Distribution dependent stochastic differential equations

Due to their intrinsic link with nonlinear Fokker-Planck equations and many other applications, distribution dependent stochastic differential equations (DDSDEs) have been intensively investigated. In this paper, we summarize some recent progresses in the study of DDSDEs, which include the correspondence of weak solutions and nonlinear Fokker-Planck equations, the well-posedness, regularity estimates, exponential ergodicity, long time large deviations, and comparison theorems.     

Controlling thermomechanical behavior of semicrystalline hydrogenated polynorbornene through the cis- to trans-cyclopentylene ratio

Though polynorbornene synthesized by ring-opening metathesis polymerization has an intrinsically all-cis configuration of the cyclopentylene backbone rings, a fraction of these rings can be epimerized to the trans configuration during hydrogenation over suitable catalysts. By varying the method of hydrogenation, semicrystalline hydrogenated polynorbornenes (hPNs) with trans levels between 0 and 36% were obtained. With increasing trans content, the glass transition temperature, melting point, and enthalpy of melting decrease modestly. By contrast, the temperature at which the hPN crystal transitions into a rotationally disordered polymorph varies strongly with trans content, ranging from 126 °C (all-cis) to 71 °C at 27% trans; at trans contents of 34% and above, no rotationally-ordered phase is observed at any temperature. The room-temperature Young's modulus shows no dependence on trans content, while the yield stress drops by 20% at 1% trans content and slowly decreases further with additional epimerization. The temperature dependence of the Young's modulus differs for trans-containing versus all-cis polymers, while the temperature dependence of the yield stress is set by the polymorph type (rotationally ordered vs. disordered).     

Nickel tetrathiooxalate as a cathode material for potassium batteries

We report a nickel tetrathiooxalate (NiTTO) coordination polymer as a cathode material for potassium batteries. In a potential range of 1.3–3.6 V vs. K⁺/K, the specific capacity of the material is 209 mA h g^?1 at a current density of 0.1 A g^?1, which roughly corresponds to the two-electron reduction of polymer repeating units. The charge–discharge mechanisms of NiTTO in potassium cells were examined using operando Raman spectroscopy.     

移动加热器法生长碲锌镉晶体的组分输运与界面形貌研究

移动加热器法(THM)生长碲锌镉晶体时,界面稳定性对晶体生长的质量有很大影响。本文基于多物理场有限元仿真软件Comsol建立了THM生长碲锌镉晶体的数值模拟模型,讨论了Te边界层与组分过冷区之间的关系,对不同生长阶段的物理场、Te边界层与组分过冷区进行仿真研究,最后讨论了微重力对物理场分布的影响,并对比了微重力与正常重力下的生长界面形貌。模拟结果表明,Te边界层与组分过冷区的分布趋势是一致的,在不同生长阶段,流场中次生涡旋的位置会发生移动,从而导致生长界面的形貌随着生长的进行发生变化,同时微重力条件下形成的生长界面形貌最有利于单晶生长。因此,在晶体生长的中前期,对次生涡旋位置的控制和对组分过冷的削弱,是THM生长高质量晶体的有效方案。     

Calcium-based coordination polymers from a solvothermal synthesis of HKUST-1 in 3D printed autoclaves

A mixed-metal 1D coordination polymer [CaCu(HBTC)₂(H2O)₈]_n (where H₃BTC – benzene-1,3,5-tric arboxylic acid) was obtained in a solvothermal synthesis of a well-known copper-containing metal–organic framework [Cu₃(BTC)₂(H₂O)₃]_n (HKUST-1) in autoclaves 3D-printed from commercial polypropylene. This material was a source of calcium ions, apparently, leaking from a colorant (calcium carbonate) promoted by glacial acetic acid as a modulator used to produce large single crystals of HKUST-1. This finding was confirmed by elemental analysis and a model experiment that resulted in a new calcium-based 1D coordination polymer [Ca(H₂BTC)₂(H₂O)₅]_n under the same solvothermal conditions with no copper or calcium salts put into a 3D-printed autoclave.     

Synthesis of 29H,31H-phthalocyanine and chloro (29H,31H-phthalocyaninato) aluminum derivatives showed anti-cancer and anti-bacterial actions

Continuous administration of most chemotherapeutic drugs can induce different types of side effects. There has been growing interest in exploring an alternative approach to synthesizing compounds that are most effective and have fewer side effects. We synthesized 29H,31H-Phthalocyanine, and Chloro (29H,31H- phthalocyaninato) aluminum at low temperatures using lithium in the present study with diisopropylamide as the nucleophile. The physical characteristics of 29H,31H-Phthalocyanine, and Chloro (29H,31H- phthalocyaninato) aluminum were confirmed by FT-IR method, XRD, SEM, and the impact of these compounds on human colorectal carcinoma (HCT-116) and human cervical cells (HeLa) was examined. Treatment with 29H,31H-Phthalocyanine significantly decreased cancer cell growth and proliferation, as determined by MTT and DAPI staining analysis. In contrast, Chloro (29H,31H- phthalocyaninato) aluminum treatment did not show any inhibitory action on colon or cervical cancer cells. We also calculated the inhibitory concentration (IC50) of 29H,31H-Phthalocyanine, which was 30 µg/ml (HCT-116) and 33 µg/ml (HeLa cells). The antibacterial effectiveness of 29H,31H-Phthalocyanine, and chloro (29H,31H- phthalocyaninato) aluminum was studied using Enterococcus faecalis (E. faecalis). The CFU (colony frequency unit) assay confirmed significant activity against the test bacterium after treatment with 29H,31H-Phthalocyanine. However, no activity was seen upon treatment with chloro (29H,31H- phthalocyaninato) aluminum against E. faecalis.     

One-pot,one-step,and selective terpolymerization of ethylene oxide,propylene oxide,and COS to copoly(thioether)s with tunable thermal properties

Facile construction of sulfur-rich polymers using readily available raw chemicals is an area aggressively pursued but challenging. Herein we use common feedstocks of ethylene oxide (EO), propylene oxide (PO), and carbonyl sulfide (COS) to synthesize copoly(thioether)s which are traditionally produced from unpleasant and difficult to store episulfides. In this protocol, the EO/COS coupling selectively generates a pure poly(ethylene sulfide) (PES) with melting temperature (T_m) values up to 172°C and high yields up to 98%. The EO/PO/COS terpolymerization leads to the incorporation of soft poly(propylene sulfide) (PPS) and hard PES segments together, affording a random PES-co-PPS copoly(thioether) with the complete consumption of EO and PO. Additionally, by simply varying the EO/PO feeding ratio, the obtained copoly(thioether)s possess tunable thermal properties, T_m values in the range of 76–144°C, and excellent solubility. These copolymerizations are conducted in one-pot/one-step at industrially favored reaction temperatures of 100–120°C using catalysts of common organic bases, suggesting a facile and practical manner. Especially, the copoly(thioether) exhibits high refractive indices up to 1.68 owing to its high sulfur content, suggesting a broad application prospect in optical materials.     

Four-Step Spin Crossover in a New Cyano-Bridged Iron-Silver Coordination Polymer

Spin-crossover complexes with multistep transitions attract much attention due to their potential applications as multi-switches and for data storage. A four-step spin crossover is observed in the new iron(II)-based cyanometallic guest-free framework compound Fe(2-ethoxypyrazine)₂{Ag(CN)₂}₂ during the transition from the low-spin to the high-spin state. A reverse process occurs in three steps. Crystallographic studies reveal an associated stepwise evolution of the crystal structures. Multiple transitions in the reported complex originate from distinct Fe^II sites which exist due to the packing of the ligand with a bulky substituent.     

Properties of the Reactants and Their Interactions within and with the Enzyme Binding Cavity Determine Reaction Selectivities. The Case of Fe(II)/2-Oxoglutarate Dependent Enzymes

Fe(II)/2-oxoglutarate dependent dioxygenases (ODDs) share a double stranded beta helix (DSBH) fold and utilise a common reactive intermediate, ferryl species, to catalyse oxidative transformations of substrates. Despite the structural similarities, ODDs accept a variety of substrates and facilitate a wide range of reactions, that is hydroxylations, desaturations, (oxa)cyclisations and ring rearrangements. In this review we present and discuss the factors contributing to the observed (regio)selectivities of ODDs. They span from inherent properties of the reactants, that is, substrate molecule and iron cofactor, to the interactions between the substrate and the enzyme's binding cavity; the latter can counterbalance the effect of the former. Based on results of both experimental and computational studies dedicated to ODDs, we also line out the properties of the reactants which promote reaction outcomes other than the “default” hydroxylation. It turns out that the reaction selectivity depends on a delicate balance of interactions between the components of the investigated system.