TiO_2空心微球负载钒、铈催化剂的制备及其对氯苯催化燃烧性能研究

采用水热法制备TiO2空心球,以TiO2空心球为载体,采用等体积浸渍法分别制备了不同V负载量(3%~10%)的V2O5/TiO2和稀土改性后的V2O5-CeO2/TiO2催化剂,利用XRD,SEM,EDS,TEM对TiO2空心球及V2O5-CeO2/TiO2催化剂进行了表征,结果表明,空心球TiO2分散性良好,粒径在1.5μm左右,且其为锐钛矿结构,负载的V和大部分的Ce均匀分散在TiO2空心球体内部或者表面而未破坏TiO2空心球结构。考察了催化剂对氯苯的催化燃烧性能,活性评价结果表明当V负载量在5%时,V2O5/TiO2催化剂对氯苯催化燃烧性能最佳,在掺杂10%的稀土Ce后,催化燃烧氯苯的活性得到明显提高。     

嫁接法制备Ni/SBA-15催化剂的催化氯苯加氢脱氯

SBA-15表面经嫁接方式引入氨基官能团,与Ni络合制备了SBA-15负载的Ni催化剂(Ni/SBA-15N)。同时,采用传统的浸渍法制备了具有相似Ni负载量的催化剂(Ni/SBA-15)。在负载量相近条件下,Ni/SBA-15N的Ni颗粒分散性均高于Ni/SBA-15。XRD和TPR结果表明,催化剂焙烧后,在氨化SBA-15表面,Ni以硅酸镍形式存在,而在SBA-15表面,Ni以NiO形式存在。Ni/SBA-15对氯苯催化加氢脱氯活性不随Ni负载量的变化而变化;而在Ni/SBA-15N中,Ni负载量增加,催化剂活性增加。     

DFT study of the C-Cl bond dissociation enthalpies and electronic structure of substituted chlorobenzene compounds

Quantum chemical calculations were used to estimate the bond dissociation energies (BDEs) for 13 substituted chlorobenzene compounds. These compounds were studied by employing the hybrid density functional theory methods (B3LYP, B3PW1, B3P86) with 6-31G** and 6-311G** basis sets. It was demonstrated that B3P86/6-311G** method is the best method for computing the reliable BDEs for substituted chlorobenzene compounds which contain the C-Cl bond. It was found that the C-Cl BDE depends strongly on a computational method and basis set used. Substitution effect on the C-Cl BDE of substituted chlorobenzene compounds is further discussed. It is shown that the effects of substitution on the C-Cl BDE of substituted chlorobenzene compounds are very insignificant. Frontier orbital energy gap of studied compounds was also investigated. From the data on frontier orbital energies gap, we estimated the relative thermal stability of substituted chlorobenzene compounds.     

Catalytic combustion of chlorobenzene over V2O5/TiO2 catalysts prepared by the precipitation-deposition method

Catalytic combustion of chlorobenzene over supported vanadium oxides has been investigated. TiO₂ was prepared by the sol-gel method from titanium isopropoxide. The supported vanadium oxide catalysts have been prepared by precipitation-deposition and impregnation method and characterized by XRD, FT-Raman and TPR. In the VO_x/TiO₂catalysts prepared using the impregnation method, when vanadium loading reaches 3 wt.%, the activity shows a maximum. However, in the VO_x/TiO₂catalysts prepared by precipitation-deposition, when vanadium loading reaches 7 wt.%, the activity shows a maximum. This result suggests that the precipitation-deposition can yield a higher metal loading on the support and a high dispersion compared to the impregnation method. This revised version was published online in August 2006 with corrections to the Cover Date.     

Low-temperature hydrodechlorination of 2,3-dichlorodibenzo-p-dioxin and chlorobenzene with hydrides catalyzed by transition metal compounds

Hydrodechlorination of chlorobcnzene by chemically bound hydrogen in the presence of transition metal compounds was studied. Alkali and alkaline earth metal hydrides (NaH, MgH₂, LiAlH₄, NaH(LiAlH₄)/12) were used as the sources of the chemically bound hydrogen. The effect of the natures of the hydride and of the transition metal on the activity was studied under comparable conditions. The Pd/C-NaH(LiAlH₄1/2 catalytic system was found to be the most active. This system made it possible to perform the quantitative dechlorination of 2,3-dichlorodibenzo-p-dioxin at 70 °C.Deceased.Translated fromIzvestiya Akademii Nauk. Seriya Khimicheskaya, No. 6, pp. 1391–1394, June, 1996.     

环境污染物中碳氯键离解能的理论研究

利用六种密度泛函理论方法（B3LYP, B3P86, MPW1K, TPSS1KCIS, X3LYP, BMK）对碳氯键离解能进行理论计算,结果发现几种新发展的密度泛函(DFT)方法用于碳氯键离解能的计算比传统的B3LYP有较大的改善,其中对能量估算相对准确的B3P86方法对碳氯键离解能的计算精度最高,对17个分子中碳氯键离解能计算的平均绝对偏差为6.58 kJ/mol。最后运用B3P86方法对一系列环境危害较大,但可通过光化学降解和生物降解的氯代有机物的碳氯键离解能值进行预测,并讨论了影响碳氯键离解能的结构性质关系。     

苯-氯苯二元系的折射分析

研究了液体二元系的折射分析法。发现苯-氯苯的折射率和组成间有良好的线性关系。得出了线性方程。利用方程测得的结果和实际值十分吻合。     

Dielectric Relaxation Study of Liquids Having Chloro Group with Associated Liquids. I. Chlorobenzene with Methanol, Ethanol, and 1-Propanol

The complex permittivity for chlorobenzene–alcohol binary mixtures have been determined over the frequency range of 10 MHz to 20 GHz, at 15, 25, 35, and 45°C, using the time-domain reflectometry (TDR) method for 11 concentrations of each chlorobenzene–alcohol system. The alcohols used were methanol, ethanol, and 1-propanol. The values of static dielectric constant, relaxation time, the corresponding excess properties, the Redlich–Kister coefficients up to the third order, the Kirkwood correlation factor, and thermodynamic parameters of the mixtures have been determined. The excess permittivity is found to be negative for chlorobenzene–methanol and chlorobenzene–ethanol, whereas it is positive in the 1-propanol rich region. The excess inverse relaxation time is negative for all the systems studied here. The Kirkwood effective correlation factor increases with an increasing in the molecular size of the alcohol, but decreases with increasing temperature.     

Adsorption of benzene on the V2O5/γ-Al2O3 catalyst

Adsorption of benzene on the V₂O₅/-Al₂O₃ catalysts was studied in the temperature interval from 443 to 493 K and at partial pressures of the adsorbate ranging from 1 to 400 Pa. The adsorption isotherms were plotted. The isosteric heats and various entropy characteristics of adsorption were determined. Mobility of benzene in the adsorption layer is restricted compared to the model of ideal dimeric gas. The adsorbed amounts of benzene and chlorobenzene are compared.     

Vibrational Spectroscopic Studies on the Hofmann Type Clathrates: M(1,6-diaminohexane)Ni(CN) 4 .G (M = Co, Ni or Cd; G = chlorobenzene, 1,2-, 1,3- or 1,4-dichlorobenzene)

New Hofmann-diaminohexane(dahxn)-type clathrates of the form M(1,6-dahxn)Ni(CN)₄.G (M = Co, Ni or Cd; G = chlorobenzene, 1,2-, 1,3 or 1,4-dichlorobenzene) were prepared inpowder form and their infrared spectra are reported. The spectral data suggest that these compounds are similar in structure to those of the Hofmann-diam-type clathrates. Their structure consists of planar polymeric layers, {M–Ni(CN)₄}, formedfrom Ni(CN)₄ anions coordinated to the bridging 1,6-diaminohexane molecules bound directly to the metal (M). The M atoms are bound to four N atoms of the CN ions and, the Ni atoms are surrounded by four C atoms of the CN groups in a square-planar layer.