Novel tantalum phosphate Na13Sr2Ta2(PO4)9: synthesis,crystal structure,DFT calculations and Dy3+‐activated fluorescence performance

A new tantalum phosphate, tridecasodium distrontium ditantalum nonaphosphate, Na₁₃Sr₂Ta₂(PO₄)₉, was prepared using the high‐temperature flux method. The structure can be described as a three‐dimensional open framework containing isolated [Ta^V₂(PO₄)₉]¹⁷⁻ units that are interlocked by Na and Sr ions. Band structure studies by the first‐principles method revealed that Na₁₃Sr₂Ta₂(PO₄)₉ is an insulator with an indirect band gap of 4.78 eV, which makes it suitable as a luminescent host matrix. A series of solid solutions, i.e. Na₁₃Sr_2–xTa₂(PO₄)₉:xDy³⁺ (x = 0.01, 0.02, 0.04, 0.06, 0.08, 0.1, 0.12 and 0.14), were prepared and their photoluminescence properties studied. Under 350 nm light excitation, these emit two typical emissions of the Dy³⁺ ion, i.e. the ⁴F_9/2→⁶H_15/2 transition centred at 476 nm and the ⁴F_9/2→⁶H_13/2 transition centred at 570 nm.     

1.3 GHz超导腔磁通排出效应研究

设计并搭建了一套高精度的磁场测量和补偿系统,并结合中国科学院高能物理研究所(IHEP)的2K超导腔垂直测试平台对1.3 GHz单加速间隙超导腔的磁通排出效应开展了实验研究:利用研制的磁场测量和补偿系统能够精密地测量超导腔赤道位置磁场,并能够将磁场补偿至小于5.0×10-8 T;并对超导腔不同表面温度梯度下的磁通排出效应进行了测量分析;对钉扎了磁场的超导腔进行了射频性能测试,研究了超导腔电阻对磁通钉扎的敏感度,以及在不同电场梯度下超导腔的表面电阻变化情况。结果表明,研制的高精度磁场测量和补偿系统能够满足超导腔磁通排出研究的需求;高的超导腔表面温度梯度有利于磁通的排出;磁通钉扎电阻的敏感度随着加速电场梯度的增加而增大,导致超导腔的性能下降。此实验研究也为后续超导腔的研制奠定了一定基础。     

Crystal structure and DFT calculations of Cp2NbH(SiIMe2)(SiFMe2): an asymmetric bis(silyl) niobocene hydride complex

An asymmetric bis(silyl) niobocene hydride complex, namely, bis(η⁵-cyclopentadienyl)(fluorodimethylsilyl)hydrido(iododimethylsilyl)niobium, [Nb(C₅H₅)₂(C₂H₆FSi)(C₂H₆ISi)H] or Cp₂NbH(SiIMe₂)(SiFMe₂), has been studied to determine the effect of the silyl ligand on the position of the hydride attached to the Nb atom. It has been shown that when a Group 17 atom is substituted onto one of the silyl ligands, there is a greater interaction between the hydride and this ligand, as demonstrated by a shorter Si…H distance. In the present work, we have investigated the effect when the silyl ligands are substituted by different Group 17 atoms. We present here the structure and DFT calculations of Cp₂NbH(SiIMe₂)(SiFMe₂), showing that the position of the hydride is located between the two silyl ligands. The results from our investigation show that the hydride is closer to the silyl ligand that is substituted by fluorine.     

The Critical Effect of Niobium Doping on the Formation of Mesostructured TiO2: Single‐Crystalline Ordered Mesoporous Nb‐TiO2 and Plate‐like Nb‐TiO2 with Ordered Mesoscale Dimples

Highly ordered mesoporous niobium‐doped TiO₂ with a single‐crystalline framework was prepared by using silica colloidal crystals with ca. 30 nm in diameter as templates. The preparation of colloidal crystals composed of uniform silica nanoparticles is a key to obtain highly ordered mesoporous Nb‐doped TiO₂. The XPS measurements of Nb‐doped TiO₂ showed the presence of Nb⁵⁺ and correspondingly Ti³⁺. With the increase in the amount of doped Nb, the crystalline phase of the product was converted from rutile into anatase, and the lattice spacings of both rutile and anatase phases increased. Surprisingly, the increase in the amount of Nb led to the formation of plate‐like TiO₂ with dimpled surfaces on one side, which was directly replicated from the surfaces of the colloidal silica crystals.     

Interface Engineering of a CoOx/Ta3N5 Photocatalyst for Unprecedented Water Oxidation Performance under Visible‐Light‐Irradiation

Cocatalysts have been extensively used to promote water oxidation efficiency in solar‐to‐chemical energy conversion, but the influence of interface compatibility between semiconductor and cocatalyst has been rarely addressed. Here we demonstrate a feasible strategy of interface wettability modification to enhance water oxidation efficiency of the state‐of‐the‐art CoO_x/Ta₃N₅ system. When the hydrophobic feature of a Ta₃N₅ semiconductor was modulated to a hydrophilic one by in situ or ex situ surface coating with a magnesia nanolayer (2–5 nm), the interfacial contact between the hydrophilic CoO_x cocatalyst and the modified hydrophilic Ta₃N₅ semiconductor was greatly improved. Consequently, the visible‐light‐driven photocatalytic oxygen evolution rate of the resulting CoO_x/MgO(in)–Ta₃N₅ photocatalyst is ca. 23 times that of the pristine Ta₃N₅ sample, with a new record (11.3 %) of apparent quantum efficiency (AQE) under 500–600 nm illumination.     

Influence of substrate temperature and N2/Ar flow ratio on the stoichiometry,structure and hardness of TaNx coatings deposited by DC reactive sputtering

The effect of substrate temperature and N2/Ar flow ratio on the stoichiometry, structure and hardness of TaN_x coatings prepared on (111) Si substrates by DC reactive sputtering was investigated. For the structural, chemical and morphological analysis, X‐ray diffraction (XRD), Auger electron scanning and atomic force microscopy were respectively used. Hardness values of thin films were determined using the work of indentation model from nanoindentation measurements. TaN stoichiometric coatings were obtained for samples deposited at room temperature. The stoichiometric TaN phase was not obtained by increasing the temperature up to 773 K, even when increasing the N₂/Ar flow ratio. Even when a saturation in nitrogen content was achieved, nitrogen vacancies are still present in those samples. For coatings prepared at 773 K and low N₂/Ar flow ratio, a phase mixture between TaN_x and cubic α‐Ta was observed, while a cubic structure δ‐TaN was formed by increasing the N₂/Ar flow ratio. A maximum in hardness and (38 GPa) was obtained for the sample deposited at 773 K and a N₂/Ar flow ratio of 0.2, which presented a δ‐TaN cubic crystalline structure and a roughness value of 1.6 nm. Copyright © 2015 John Wiley & Sons, Ltd.     

Helical Mesoporous Tantalum Oxide Nanotubes: Formation,Optical Activity,and Applications

Nanomaterials with helical morphologies have attracted much attention owing to their potential applications as nanosprings, chirality sensors and in chiral optics. Single‐handed helical Ta₂O₅ nanotubes prepared through a supramolecular templating approach are described. The handedness is controlled by that of the organic self‐assemblies of chiral low‐molecular‐weight gelators (LMWGs). The chiral LMWGs self‐assemble into single‐handed twisted nanoribbons through H‐bonding, hydrophobic association, and π‐π stacking. The Ta₂O₅ nanotubes are formed by the adsorption and polycondensation of Ta₂O₅ oligomers on the surfaces and edges of the twisted organic nanoribbons followed by removal of the template. The optical activity of the nanotubes is proposed to originate from the chiral defects on the inner surfaces of the tubular structures. Single‐handed twisted LiTaO₃ nanotubes can also be prepared using Ta₂O₅ nanotubes.     

Interaction Products of 12·5 Deuterons with Molybdenum and their Isolation Possibilities from Worn-out Cyclotron Parts

Using chemical separations and radiometric measurements medium-half-life irradiation products of molybdenum with 12.5 MeV deuterons were determined (⁹⁰Nb, ⁹²Nb, ^95mNb, ⁹⁵Nb, ⁹⁶Nb, ⁹⁹Mo, ^95mTc, ⁹⁶Tc, ^99mTc) as well as thick target yields for some of them: ⁹²Nb (0.22 μCi/μAh), ⁹⁵Nb(0.05 μCi/μAh), ⁹⁹Mo (64 μCi/μAh), ^95mTc(0.76 μCi/μAh), ⁹⁶Tc((62.5 μCi/μAh). Moreover isolation possibiities of radioactive preparations from removed worn-cut molybdenum parts of the U-120 cycletron are discussed.     

Beiträge zur Mikrobestimmung von Kohlenstoff-14 und Tritium

Die Verwendung Con¹⁴C und Tritium zur Lösung kinetischer und analylischer Probleme erfordert zuverlässige Analysenmethoden. Es wird iiber die Herstellimg von Meβgasen durch Naβcerbrennung mil Chromsäure-Jodsäure-Gemischen, Trockenverbrennung in Gegenwart Con Katalysatoren wie Kupferoxid, Kobaltoxid und Zersetzungsprodukte des Silberpermanganats und durch Umsetziingentm geschlossenen Rohr berichtet. Die Aktivitätsniessungen erfolgten auf cerschiedene IVeise. Hier werden besonders die Ergebnisse diskutiert, die durch Ionisationskammermessungen erzielt wurden. Schlieβlich werden einfache Apparaturen zur routinemäβigen Durchfiihrung von Mikroanalysen beschrieben.