Asymmetric Total Syntheses,Stereostructures, and Cytotoxicities of Marine Bromotriterpenoids Aplysiol B (Laurenmariannol) and Saiyacenol A

There are marine cytotoxic bromotriterpenoids, named the thyrsiferol family that are structurally characterized by some tetrahydropyran (THP) and tetrahydrofuran (THF) rings. The thyrsiferol family belongs to natural products that are often difficult to determine their stereostructures even by the current, highly advanced spectroscopic methods, especially in acyclic systems including stereogenic tetrasubstituted carbon centers. In such cases, it is effective to predict and synthesize the possible stereostructures. Herein, to elucidate ambiguous stereostructures and unassigned absolute configurations of aplysiol B, laurenmariannol, and saiyacenol A, members of the thyrsiferol family, we carried out their asymmetric chemical syntheses featuring 6-exo and 5-exo oxacyclizations of epoxy alcohol precursors and 6-endo bromoetherification of a bishomoallylic alcohol. In this paper, we report total assignments of their stereostructures through their asymmetric chemical syntheses and also their preliminary cytotoxic activities against some tumor cells. These results could not have been achieved without depending on asymmetric total synthesis.     

A simple,rapid and sensitive method based on modified multiwalled carbon nanotube for preconcentration and determination of lead ions in aqueous media in natural pHs

In this study, multiwalled carbon nanotube (MWCNT) was modified by the pyridine group using a silane agent and characterized by infrared spectroscopy (IR), thermal analysis (TG/DTA), and elemental analysis (CHN) and scanning electron microscopy (SEM). The application of this sorbent was investigated in determination of lead ions in aqueous samples, using flame atomic absorption spectrometry (FAAS). Through this study, different parameters such as pH and sample flow rate on adsorption process and eluent concentration, volume and flow rate were optimized. The limit of detection (LOD), the relative standard deviation and the recovery of the method were 2 ng mL^?1, 1.3% and 99.7%, respectively. Two standard reference materials (NIST 1571 and NIST 1572) were used to verify accuracy of this method. Finally, the sorbent was successfully applied for extraction and determination of low levels of Pb(II) ions in aqueous samples.     

Magnetic solid‐phase extraction based on carbon nanosphere@Fe3O4 for enantioselective determination of eight triazole fungicides in water samples

In this work, a carbon nanosphere decorated by Fe₃O₄ nanoparticles was prepared, characterized and used as the magnetic adsorbent. Eight commonly used chiral triazole fungicides, including penconazole, uniconazole, paclobutrazol, triazolone, tebuconazole, hexaconazole, triticonazole and epoxiconazole were extracted from two environmental water samples (river water and lake water) by magnetic solid‐phase extraction, followed by the enantiomeric analysis on a Chiralpark IC column coupled with a triple quadrupole mass spectrometry to evaluate their possible stereoselective degradation occurring in the water samples. The possible factors affecting the extraction performance, such as amount of used adsorbents, pH and ionic strength of water solution, types and volumes of desorption solvents were systematically investigated. Under the optimum conditions, extraction yields of eight triazole fungicides were above 80% and the concentration factors were as high as 1000. Method detection and quantification limits for the enantiomers of eight triazole fungicides were in the range of 0.56–6.95 ng/L. Satisfactory accuracy (relative recovery 77.8–93.5%), good intraday precision (RSD 4.3–9.8%) and interday precision (RSD 3.1–7.9%) were also obtained. The developed method provided the simplicity of operation, rapidity and high enrichment factor, which can be used to monitor and evaluate the behavior of the individual enantiomer of chiral triazole fungicides.     

对比实验法在无机及分析化学实验教学中的应用——以银量法测定氯含量实验为例

介绍莫尔法和荧光黄法测定生理盐水中氯化钠含量的实验原理和操作步骤，针对无机及分析化学实验教学中测定氯含量实验的原理、指示剂、标准溶液、滴定条件及适用范围等内容进行比较和分析，阐明了不同实验方法与操作步骤之间的对应关系。学生根据预习实验，结合具体实验操作、实验现象和实验结果的对比，可以充分直观地理解实验内容，掌握无机及分析化学实验的学习方法，提高学生的发现问题和解决问题的能力。     

基于无人机多光谱图像的土壤水分检测方法研究

以表层土壤为对象,探究土壤的多光谱反射率与土壤水分含量相关性,进行基于无人机多光谱图像的土壤水分含量预测模型方法的探究。选取中国农业大学通州实验站为研究区域,实地采集试验田的土壤样本100组,按照一定梯度配制土壤含水量,配成的土壤含水率为10%~50%之间,土壤含量的真实值采用土壤烘干法进行测定。多光谱相机灵巧便捷,可搭载在无人机上对土壤进行监测。将RedEdged-M型多光谱相机搭载在Phantom 3型无人机上,选择阳光充足的采集环境,实时采集土壤样本的多光谱图像,建立土壤多光谱信息与水分含量之间的模型。利用处理光谱数据的ENVI5.3软件提取土壤样本多光谱信息,以多光谱相机自带的标准白板反射率为100%,计算出土壤样本在蓝、绿、红、红边、近红外五个波段的光谱反射率。采用BP神经网络算法、支持向量机算法、偏最小二乘算法分别建立基于无人机多光谱图像的土壤水分含量的预测模型。以80组土壤样本数据作为训练集,建立基于多光谱图像的土壤水分含量预测模型。采用莱文贝格-马夸特算法对BPNN进行改进,提高了其训练速度,当网络结构为5-10-1时,训练效果最好,本文选择该网络结构;SVM采取高斯核函数,当参数为0.56时,模型效果最好。本研究采用归一化均方根误差(NRMSE)和决策系数(R 2)对三种土壤水分含量的预测模型进行定量对比。以20组土壤样本数据作为测试集,结果可知,基于BP神经网络土壤水分含量预测模型的NRMSE为0.268,R 2为0.872;基于支持向量机的土壤水分含量预测模型的NRMSE为0.298,R 2为0.821;基于偏最小二乘土壤水分含量预测模型的NRMSE为0.316,R 2为0.789。对三种模型分析可知,基于BPNN的土壤水分含量预测模型效果均较好。结果可知,土壤的光谱反射率与含水率间存在较密切的相关性,将多光谱相机搭载在无人机上可以对土壤水分含量进行有效的实时监测,对监测土壤墒情提供技术支持和理论支撑。     

高光谱成像的土壤剖面水分含量反演及制图

传统土壤水分的获取方法仅可获得离散的土壤水分点位数据，难以获得剖面上精细且连续的水分含量分布图。研究了野外条件下利用近红外高光谱（882～1 709 nm）成像反演剖面土壤水分含量（SMC），并实现精细制图的可行性。研究剖面位于江苏省东台市，我们利用近红外高光谱成像仪对剖面进行了5天原位连续观测，共采集了280个土样用于烘干法测定SMC。原始高光谱图像经数字量化值（DN）校正、黑白校正、拼接、几何校正、剪切和掩膜等一系列预处理后，提取各采样点的平均光谱反射率。提取光谱（Raw）经吸光度[LOG₁₀(1/R)]，Savitzky-Golay平滑（SG）、一阶微分（FD）、二阶微分（SD）、多元散射校正（MSC）和标准正态变量（SNV）转换后，采用偏最小二乘回归（PLSR）和最小二乘支持向量机（LS-SVM）方法建立SMC预测模型，并对比分析不同光谱预处理方法与建模方法组合条件下SMC的预测精度。结果表明，光谱反射率随SMC增加逐渐降低，不同光谱预处理方法的预测精度有所差异，除MSC方法外，同一光谱预处理方法的LS-SVM模型预测精度均高于PLSR模型，并且基于LOG₁₀(1/R)光谱的LS-SVM模型对SMC预测精度最高，其建模集的决定系数（R2_c）和均方根误差（RMSE_c）分别为0.96和0.65%，预测集的决定系数（R2_p）、均方根误差（RMSE_p）和相对分析误差（RPD_p）分别为0.88，1.05%和2.88。利用最优模型进行剖面SMC的高空间分辨率精细制图，通过比较SMC反演图中提取的预测值与实测值关系发现预测精度较高（R2: 0.85～0.95, RMSE: 0.94%～1.02%），且两者在剖面中的变化趋势基本一致，说明SMC反演图不仅能很好地反映出土壤水分在整个剖面中毫米级的含量分布信息，也可反映出同一位置处不同天数间的含量差异。因此，利用近红外高光谱成像结合优化的预测模型，能够实现土壤剖面SMC的定量预测及精细制图，有助于快速、有效监测田间剖面土壤水分状况。     

Structure determination of KScS2, RbScS2 and KLnS2 (Ln = Nd,Sm, Tb,Dy, Ho,Er, Tm and Yb) and crystal–chemical discussion

The title structures of KScS₂ (potassium scandium sulfide), RbScS₂ (rubidium scandium sulfide) and KLnS₂ [Ln = Nd (potassium neodymium sufide), Sm (potassium samarium sulfide), Tb (potassium terbium sulfide), Dy (potassium dysprosium sulfide), Ho (potassium holmium sulfide), Er (potassium erbium sulfide), Tm (potassium thulium sulfide) and Yb (potassium ytterbium sulfide)] are either newly determined (KScS₂, RbScS₂ and KTbS₂) or redetermined. All of them belong to the α‐NaFeO₂ structure type in agreement with the ratio of the ionic radii r³⁺/r⁺. KScS₂, the member of this structural family with the smallest trivalent cation, is an extreme representative of these structures with rare earth trivalent cations. The title structures are compared with isostructural alkali rare earth sulfides in plots showing the dependence of several relevant parameters on the trivalent cation crystal radius; the parameters thus compared are c, a and c/a, the thicknesses of the S—S layers which contain the respective constituent cations, the sulfur fractional coordinates z(S²⁻) and the bond‐valence sums.     

Thermally induced solid-state transformation of cimetidine. A multi-spectroscopic/chemometrics determination of the kinetics of the process and structural elucidation of one of the products as a stable N3-enamino tautomer

Exposure of cimetidine (CIM) to dry heat (160–180 °C) afforded, upon cooling, a glassy solid containing new and hitherto unknown products. The kinetics of this process was studied by a second order chemometrics-assisted multi-spectroscopic approach. Proton and carbon-13 nuclear magnetic resonance (NMR), as well as ultraviolet and infrared spectroscopic data were jointly used, whereas multivariate curve resolution with alternating least squares (MCR-ALS) was employed as the chemometrics method to extract process information. It was established that drug degradation follows a first order kinetics.     

Recent advances in liquid chromatographic methods for the determination of selective serotonin reuptake inhibitors and serotonin norepinephrine reuptake inhibitors

Depression is now the second largest public health burden throughout the world. Selective serotonin reuptake inhibitors (SSRIs) and serotonin norepinephrine reuptake inhibitors (SNRIs) have replaced older antidepressants to become first-line medications to treat this disease with increased remission rates and markedly decreased incidence of severe adverse events. Traditional and modern bioanalytical strategies for SSRI and SNRI determination are being continuously improved. There has also been a recent increase in the use of unconventional sample preparation methods. This review critically evaluates the development of SSRI and SNRI liquid chromatographic analytical methods published between 2014 and mid-2019, with special attention to novel sample preparation methods.