Microfunnel‐filter‐based emulsification microextraction followed by gas chromatography for simple determination of organophosphorus pesticides in environmental water samples

A simple and fast method named microfunnel‐filter‐based emulsification microextraction is introduced for an efficient determination of some organophosphorus pesticides including diazinon, malathion, and chlorpyrifos in the environmental samples including the river, sea, and well water. This method is based upon the dispersion of a low‐toxicity organic solvent (dihexyl ether), as the extractant, in a high volume of an aqueous sample solution (45 mL). It is implemented without a centrifugation step, and using a syringe filter and a micro‐funnel, the phase separation and transfer of the enriched analytes to the gas chromatograph are simply achieved. By filtration of the extractant phase, a suitable sample clean‐up is obtained, and the total extraction time is just a few minutes. The factors influencing the extraction efficiency are optimized, and under the optimal conditions, the proposed method provides a good linearity (in the range of 15–1500 ng/mL (R² > 0.996). A high enrichment factor is obtained (in the range of 306–342), and the method provides low limits of detection and quantification (in the ranges of 4–8 and 15–25 ng/mL, respectively).     

Rapid and easy quantification of elemental sulphur in aqueous samples from biological reactors: the turbidimetric method revisited

Recent developments in wastewater treatment have led to a renewed interest to obtain elemental sulphur (S°) as a by-product from bioreactors. However, practical studies are limited by the gap of adequate analytical techniques for its determination. This paper provides a statistical study and matrix effect evaluation of an adapted spectrophotometric method for routine S° analyses in aqueous samples, based on a methodology previously described by Hart (1961). Four complex matrices were tested: domestic sewage and effluent samples from three different bioreactors. Tested performance criteria included linearity, matrix effect, limit of detection and quantification and S° recovery. Results were linear (R² = 0.99994) in the studied range (5 to 100 mg S° L^?1) and no matrix effect was observed. The accuracy was based on recovery values that varied from 100% to 106%. The colloidal S° separation and extraction protocol was also considered suitable for aqueous samples, reaching more than 99.0% of S° recovery.     

Stable isotope dilution assay for the accurate determination of tricaine in fish samples by HPLC–MS–MS

Tricaine methanesulfonate is one of most commonly used anesthetics in fish during blood sampling, artificial propagation and long‐distance transportation. In this study, an accurate method for the quantitative determination of tricaine in fish samples by a stable isotope dilution assay coupled with high‐performance liquid chromatography–triple quadrupole mass spectrometry was developed. Tricaine‐D₅ was synthesized and used as an isotopically labeled internal standard for the determination of tricaine. The analytical performance of the method was validated for tricaine determination in marine fish and freshwater fish. The determination of tricaine was linear in the range of 2.0–200.0 μg L^?1. The limit of detection and limit of quantitation for fish muscle tissues were 1.0 and 4.0 μg kg^?1, respectively. Good recoveries were obtained in the range of 92.08–97.50%. The inter‐ and intra‐assay relative standard deviations (RSD values) were investigated, and the values were 0.39–3.01 and 0.85–2.77%, respectively. The values of CCα and CCβ were 10.21–10.43 and 10.42–10.87 μg kg^?1, respectively. The clearance of MS‐222 from grass carp was further studied using our method. The results demonstrate that MS‐222 could be well absorbed and rapidly eliminated after bath administration.     

Comparative study between two fabricated potentiometric sensors to enhance selectivity towards ferrous ions

Electroanalytical methods are highly selective for measuring electrical quantities including the charge, potential and current with their relation to chemical parameters. They are widely applied in various fields such as biochemical analysis, industrial quality control and environmental monitoring. They have many advantages over other techniques in that they are not time consuming and are specific for certain oxidation states of certain elements which give these techniques high selectivity and sensitivity features. This paper is based on two parts: the first part describes the fabrication of screen‐printed electrodes (SPEs) modified with methyl red as electroactive material, while second part describes the preparation and characterization of Fe(II)–methyl red complex using various spectroscopic tools, the complex being used for the construction of carbon paste electrodes (CPEs). The two proposed electrodes were successfully applied for the determination of Fe(II) in water and pharmaceutical (pharovit) samples. The electrodes under investigation show potentiometric response for Fe(II) in the concentration range 8.0 × 10^?7–1.0 × 10^?2 and 5.0 × 10^?7–1.0 × 10^?2 M at 25°C for SPE and CPE, respectively, and the electrode response is independent of pH in the range 1.5–7.0. These sensors show Nernstian slopes of 29.1 ± 0.2 and 29.7 ± 0.16 mV decade^?1 with detection limit values of 8.0 × 10^?7 and 5.0 × 10^?7 M for SPE and CPE, respectively. These electrodes show fast response time of 6 and 4 s and exhibit a lifetime of 100 and 30 days for SPE and CPE, respectively. The mechanism of chemical reaction between modifier and Fe(II) on the SPE surface was studied using infrared spectra, scanning electron microscopy and energy‐dispersive X‐ray analysis. The proposed potentiometric method was validated according to the IUPAC recommendations. The results obtained using the proposed sensors were comparable with those obtained with inductively coupled plasma analysis.     

Experimental strategy of the spectrophotometric approach using freeze-drying for PO43− determination in frozen and chilled chickens in the Saudi Arabia market

Herein, an efficient analytical method based on an extraction protocol was developed and validated for the spectrophotometric detection of phosphate (PO₄^3?) in chilled and frozen chicken samples. The preparation was a very simple sample that included freeze-drying, extraction with acidified amino acids and filtration of the final extract prior to spectrophotometric analysis. FT-IR spectrum of CS1 was confirmed that the selected solvent has successfully extracted PO₄^3? from the chilled chicken sample. Analytical performances were assessed in chilled of one of the merchant species and showed good recoveries with relative standard deviations (RSD) below 2%. The analytical validation parameters of the method in terms of limit of quantification (LOQ) and detection (LOD) were calculated and found to be 0.10 and 0.032 mg/L, respectively. This protocol has been effectively applied to PO₄^3? determination in chicken samples collected from Saudi supermarkets (Northern KSA), and PO₄^3? in all frozen samples was detected at high mg/kg levels ranging from 2.11 × 10⁴ to 2.90 × 10⁴ mg/kg, while in limit levels of PO₄^3? concentration were detected in the chilled samples except chilled sample 1 (CS1), which was 2.22 × 10⁴ mg/kg. The extraction and determination protocol suggested that this developed method could be validated for routine monitoring of PO₄^3? in food quality control laboratories and safety monitoring.     

Facile synthesis of spherical covalent organic frameworks for enrichment and quantification of aryl organophosphate esters in mouse serum and tissues

Here, an imine-linked-based spherical covalent organic framework (COF) was prepared at room temperature. The as-synthesized spherical COF served as an adsorbent in dispersive solid-phase extraction (dSPE), by its virtue of great surface area (1542.68 m²/g), regular distribution of pore size (2.95 nm), and excellent stability. Therefore, a simple and high-efficiency dispersive solid phase extraction method based on a spherical COF coupled with high-performance liquid chromatography-tandem mass spectrometry (HPLC-MS/MS) was established to determine aryl organophosphate esters in biological samples. This approach displayed favorable linearity in the range of 10.0–1000.0 ng/L (r > 0.9989), a high signal enhancement factor (58.8–181.8 folds) with low limits of detection (0.3–3.3 ng/L). Moreover, it could effectively eliminate complex matrix interference to accurately extract seven aryl organophosphate esters from mouse serum and tissue samples with spiked recoveries of 82.0%–117.4%. The as-synthesized spherical COF has been successfully applied in sample preparation. The dSPE-HPLC-MS/MS method based on a spherical COF has potential application to study the pollutants' metabolism in vivo.     

氟化铵快速分解－电感耦合等离子体质谱法测定地球化学样品中的稀土元素

测定地球化学样品中的微量稀土元素常用混酸分解法或碱熔融法,这些常规方法往往存在耗费试剂量多、基体效应大、操作周期长等缺点。本文采用氟化铵作熔剂,在旋盖聚四氟乙烯坩埚中220℃熔融样品,后采用2毫升硝酸和0.5毫升高氯酸、硫酸（1+1）在电热板上继续分解,建立了氟化铵分解 －电感耦合等离子体质谱法测定岩石、土壤和水系沉积物中15种微量稀土元素的分析方法。本方法能快速、有效地分解样品,经三种国家标准物质验证（岩石、土壤、水系沉积物）,方法的准确度ΔlgC在0.001～0.02之间,测定值与认定值相符。方法检出限为0.001～0.04μg／g之间,精密度RSD%在1.11％ ～4.85％之间,能够满足微量稀土元素的分析要求,方法具有简单快捷、消耗试剂少、检出限低、精密度与准确度好等特点,适合于地球化学等地质样品微量稀土元素的批量快速分析测定。     

地质环境样品中挥发酚分析现状与进展

挥发酚被列为环境优先控制的有机污染物,已成为评价环境污染的重要指标之一。该文简述了挥发酚的化学性质及地质环境来源,概括了国内外挥发酚测定的相关标准方法,从样品预处理技术和检测技术两方面综述了近年来地质环境样品中挥发酚分析的研究现状。重点对溶剂萃取、蒸馏、固相萃取、固相微萃取和吹扫捕集等样品预处理技术,以及4-氨基安替比林分光光度法、紫外和荧光分光光度法、溴化容量法、气相色谱法、液相色谱法和酚生物传感器法等技术在地质环境样品中挥发酚分析上的应用进行了较为全面的总结,并对其未来的发展趋势进行了展望,为进一步研究挥发酚的分析技术及其环境应用提供参考。     

Trace analysis of Pt (IV) metal ions in roadside soil and water samples by Fe3O4/graphene/polypyrrole nanocomposite as a solid-phase extraction sorbent followed by atomic absorption spectrometry

A novel Fe₃O₄/graphene/polypyrrole nanocomposite has been successfully synthesised via a simple chemical method and applied as a new magnetic solid-phase extraction (MSPE) sorbent for the separation and pre-concentration of trace amounts of Pt (IV) in environmental samples followed by flame atomic absorption spectrometric (FAAS) detection. The nanocomposite has been characterised by scanning electron microscopy (SEM), transmission electron microscopy (TEM) and Fourier transform infrared (FTIR) spectroscopy. Seven important parameters, affecting the extraction efficiency of Pt (IV), including pH, adsorption time, desorption solvent type and concentration, desorption time, elution volume and sample volume, were investigated. Under the optimised conditions, the calibration graph was linear in the range of 50–1500 μg L^?1 (R = 0.993). The detection limit and pre-concentration factor (PF) for Pt (IV) were found to be 16 μg L^?1 and 112.5, respectively. Under the optimised solid-phase extraction (SPE) conditions, the adsorption isotherm and the adsorption capacity of the nanocomposite for Pt (IV) were studied. Pt (IV) adsorption equilibrium data were fitted well to the Langmuir isotherm and the maximum adsorption capacity of the magnetic sorbent was calculated from the Langmuir isotherm model as 416.7 mg g^?1. The precision of the method was studied as intraday and interday variations. A relative standard deviation percentage (RSD%) value less than 3.0 indicates that the method is precise. Also, the accuracy of the method was tested by the analysis of the standard reference material (NIST SRM 2556) and by recovery measurements on spiked real samples. It was also shown that the optimised method was suitable for the analysis of trace amounts of Pt (IV) in roadside soil, tap water and wastewater samples.