Human-to-metal electrostatic discharge current measurements – Notes on the ESD current waveform

The Electrostatic Discharge (ESD) phenomenon has been described through the IEC 61000-4-2. ESD current parameters' values, have been set in this Standard. The theoretical ESD current waveform defined in this standard, describing the conventional Contact discharge mode, needs to be re-evaluated on the basis of accurate experimental data. Even though the standard deals with commercial ESD generators, its goal is to simulate the natural phenomenon as good as possible. More and accurate data may contribute to the better simulation of the natural phenomenon. New values and better comprehension of the phenomenon demand new measurements based on high end measuring equipment. Such works and publications have been carried out the past years. Yet, the need to systematize and integrate this work remains. Larger and trust-worthy series of measurements need to be carried out and presented clearly.This paper deals with new ESD-current data, taken with broadband equipment. New and more detailed measurements like these, were never before taken at such a large number of individuals. The goal of this work is that the data acquired can serve as a basis for re-evaluating the conventional approach of the scientific community to the ESD event.In this paper, using a broadband measuring system, new parameters' values are measured and relations are presented, following standard statistical procedures. The results, which occur from measurements carried out on tenths of human individuals, are questioning the Standard in many points. A new way of approaching the standardization of the ESD current is proposed, as the excuse of the poor measuring equipment that sets barriers on the measuring accuracy, does not apply any more. The charging voltages of 500 V and 1000 V were also examined since such range of voltages are often met at ESD events and they are considered very harmful.     

强耦合腔-QED系统中原子的纳秒脉冲激发光谱研究

本文在多原子强耦合腔-QED系统中,利用脉冲宽度为5 ns的强脉冲光在垂直于腔轴方向直接激发原子,脉冲的峰值功率为40 mW,通过光学腔观测激发原子辐射到腔中的光子获得相应的激发光谱。我们发现当光场频率和原子跃迁失谐±80 MHz时原子激发率达到最大,而在共振时原子激发被抑制。我们建立了脉冲光与三能级原子相互作用的模型,通过缀饰态能够解释此现象。     

Quantifying interference in multipartite quantum systems

The characterization of quantum correlations is crucial to the development of new quantum technologies and to understand how dramatically quantum theory departs from classical physics. Here we systematically study single- and multiparticle interference patterns produced by general two- and three-qubit systems. From this we establish on phenomenological grounds a new type of quantum correlation for these systems, which we name quantum interference, deriving some quantifiers that are given explicitly in terms of the density matrix elements of the complete system. By using these quantifiers, we show that, contrary to our expectations, entanglement is not a required property for a composite quantum system to manifest multiparticle interference.     

Vertex correction and conductivity in 2D Dirac-like systems with non-conserving spin disorder

We determine the classical diffusion of two dimensional Dirac-like quasiparticles, in the presence of conserving spin disorder (scattering off electric impurities) and non-conserving spin disorder (scattering off magnetic impurities). We use the Kubo formula for the conductivity tensor and employ diagrammatic perturbation theory to calculate the vertex correction and the renormalisation of the current operator for both electric and magnetic scattering. Scattering off electric impurities is isotropic and the current operator renormalised to two times the bare current operator irrespective of the direction of the dynamics, as usual for Dirac-like fermions. For magnetic scattering the renormalisation of the current operator depends on the direction of the dynamics and on the polarisation of the magnetic impurities, making the system anisotropic. We calculate the anisotropic magnetoresistance (AMR) and analyse it as a function of the ratio of the strength of the electric to the magnetic scattering potentials, for short range Gaussian correlation.     

群集建筑中大跨裙摆屋盖风荷载特性的数值模拟研究

以苏州太平金融大厦为工程背景,针对其大跨裙摆屋盖的风荷载作用,首先采用RNG k-ε模型模拟分析了其平均风压分布规律,以及风向变化对屋盖表面风荷载体型系数的影响;其次,引入干扰因子IF,探讨了周边建筑对大跨裙摆屋盖风荷载的气动干扰作用。结果表明:0°风向下,走廊上方屋盖两侧区域出现“上吸下顶”的叠加作用;90°风向下屋盖北侧飘带末端区域受到狭道风效应出现正压集中现象;风向变化对大跨裙摆屋盖的风荷载体型系数分布影响较大;且周围建筑物对大跨裙摆屋盖的气动干扰效应明显,主要表现为风压“遮挡效应”,而局部区域表现为风压“放大效应”。     

External electric field effect on electronic properties and charge transfer in CoI2/NiI2 spinterface

Electronic structure and spin-related properties of CoI₂/NiI₂ heterostructure were studied by means of density functional theory. It was shown that the electronic structure at the Fermi level can be characterized by a band gap. The effect of the external electric field on charge transfer and electronic properties of the CoI₂/NiI₂ interface was investigated, and it was found that band gap width depends on the strength of the applied electric field, switching its nature from semiconducting to a half-metallic one. An easy control of the electronic properties and promising spin-polarized nature of the CoI₂/NiI₂ spinterface allows the heterostructure to be used in spin-related applications.     

Comparison study of exchange-correlation functionals on prediction of ground states and structural properties

Despite significant advances in first-principles calculation methods, there is no single exchange-correlation functional which predicts the ground state of materials without an error yet. We investigated how accurately ground states of binary semiconductors are described using 16 exchange-correlation functionals (with or without van der Waals corrections). LDA, PBEsol, SCAN (with or without rVV10 correction), and PBE with D3 van der Waals correction (zero or Becke-Johnson damping) show good predicting power. The lattice constants of stable phases were slightly better described by SCAN, PBEsol, PBE+D3 (Becke-Johnson damping), and MS2. We also propose a set of functionals to double-check the stability of new materials based on the majority vote.     

电感耦合等离子体质谱(ICP-MS)法测定地质样品中Cu和Zn的干扰研究

电感耦合等离子体质谱法（ICP-MS）标准模式测定地质样品中Cu和Zn时,样品溶液中Ti在高温下易形成TiO+和 TiOH+离子产生重叠干扰,使测定值偏离真值而影响测定结果。采用氢氟酸-高氯酸-硝酸消解、王水复溶样品,通过多级在线校正46Ti16O+,消除TiO+和 TiOH+离子重叠干扰,研究了单质Ti与46Ti16O+、质荷比63、64、65、66离子间存在的关系,建立了一种电感耦合等离子体质谱(ICP-MS)法测定地质样品中Cu和Zn的分析方法。实验结果表明：单质Ti对Cu和Zn产生的干扰值与其质量浓度呈非简单的正相关性,TiO+产生的干扰离子质荷比65离子强度比63高,质荷比64离子强度比66 高; 46Ti16O+对质荷比63、66离子干扰增量值与单质Ti质量浓度变化无关;62Ni对46Ti16O+产生同量异位素重叠干扰,测定值须校正来自62Ni的贡献。ICP-MS测定地质样品中Cu和Zn时应选择测量同位素63Cu和66Zn,其检出限（n=7）分别为0.35 μg/g和0.63 μg/g。经有证标准物质验证,测定值与认定值吻合,准确度（RE）<8.6%,精密度（RSD,n=6）<5%。本方法适用于ICP-MS测定地质样品中Cu和Zn的质谱干扰消除,满足地质分析要求。     

Calibration transfer employing univariate correction and robust regression

This paper proposes a new method for calibration transfer, which was specifically designed to work with isolated variables, rather than the full spectrum or spectral windows. For this purpose, a univariate procedure is initially employed to correct the spectral measurements of the secondary instrument, given a set of transfer samples. A robust regression technique is then used to obtain a model with low sensitivity with respect to the univariate correction residuals. The proposed method is employed in two case studies involving near infrared spectrometric determination of specific mass, research octane number and naphthenes in gasoline, and moisture and oil in corn. In both cases, better calibration transfer results were obtained in comparison with piecewise direct standardization (PDS). The proposed method should be of a particular value for use with application-targeted instruments that monitor only a small set of spectral variables.