光寻址电位传感器的正交相位检波检测方法

光寻址电位传感器的幅度检测方法易受噪声干扰,灵敏度差,信噪比和精度低,且受调制光源的影响较大,影响检测结果的准确性.为此提出了一种基于正交相位检波的光寻址电位传感器检测方法.该方法是将光寻址电位传感器的输出光电流信号分别与两路正交信号相乘,通过低通滤波提取直流分量并相除,即可得到光寻址电位传感器的输出信号相位信息.与已有的光寻址电位传感器相位检测方法相比,该方法具有算法复杂度低、实时性高的优点.实验研究了调制光源光强对光寻址电位传感器幅度检测和相位检测的影响,对比分析了光寻址电位传感器的传统幅度检测方法与正交相位检波检测方法对pH检测的灵敏度、线性度及信噪比.结果表明,相比于幅度检测方法,调制光源光强对光寻址电位传感器的相位检测影响更小,在频率为10 kHz,pH的范围为1.68~10.01的情况下,相位检测方法比幅度检测方法测得的灵敏度增加了7 mV/pH,精度提高了14.9 mpH,非线性误差减小了0.003%,均方差减少了0.1051×10^-5,信噪比增加了8.2827 dB.该方法特别适用于弱光下的光寻址电位传感器检测.     

三元素氢氧化物中镍钴锰含量的测定

采用仪器分析方法和化学分析方法相结合测定三元前驱体Ni0.33Co0.33Mn0.33(OH)2中镍、钴、锰主含量,分别采用电感耦合等离子体原子发射光谱(ICP-AES)内标法测定镍、钴、锰的摩尔比例,EDTA滴定法测定镍、钴、锰的摩尔总量,计算得到各元素的含量。通过优化实验条件,进行了准确度和精密度实验,加标回收率为99.2%~101%,相对标准偏差小于0.65%。方法准确、快速,已用于实际的检测工作中。     

锌粉-硼砂-硼酸熔融-碘酸钾滴定法测定高硅锡精矿中的锡

针对高硅锡精矿中锡的测定时通常用锌粉-氢氧化钠熔融,精密度差,不能满足分析要求的问题,建立了锌粉-硼砂-硼酸熔融,盐酸浸取,铝粒将锡还原,碘酸钾滴定法测定高硅锡精矿中锡的分析方法。方法结果稳定,精密度好,相对标准偏差在0.19%~0.55%,加标回收率在96.9%~105%。分析结果能够满足高硅锡精矿中锡的测定要求。     

Comparison of a single-use pH test strip and a glass electrode for potentiometric titration

The potentiometric titration of a carbonate mixture or an acetate solution is a common experiment in analytical laboratories. Typically, a glass electrode combined with a calomel or Ag/AgCl reference electrode is used to locate the equivalence points in neutralization titrations. The dissociation constants of weak acids and bases can be calculated from the pH at the half-neutralization point. Recently, a new commercial product for measuring pH has been developed. This novel acid–base detection strip is a single-use sensor that requires neither storage in a preservation liquid nor calibration prior to use. This study examined its suitability for the continuous monitoring of pH changes in potentiometric titrations of carbonate mixtures, acetate solutions, or ammonia solutions. There were no significant differences in the concentrations of solutions tested using a glass electrode and a pH test strip. The pK_a, pK_b, and pH values determined using the two systems differed by less than 5%. The results confirmed that the pH strips are suitable for continuously monitoring pH changes during neutralization titrations. However, the strips can only be used once.     

Analytical Methods for Determination of Phytic Acid and Other Inositol Phosphates: A Review

From the early precipitation-based techniques, introduced more than a century ago, to the latest development of enzymatic bio- and nano-sensor applications, the analysis of phytic acid and/or other inositol phosphates has never been a straightforward analytical task. Due to the biomedical importance, such as antinutritional, antioxidant and anticancer effects, several types of methodologies were investigated over the years to develop a reliable determination of these intriguing analytes in many types of biological samples; from various foodstuffs to living cell organisms. The main aim of the present work was to critically overview the development of the most relevant analytical principles, separation and detection methods that have been applied in order to overcome the difficulties with specific chemical properties of inositol phosphates, their interferences, absence of characteristic signal (e.g., absorbance), and strong binding interactions with (multivalent) metals and other biological molecules present in the sample matrix. A systematical and chronological review of the applied methodology and the detection system is given, ranging from the very beginnings of the classical gravimetric and titrimetric analysis, through the potentiometric titrations, chromatographic and electrophoretic separation techniques, to the use of spectroscopic methods and of the recently reported fluorescence and voltammetric bio- and nano-sensors.     

全自动电位滴定法测定锂电池原料碳酸锂中主成分的含量

采用全自动电位滴定法测定锂电池原料碳酸锂中主成分的含量,用盐酸标准溶液进行滴定,考虑自动电位滴定仪的灵敏性和准确度,通过多次对比实验,确定了仪器的最佳工作参数、滴定剂浓度和样品称样量等滴定条件;对两个不同品位试样分别进行了11次平行测定,相对标准偏差(RSD)均小于1%。在碳酸锂试样中加入基准物质无水碳酸钠进行碳酸根的加标回收实验,碳酸根的加标回收率在99.4%~100%。与传统的酸碱滴定法相比,全自动电位滴定法方便、快捷,同时方法测定结果准确、可靠、精密度高,适合大批量样品快速分析。     

Na2EDTA返滴定法测定铜镍合金中的镍含量

采用Na₂EDTA返滴定法测定铜镍合金中的镍含量,用柠檬酸钠、硫代硫酸钠和酒石酸作掩蔽剂,丁二酮肟沉淀分离,以二甲酚橙为指示剂,加入过量的Na2EDTA,用氯化锌标准溶液返滴定,能很好地分离铜及其他杂质的干扰。方法用于测定铜镍合金中的镍含量,测定结果的相对标准偏差(RSD,n=9)为0.046%~0.24%,加标回收率为99.3%~101%。能够满足日常样品的检测要求。     

Quantitative determination of fucoidan using polyion-sensitive membrane electrodes

The use of polyanion and polycation-sensitive membrane electrodes to detect five different preparations of fucoidan is described. Unlike linear polyanionic molecules previously measured with polymer membrane-based electrochemical sensors, fucoidans from marine brown algae are all highly branched, sulfated polysaccharides with varying charge densities and structures, depending on the species of seaweed, method of extraction used and extent of purification. When tridodecylmethylammonium (TDMA) was used as the ion-exchanger, a large, non-equilibrium EMF response was observed over a concentration range of 0.5–50 μg mL⁻¹ fucoidan. Fucoidan was also measured by titration with polycationic protamine, using a dinonylnaphthalene sulfonate (DNNS)-doped membrane electrode as the potentiometric endpoint detector. Potentiometric titration was used to determine the binding ratio between protamine and fucoidan at the neutralization endpoint for each fucoidan preparation. This binding ratio was then used to successfully determine the fucoidan content of commercially available nutritional supplements. Fucoidan was also measured in undiluted blood serum, demonstrating that this method may be applicable for measuring fucoidan for clinical applications.     

Thermodynamic characterization of proflavine–DNA binding through microcalorimetric studies

The interaction of an important acridine dye, proflavine hydrochloride, with double stranded DNA was investigated using isothermal titration calorimetry and differential scanning calorimetry. The equilibrium constant for the binding reaction was calculated to be (1.60 ± 0.04) · 10⁵ · M⁻¹ at T = 298.15 K. The binding of proflavine hydrochloride to DNA was favored by both negative enthalpy and positive entropy contributions to the Gibbs energy. The equilibrium constant for the binding reaction decreased with increasing temperature. The standard molar enthalpy change became increasingly negative while the standard molar entropy change became less positive with rise in temperature. However, the standard molar Gibbs free energy change varied marginally suggesting the occurrence of enthalpy–entropy compensation phenomenon. The binding reaction was dominated by non-polyelectrolytic forces which remained virtually unchanged at all the salt concentrations studied. The binding also significantly increased the thermal stability of DNA against thermal denaturation.     

基于制备接枝型分子印迹膜构建农药电位型电化学传感器及其检测性能研究

基于分子设计,以氯甲基化聚砜(CMPSF)为基膜,阴离子单体对苯乙烯磺酸钠(SSS)为功能单体,N,N'-亚甲基双丙烯酰胺(MBA)为交联剂,在表面引发体系-NH2/S2O2-8的作用下,采用"接枝聚合与分子印迹同步进行"的分子表面印迹新技术,制备了接枝型农药抗蚜威分子印迹膜(MIM)。采用红外光谱(FITR)和光学显微镜(OM)对该分子印迹膜进行表征,通过等温结合实验与竞争吸附实验,考察了抗蚜威分子印迹膜的分子识别性能与机理。以该印迹膜作为敏感膜,构建了抗蚜威电位型传感器,并对其检测性能进行了考察。结果表明,所制备的接枝型印迹膜对模板抗蚜威分子具有特异的识别选择性和优良的结合亲和性,结合容量高达92μg/cm2,相对于分子结构与抗蚜威相似的阿特拉津,印迹膜对抗蚜威的选择性系数为4.537。在p H 4.0的水介质中,传感器膜电极的电位响应与抗蚜威浓度对数在1.0×10-6~1.0×10-3mol/L范围内呈良好的线性关系(r=0.999 9),其检出限为2.5×10-8mol/L;以抗蚜威分子印迹膜为敏感膜所构建的电位型传感器,其构建过程简捷,检测灵敏准确,电位响应快速(t10 s)。