元素的快速测定方法。通过分级过筛实验优化确定样品粒度,探讨样品粒度对测定结果的影响,并进行实际样品和标准物质验证。结果显示,样品粒度为85μm时,经实际样品和标准物质验证,测定结果与化学值和标准认定值相符,且相对标准偏差(RSD)均小于2%。方法具有准确度高、检出限好、测试范围宽、简便快速等优点,能确保样品分析结果的准确性,实现了地质样品中S和F的快速测定。     

三价铁离子与硫离子反应的实验探究

探究了水溶液中Fe3+与S2-的反应，得出几点结论：生成Fe2S3的沉淀反应是动力学优势反应，生成Fe2+和S的氧化还原反应是热力学优势反应；发现Fe2S3可以与Fe3+反应生成S和Fe2+，Fe2S3在酸性条件下不稳定；在弱碱性条件下，Fe3+也有与HS-发生氧化还原反应的倾向；Fe3+在水溶液中主要以水解产物[Fe（H2O）6-n（OH）n]（3-n）+（n=1，2）存在，[Fe（H2O）6-n（OH）n]（3-n）+的氧化性很弱，难以将H2S或HS-氧化，却易与S2-结合生成Ksp极小的Fe2S3沉淀。     

Rapid and easy quantification of elemental sulphur in aqueous samples from biological reactors: the turbidimetric method revisited

Recent developments in wastewater treatment have led to a renewed interest to obtain elemental sulphur (S°) as a by-product from bioreactors. However, practical studies are limited by the gap of adequate analytical techniques for its determination. This paper provides a statistical study and matrix effect evaluation of an adapted spectrophotometric method for routine S° analyses in aqueous samples, based on a methodology previously described by Hart (1961). Four complex matrices were tested: domestic sewage and effluent samples from three different bioreactors. Tested performance criteria included linearity, matrix effect, limit of detection and quantification and S° recovery. Results were linear (R² = 0.99994) in the studied range (5 to 100 mg S° L^?1) and no matrix effect was observed. The accuracy was based on recovery values that varied from 100% to 106%. The colloidal S° separation and extraction protocol was also considered suitable for aqueous samples, reaching more than 99.0% of S° recovery.     

Nuklearpharmaka — Ihre Entwicklung,Präparation und Anwendungsmöglichkeiten

Radioaktiv markierte Präparate haben in denletzten Jahren in schnell zunehmendem Maße Eingang in die klinische Medizin gefunden. Sie sind beieiner Reihe von Indikationen schon jetzt außerordentlich wertvolle Hilfsmittel bei der Diagnose, besonders bei der Prüfung von Organfunktionen.     

Sulphur electric properties at superhigh pressure around the polymerization temperatures

Abstract

The electrical resistivity temperature dependence of S has been studied in the diamond anvil cell (DAC) of the “rounded cone-plane” type. The pressure is about 50 GPa. The experimental data analysis shows the polymerization between 380–410 K. The electrical resistivity temperature dependence is distorted by a number of maxima, some of them being shifted along the temperature axis towards the lower temperature and disappear with increasing transport current.     

Präparation polykristalliner LiF-Speicherphosphore für die Thermolumineszenzdosimetrie

Zur Ausbildung eines intensiven Glowmaximums der Thermolumineszenz bei 200°C wurden eine Vielzahl von Kationen auf ihre Aktivatorwirkung gegenüber LiF untersucht. Als günstige Aktivatoren erwiesen sich bei der Herstellung des LiF mitgefällte Mg-, Ca- und Ti-Spuren. Die Eigenscaften der präparierten Phosphore werden mit den Analysenergebnissen verglichen und diskutiert.     

Beobachtung des Stickstoffstoffwechsels bei Leguminosen mittels 15N

Es war Ziel dieser Arbeit, zu ermitteln, welchen Einfluß höhere Dosen von Stickstoffdüngemitteln in Form von KNO₃ auf die Menge des in der Pflanze fixierten Luftstickstoffs haben. Als Versuchspflanze wählten wir Pferdebohnen (Vicia faba, Chlumetzer Abart) wegen ihrer vielseitigen Verwendung in der Landwirtschaft und ihrer besonderen experimentellen Eignung.     

Zur Anreicherung der stabilen Isotope des Schwefels durch Fest-Flüissig-Austausch unter Verwendung von Ionenaustauschern

An verschiedenen Systemen chemischer Verbindungen wurden Versuche zur Anreicherung des stabilen Isotopes ³⁴S unter Verwendung der Ionenaustauscher Wofatit L 150, SBW und SBK nach den Methoden der Frontalchromatographie und der Bandenverdrāngungschromatographie ausgeführt. Beim Isotopenaustauschsystem Hydrogensulfit (am Ionenaustauscher)/Schwefeldioxid (in wäβriger Lösung) wurden Verfahrensweise und Betriebsparameter hinsichtlich des Anreicherungsgrades optimiert. Mit Hilfe einer einfachen Methode gelang es, aus den Versuchsergebnissen Werle für den elementaren Trennfaktor und die Trennstufenhöhe zu berechnen.     

Calibration transfer between electronic nose systems for rapid In situ measurement of pulp and paper industry emissions

Electronic nose systems when deployed in network mesh can effectively provide a low budget and onsite solution for the industrial obnoxious gaseous measurement. For accurate and identical prediction capability by all the electronic nose systems, a reliable calibration transfer model needs to be implemented in order to overcome the inherent sensor array variability. In this work, robust regression (RR) is used for calibration transfer between two electronic nose systems using a Box–Behnken (BB) design. Out of the two electronic nose systems, one was trained using industrial gas samples by four artificial neural network models, for the measurement of obnoxious odours emitted from pulp and paper industries. The emissions constitute mainly of hydrogen sulphide (H₂S), methyl mercaptan (MM), dimethyl sulphide (DMS) and dimethyl disulphide (DMDS) in different proportions. A Box–Behnken design consisting of 27 experiment sets based on synthetic gas combinations of H₂S, MM, DMS and DMDS, were conducted for calibration transfer between two identical electronic nose systems. Identical sensors on both the systems were mapped and the prediction models developed using ANN were then transferred to the second system using BB–RR methodology. The results showed successful transmission of prediction models developed for one system to other system, with the mean absolute error between the actual and predicted concentration of analytes in mg L⁻¹ after calibration transfer (on second system) being 0.076, 0.1801, 0.0329, 0.427 for DMS, DMDS, MM, H₂S respectively.     

Investigation of the Oxidation of Serum Albumin by Iodine

In studies of metabolism using serum albumin labelled with iodine (I¹³¹ and I¹²⁵) the question of the biological equivalence of the labelled material is of decisive importance. Changes of the chemical and biological characteristic of various proteins after iodination have been found by a number of workers [1–4], especially with reference to chromatographic behaviour, rate of metabolism in the organism and content of thiol. Oxidation of sulphhydryl groups can lead to interchain disulphide bridge-linkage and the formation of molecule aggregates.