Investigating the kinetics of liquid-free,OSDA-free ZSM-5 zeolite synthesis from iron ore tailings

In this study, ZSM-5, which is a Mobil-type five-type zeolite with well-defined crystal morphology, is successfully synthesized via a seed-assisted, liquid-free method that uses iron ore tailings as a silica source. The ZSM-5 crystallization kinetics at 423, 433, and 443 K and different synthesis times are investigated to identify the nucleation and crystallization mechanisms of the synthesized ZSM-5 zeolites, and results suggest that the crystallization kinetics follow a Kolmogorov-Johnson-Mehl-Avrami-type behavior. The activation energies for the induction and transition periods are 112.38 and 58.35 kJ mol⁻¹, respectively. Furthermore, the Avrami exponent indicates three-dimensional crystal growth from both sporadic and instantaneous nucleation mechanisms. A comparison of our results with previous reports of the ZSM-5 crystallization mechanism demonstrates that the seed crystals play a significant role in nucleation and crystal growth. Finally, seed surface crystallization and new nuclei crystallization dual mechanism has been proposed to describe the crystallization process of ZSM-5.     

Determination of carbonate content in barite ore by headspace gas chromatography

This paper reports a method for determining the carbonate content in barite ore using headspace gas chromatography. Based on the acidification reaction, the carbonate in the barite ore was converted to CO₂ in a closed headspace vial. When the carbonate content was significant, the pressure caused changes in the CO₂ and O₂ signals and affected the measurement accuracy. It was found that carbonate content is proportional to the intensity ratio of the CO₂ to O₂ signals. Thus, the carbonate content in barite ore can be measured indirectly using a theoretical model. The results showed that the carbonate in 3 g of barite ore sample with a particle size of 74 μm could react completely with a hydrochloric acid solution (2 mol/L) at 65°C for 5 min. The method described herein had good precision (relative standard deviation < 4.14%) and accuracy (relative differences < 6.12%). Further, the limit of quantification was 0.07 mol/L. Owing to its simplicity and speed, this method can be used for the batch determination of carbonate content in barite ore.     

Si内标-X射线衍射法定量测定铁矿中Fe3O4、Fe2O3和SiO2

铁矿物相的准确定量对矿物价值评价及选冶工艺研究有重要作用,现有化学法流程复杂效率低,X射线衍射全谱拟合法可溯源性差,结果准确性难以评价和验证。本研究建立了以Si为内标,以Cu靶X射线为辐射光源,步进扫描方式获得衍射谱图,以待测相含量为横坐标,待测相与内标相峰面积比值为纵坐标建立校准曲线,以曲线对铁矿中Fe3O4、Fe2O3和SiO2物相进行定量的方法。试验对制样条件、扫描参数、内标物选择、积分方式、重叠峰校正等进行了优化选择,结果表明,试样全部通过45 μm标准筛,Si内标比例为10%,步进长度0.01°,步进时间30S,选择对Fe3O4（311）、Fe2O3（104）、SiO2（011）和Si（111）的衍射峰进行积分强度计算,可获得最优结果。在选定工作条件下,Fe3O4在1.07～100%范围内线性相关系数(R2)为0.9953,相对标准偏差(RSD)1.1%～13.2% (n=6),加标回收率99.7 %~114.8 %,检出限(LOD)4.29%;Fe2O3在1.51～100%范围内线性相关系数(R2)为0.9991,相对标准偏差(RSD)2.8%～10.6% (n=6),加标回收率87.1%~112.2%,检出限(LOD)2.56%;SiO2在0.79～29.72 %范围内线性相关系数(R2)为0.9957,相对标准偏差(RSD)3.2%～10.3% (n=6),加标回收率86.6%~98.9%,检出限(LOD)0.68%。方法易溯源、准确性易评价和验证,适合开展标准化检测和应用。     

气基磁化焙烧回收包头稀土尾矿中铁的研究

试验采用磁化焙烧-磁选的方法来回收包头稀土尾矿中的Fe。考察了还原球团的粒径、焙烧温度、还原气体的成分、还原气气体流量、焙烧时间对于磁化焙烧回收Fe的影响。在焙烧温度为580℃,CO与CO2的浓度比为40∶60,还原气体气流量为1.2 L·min-1,焙烧时间为60 min的条件下对球团进行磁化焙烧,并将焙烧后的球团进行磨矿,使得-200目的物料占物料总重量的95%。将磨矿后的物料置于磁场强度为233 k A·m-1的磁选管中进行磁选,可以得到品位为60%左右的铁精矿,其铁回收率达到70%左右。     

火试金法测定铜硫矿中的金和银量的研究

本文针对铜硫矿中铜含量较高的特性,建立了适合该试样的配料比、高温熔融,金、银与铅形成合金,利用其比重悬殊与熔渣分离,将铅扣灰吹得金、银合粒,用硝酸分金,用重量法测定金量,用容量法测定银量。方法的相对标准偏差0.66%到4.78%,加标回收率96.5%到100.6%。     

电感耦合等离子体原子发射光谱法(ICP-OES)测定铍铀伴生矿石中的铍

建立了电感耦合等离子体原子发射光谱法(ICP-OES)测定铍铀伴生矿石中的铍的方法,研究了酸溶-碱熔融法溶样过程中加入的焦硫酸钾,对ICP-OES法测定铍铀伴生矿石中的铍含量产生的基体干扰问题。主要阐述消除基体干扰的一些措施。从实验数据可知,控制称样量、焦硫酸钾加入量、定容体积和加标稀释倍数,能够有效消除焦硫酸钾对ICP-OES法测定结果的基体干扰,6次平行测定结果的相对标准偏差为3.4%,加标回收率为98.7%~104.4%,实验表明,方法准确、可靠。     

微波消解-磷钼蓝分光光度法测定钨矿石中的磷含量

针对钨矿石中的微量元素磷,采用混合酸快速微波消解结合磷钼蓝分光光度法进行测定。经选择优化样品的微波消解和实验测定条件,结果表明:HCl+HNO3+HF的混合酸微波消解后的样品,在硫酸介质中,有钼酸铵存在时,用抗坏血酸将磷还原成磷钼蓝络合物,在825nm处比色测定。方法的加标回收率为98.9%~101.6%,结果准确可靠。硅在熔样过程中挥发除去不会干扰测定,砷会干扰实验,可在酸介质中加入碘化钾,使砷还原至低价而不干扰磷的测定。     

泡沫塑料富集-火焰原子吸收光谱法测定金矿石中金

采用聚氨酯泡塑富集硫脲洗脱-火焰原子吸收光谱法测定金矿石中金。对样品称样量、硫脲洗脱时间、磷酸三丁酯的吸附效果和铁元素的干扰等工作条件进行了优化,解决了泡沫塑料吸附效率低和铁元素的干扰等技术性难题,提高了分析结果的精密度和准确度,弥补了传统的泡沫塑料富集-火焰原子吸收光谱法测定金矿石中金量的不足,方法检出限为0.06 μg/g,测定范围为 0.2 μg/g～100 μg/g,测定结果与标准值符合性较好,无显著性差异,精密度(RSD, n = 9) 小于2%。方法具有快速、简便、实用等优点,分析误差满足常规化学分析法的要求,能满足金矿石中金量的快速、准确测定。     

EDTA快速滴定法测定矿石中的氧化铝

介绍一种利用二乙基二硫代氨基甲酸钠分离后以EDTA滴定测定矿石中铝的新方法。锰矿样品用Na OH,Na_3PO_4和Na_2O_2混合熔剂熔融,消除Ca,Mg,Ti的干扰,用含无水乙醇的热水浸取,其中的Mn变为Mn O2沉淀析出,干过滤,定容。将滤液中和至弱酸性,加入二乙基二硫代氨基甲酸钠,一些金属阳离子形成难溶水的络合物而分离,再次过滤,一定量的滤液与过量的EDTA标准溶液反应,用锌标准溶液滴定剩余的EDTA,即得氧化铝的含量。该法采用二甲酚橙为指示剂,同时加入少量氯化十六烷基吡啶,滴定终点颜色突变明显,改善了测量精密度,操作易于掌握。样品测定结果的相对标准偏差为0.42%~1.08%(n=5),加标回收率为97.39%~99.94%。分析过程只需滴定一次,且不使用含铅、铜、氟溶液,方法便捷环保。     

Sulphur removal of iron ore tailings by flotation

Iron ore tailings have become one kind of the most hazardous solid waste. Beneficiation of iron ore tailings is a significant issue in the world steel industries, from the point of view of both pollution control and secondary resources. This investigation addressed the processing of tailings with high sulphur content from an iron ore concentrator to produce pellet feed fines and to prevent acid mine drainage. This study was the lab-scale testing of an integrated method consisting of froth flotation combined with gravity and magnetic separation. Reverse flotation located at the end of the primary treatment circuit (high- and low-intensity magnetic separation) will lower a large amount of the sulphur from magnetic separator concentrate. The effects of various operating parameters such as concentrations of collector, frother, depressant and activator, pH, solid-in-pulp concentration have been studied on the sulphur removal using reverse flotation. According to the data presented in this study, the maximum recovery of total sulphur was obtained when the operational parameters were set to the PAX dosage160?gr/t, MIBC dosage 140?gr/t, CuSo₄ 100?gr/t, air flow rate 10?l/min, pH 8.5, and pulp density 30%. With these optimum parameters, final concentrate with the grade of 63.7% Fe and 0.085% S was obtained. The results of this study indicated that, with this method, a great amount of iron concentrate is produced and, simultaneously, the sulphidic fraction is separated that can later be managed more easily owing to the reduced volume.