Nonlinear elastic constitutive relations of residually stressed composites with stiff curved fibres

Applied Mathematics and Mechanics - Mechanical models of residually stressed fibre-reinforced solids, which do not resist bending, have been developed in the literature. However, in some residually...     

室温铁磁性Sr3YCo4O10.5+δ多晶有序化的烧结工艺及电磁性能

采用固相反应法制备了不同烧结温度(950~1 180 ℃)、烧结时间、烧结次数共7种工艺的Sr₃YCo₄O_10.5+δ多晶块材,通过热分析、XRD、SEM确定了有序化相变和最佳烧结工艺(1 180 ℃/24 h+1 180 ℃/24 h),并研究了多晶的电磁性能。结果表明,964 ℃完全晶化的四方相Sr₃YCo₄O_10.5在1 042 ℃吸氧(δ)完成有序化,生成Sr₃YCo₄O_10.5+δ,而1 100 ℃和1 180 ℃烧结的样品均出现(103)、(215)超结构峰,验证了其结构的有序性。块材均呈半导体电输运行为,二次烧结晶格完整性提高,晶粒长大,300 K时电阻率仅为0.06 Ω·cm,居里温度(T_c)~335 K,零场冷曲线(ZFC)上的Hopkinson峰源于低温时被冻结的磁矩随温度升高转向磁场方向,磁化强度在298 K达到最大,随后受热扰动的影响减小。室温铁磁性源于有序结构导致的中自旋或高自旋态Co³⁺的e_g轨道有序。     

Preparation,Characterization and ex vivo Intestinal Permeability Studies of Ibuprofen Solid Dispersion

The aim of the present study was to improve the solubility and dissolution rate of ibuprofen and to evaluate, ex vivo, the intestinal permeation. Solid dispersions (SD) were prepared with Kollicoat IR^® by solvent evaporation technique in different drug:carrier ratios. The permeation intestinal of ibuprofen was evaluated by inverted intestinal sac method. The SD was characterized by solubility equilibrium, FT-IR, DSC, PXRD, SEM, and dissolution rate. The solubility, dissolution rate, and permeability were significantly greater for SD 1:2. The PXRD, SEM and DSC indicated a partial change in the crystalline state of ibuprofen. The solubility equilibrium of SD (1:2) was approximately 15 times greater than the solubility of ibuprofen. Dissolution rate enhancement was attributed to the decreased crystallinity of the ibuprofen, and increase of wettability and decrease of particle size. In conclusion, dissolution rate and intestinal permeability of ibuprofen were enhanced by the use of Kollicoat IR^® carrier in the SD formulation.     

Use of a recently developed thermal modulator within the context of comprehensive two‐dimensional gas chromatography combined with time‐of‐flight mass spectrometry: Gas flow optimization aspects

The present research is based on the use of a recently developed comprehensive two‐dimensional gas chromatography thermal modulator, which is defined as solid‐state modulator. The transfer device was installed on top of a single gas chromatography oven, while benchtop low‐resolution time‐of‐flight mass spectrometry was used to monitor the compounds exiting the second analytical column. The solid‐state modulator was first described by Luong et al. in 2016, and it is a moving modulator that does not require heating and cooling gases to generate comprehensive two‐dimensional gas chromatography data. The accumulation and remobilization steps occur on a trapping capillary, this being subjected to thermoelectric cooling and micathermic heating. In this study, the effects of the gas linear velocity on the modulation performance were evaluated by using two different uncoated trapping capillaries, viz., 0.8 m × 0.25 mm id and 0.8 m × 0.20 mm id. Solid‐state modulator applications were carried out on a standard solution containing n‐alkanes (C_9, C_10, C₁₂), and on a sample of diesel fuel. The results indicated that the type of trapping capillary and gas velocity have a profound effect on modulation efficiency.     

Preparation and application of molecularly imprinted polymer solid‐phase microextraction fiber for the selective analysis of auxins in tobacco

As signal molecules, auxins play an important role in mediating plant growth. Due to serious interfering substances in plants, it is difficult to accurately detect auxins with traditional solid‐phase extraction methods. To improve the selectivity of sample pretreatment, a novel molecularly imprinted polymer ‐coated solid‐phase microextraction fiber, which could be coupled directly to high‐performance liquid chromatography, was prepared with indole acetic acid as template molecule for the selective extraction of auxins. The factors influencing the polymer formation, such as polymerization solvent, cross‐linker, and polymerization time, were investigated in detail to enhance the performance of indole acetic acid‐molecularly imprinted polymer coating. The morphological and chemical stability of this molecularly imprinted polymer‐coated fiber was characterized by scanning electron microscopy, infrared spectrometry, and thermal analysis. The extraction capacity of the molecularly imprinted polymer‐coated solid‐phase microextraction fiber was evaluated for the selective extraction of indole acetic acid and indole‐3‐pyruvic acid followed by high‐performance liquid chromatography analysis. The linear range for indole acetic acid and indole‐3‐pyruvic acid was 1–100 µg/L and their detection limit was 0.5 µg/L. The method was applied to the simultaneous determination of two auxins in two kinds of tobacco (Nicotiana tabacum L and Nicotiana rustica L) samples, with recoveries range from 82.1 to 120.6%.     

Determination of trace amounts of aromatic amines after magnetic solid‐phase extraction using silver‐modified Fe3O4/graphene nanocomposite

In this work, a fast and simple magnetic dispersive solid phase extraction methodology was developed utilizing Ag@magnetite nanoparticles@graphene nanocomposite as an efficient magnetic nanosorbent for preconcentration and determine of five aromatic amines in water samples. The sorbent was characterized by diverse characterization techniques. After the extraction, high‐performance liquid chromatography with UV detection was utilized to analysis the aromatic amines. The effects of different factors on the extraction process were studied thoroughly via design of experiment and desirability function. Detection limits and linear dynamic ranges were obtained in the range of 0.10–0.20 and 0.3–300 μg/L, respectively. The relative standard deviations (n = 5) were in the range of 4.3–6.5%. Eventually, the method was employed for determination of target aromatic amines in various water samples.     

QuEChERS/超高效液相色谱-串联质谱法快速测定土壤中19种氟喹诺酮类抗生素残留

建立了一种基于QuEChERS前处理技术,结合超高效液相色谱-串联质谱(UPLC-MS/MS)和内标法,快速测定土壤中19种氟喹诺酮类抗生素(FQs)残留的分析方法。5. 0 g土壤样品添加200μg/kg基质匹配同位素内标后,经20 m L 0. 1 mol/L EDTA-McIlvaine缓冲液和乙腈混合溶剂(体积比1∶1)提取,基质分散固相萃取(150 mg无水MgSO4、15 mg PSA、15 mg C18)净化后,采用UPLC-MS/MS进行测定。质谱分析采用电喷雾电离,正离子扫描,多反应监测模式。在优化条件下,19种抗生素的相关系数(r~2)为0. 992～0. 998,检出限为0. 2～1. 0μg/kg,定量下限为1. 0～5. 0μg/kg;在10、50、200μg/kg加标水平下的回收率为65. 2%～104%,相对标准偏差(n=5)不大于14%。该方法操作简单快速、准确度高,适用于土壤中氟喹诺酮类抗生素残留的检测。     

Magnetic solid‐phase extraction based on carbon nanosphere@Fe3O4 for enantioselective determination of eight triazole fungicides in water samples

In this work, a carbon nanosphere decorated by Fe₃O₄ nanoparticles was prepared, characterized and used as the magnetic adsorbent. Eight commonly used chiral triazole fungicides, including penconazole, uniconazole, paclobutrazol, triazolone, tebuconazole, hexaconazole, triticonazole and epoxiconazole were extracted from two environmental water samples (river water and lake water) by magnetic solid‐phase extraction, followed by the enantiomeric analysis on a Chiralpark IC column coupled with a triple quadrupole mass spectrometry to evaluate their possible stereoselective degradation occurring in the water samples. The possible factors affecting the extraction performance, such as amount of used adsorbents, pH and ionic strength of water solution, types and volumes of desorption solvents were systematically investigated. Under the optimum conditions, extraction yields of eight triazole fungicides were above 80% and the concentration factors were as high as 1000. Method detection and quantification limits for the enantiomers of eight triazole fungicides were in the range of 0.56–6.95 ng/L. Satisfactory accuracy (relative recovery 77.8–93.5%), good intraday precision (RSD 4.3–9.8%) and interday precision (RSD 3.1–7.9%) were also obtained. The developed method provided the simplicity of operation, rapidity and high enrichment factor, which can be used to monitor and evaluate the behavior of the individual enantiomer of chiral triazole fungicides.     

Dissolvable layered double hydroxide as a sorbent in dispersive micro‐solid phase extraction for the determination of acidic quinolones in honey by HPLC

This study presents a simple and green dispersive micro‐solid phase extraction method for preconcentration of acidic quinolones from honey prior to high performance liquid chromatography determination. A two‐dimensional nanostructured zinc‐aluminum layered double hydroxide was synthesized and used as the sorbent for dispersive micro‐solid phase extraction. Its different characteristics from conventional sorbents is that it is dissolvable in acidic solution (pH < 4). After the extraction, the analyte elution step was omitted and thus the use of organic solvents was avoided. The key parameters influencing the extraction efficiency such as the amount of sorbent, pH of sample solution, vortex time, type and volume of acidic solution were investigated and optimized. The method exhibited low limits of detection (3.0?5.0 ng/g), good linearity (10?2000 ng/g) with coefficients of determinations higher than 0.9991, acceptable precision (RSD<9.1%) and accuracy (RE<5.8%). The proposed method is fast, efficient, eco‐friendly, and suitable for the determination of acidic quinolones in honey samples.     

In Situ Generated Gold Nanoparticles on Active Carbon as Reusable Highly Efficient Catalysts for a C −C Stille Coupling

Gold nanoparticle catalysts are important in many industrial production processes. Nevertheless, for traditional C ?C cross‐coupling reactions they have been rarely used and Pd catalysts usually give a superior performance. Herein we report that in situ formed gold metal nanoparticles are highly active catalysts for the cross coupling of allylstannanes and activated alkylbromides to form C ?C bonds. Turnover numbers up to 29 000 could be achieved in the presence of active carbon as solid support, which allowed for convenient catalyst recovery and reuse. The present study is a rare case where a gold metal catalyst is superior to Pd catalysts in a cross‐coupling reaction of an organic halide and an organometallic reagent.