Negative Charging of Au Nanoparticles during Methanol Synthesis from CO2/H2 on a Au/ZnO Catalyst: Insights from Operando IR and Near‐Ambient‐Pressure XPS and XAS Measurements

The electronic and structural properties of Au/ZnO under industrial and idealized methanol synthesis conditions have been investigated. This was achieved by kinetic measurements in combination with time‐resolved operando infrared (DRIFTS) as well as in situ near‐ambient pressure X‐ray photoelectron spectroscopy (NAP‐XPS) and X‐ray absorption near‐edge spectroscopy (XANES) measurements at the O K‐edge together with high‐resolution electron microscopy. The adsorption of CO during the reaction revealed the presence of negatively charged Au nanoparticles/Au sites during the initial phase of the reaction. Near‐ambient‐pressure XPS and XANES demonstrate the build‐up of O vacancies during the reaction, which goes along with a substantial increase in the rate of methanol formation. The results are discussed in comparison with previous findings for Cu/ZnO and Au/ZnO catalysts.     

Size and Shape Effect of Gold Nanoparticles in “Far‐Field” Surface Plasmon Resonance

The “far‐field” surface plasmon resonance (FSPR) of metal nanoparticles, which have built a facile way to emission enhancement of red, green, blue, and white with nice reproducibility, has big potential application in solution‐processed organic light‐emitting diodes (OLEDs). According to the theory of the “far‐field” effect, the reflectivity of the metal surface and the phase shift at the reflection play an important role in enhancing ratio, which strongly relate to the size and shape of nanoparticles. In this work, gold nanospheres with different sizes and nanorods are synthesized in order to determine the size and shape effect of FSPR. The results demonstrate that the one with higher reflectivity in a certain range induces a better emission enhancement in the luminous efficiency and the maximum brightness. The nanoparticles with bigger sizes and shape of rods have higher reflectivity, which is consistent with the simulation based on FSPR effect. The phase shifts of different nanoparticles are optimized by the distance between gold nanoparticles and emitters. The metal NPs with a high reflectivity and the applicable phase shift will have big potential for the emission enhancement in OLEDs.     

Construction of a Graphene/Au‐Nanoparticles/Cucurbit[7]uril‐Based Sensor for Pb2+ Sensing

The development of highly sensitive and selective methods for the detection of lead ion (Pb²⁺) is of great scientific importance. In this work, we develop a new surface‐enhanced Raman scattering (SERS)‐based sensor for the selective trace measurement of Pb²⁺. The SERS‐based sensor is assembled from gold nanoparticles (AuNPs) and graphene using cucurbit[7]uril (CB[7]) as a precise molecular glue and a local SERS reporter. Upon the addition of Pb²⁺, CB[7] forms stronger complexes with Pb²⁺ and desorbs from AuNPs, resulting in a sensitive “turn‐off” of SERS signals. This SERS‐based assay shows a limit of detection (LOD) of 0.3 nm and a linear detection range from 1 nm to 0.3 μm for Pb²⁺. The feasibility of the assay is further demonstrated by probing Pb²⁺ in real water samples. This SERS‐based analytical method is highly sensitive and selective, and therefore holds promising applications in environmental analysis.     

Three-ligand Co-assembled 2D Au(I)-Thiolate Nanosheets

Two-dimensional (2D) Au(I)-thiolate assemblies are a special type of material that can balance high structural stability and rich surface functionality, which shows promising prospects in both fundamental research and applications. Co-assembly of multiple ligands is a facile way to further enrich the surface properties and functions, and expand their application potentials. In this work, taking 3-mercaptopropionic acid (MPA), cysteine (Cys) and 1-thioglycerol (TGO) as example ligands, we studied in detail the possibility to co-assemble them into one nanosheet. Although the three ligands have significantly different controllability and pathways when self-assembling individually with Au(I), they can still be effectively co-assembled by reacting with HAuCl₄ together to obtain three-ligand nanosheets with good colloidal stability. The key points for successful co-assembly are also revealed by comparing single- and three-ligand self-assembly processes, laying a solid foundation for co-assembly of even more ligands. The easy but powerful strategy for 2D materials with closely-packed and multiple tunable surface functional groups addresses the surface engineering problem for 2D materials and paves the way for their wider applications in sensing and biomaterials.     

消光式核壳二聚体传感器的设计与光谱特性分析

根据ITO/Au纳米核壳二聚体粒子在生物医学领域的应用合理性,设计了一种实时检测生物液体的核壳二聚体探针消光式传感器;由偶极子理论推导出输出波长与外界环境折射率关系;利用MATLAB设计ITO/Au纳米核壳二聚体粒子结构;采用软件DDSCAT7.3结合离散偶极近似法,利用二聚体有效半径模拟计算了300~950nm可见光到红外光波段不同核壳比、二聚体间距、以及不同介质折射率的消光光谱;根据传感芯片折射率与偶极共振、耦合八级共振的响应关系得出ITO/Au二聚体的折射率灵敏特性。与传统Ag/Au核壳纳米粒子相比,ITO/Au纳米核壳二聚体结构引入了可作为传感芯片灵敏性自参考参数的耦合八级共振峰,同时ITO/Au二聚体结构的折射率灵敏度可达到419nm/RIU。这些工作及其结果对制作消光式传感器具有重要的意义。     

Selective Oxidation of Aldehyde over Hydroxymethyl Group Catalyzed by Gold Nanoparticles in Aqueous Phase

A protocol for selectively oxidizing aldehyde over hydroxymethyl group is developed, using biomass starch protected gold nanoparticles (NPs) as catalyst. The Au NPs show high selectivity that aldehyde is oxidized into carboxylic acid while alcoholic hydroxyl group stays intact in selective oxidation of 4-(hydroxymethyl)-benzaldehyde. The heterogeneous catalysis system is composed of soluble catalysts and insoluble substrate. The gold catalyst is prepared, preserved and applied for catalytic oxidation all in water. After reaction conditions are optimized, H\begin{document}$_2$\end{document}O\begin{document}$_2$\end{document} is found to be the best oxidizing agent with complete conversion. Besides, the gold catalyst displays good versitility for aldehyde derivatives. After reaction completes, organic components are extracted by organic solvent and gold NPs in water are separated and recycled.     

Antimicrobial Effect and Cytotoxic Evaluation of Mg-Doped Hydroxyapatite Functionalized with Au-Nano Rods

Hydroxyapatite (HA) is the main inorganic mineral that constitutes bone matrix and represents the most used biomaterial for bone regeneration. Over the years, it has been demonstrated that HA exhibits good biocompatibility, osteoconductivity, and osteoinductivity both in vitro and in vivo, and can be prepared by synthetic and natural sources via easy fabrication strategies. However, its low antibacterial property and its fragile nature restricts its usage for bone graft applications. In this study we functionalized a MgHA scaffold with gold nanorods (AuNRs) and evaluated its antibacterial effect against S. aureus and E. coli in both suspension and adhesion and its cytotoxicity over time (1 to 24 days). Results show that the AuNRs nano-functionalization improves the antibacterial activity with 100% bacterial reduction after 24 h. The toxicity study, however, indicates a 4.38-fold cell number decrease at 24 days. Although further optimization on nano-functionalization process are needed for cytotoxicity, these data indicated that Au-NRs nano-functionalization is a very promising method for improving the antibacterial properties of HA.     

Solid-state luminescence of Au(I) complexes with external stimuli-responsive properties

In the last decade, the field of stimuli-responsive luminescent materials have been intensely emerged because of the high potential application to functional sensors or photoelectronic devices. In particular, luminescent molecular crystals constructed from Au(I) complexes have produced a wide range of examples of luminescent alterations when some external stimulations, such as heat, mechanical stress, vapor (or solvents), were applied to the solid samples. In this review, we describe the recent progress through a summary of the reported Au(I) complexes based on their utilized stimuli-responsive mechanisms, which are categorized in crystal phase transitions (“crystal-to-amorphous”, “crystal-to-crystal” and “single-crystal-to-single-crystal” transitions) and molecular rotation in crystalline media, respectively.     

Boosting the Efficiency of Dye-Sensitized Solar Cells by a Multifunctional Composite Photoanode to 14.13 %

We report a new strategy to fabricate a multifunctional composite photoanode containing TiO₂ hollow spheres (TiO₂-HSs), Au nanoparticles (AuNPs) and novel NaYF₄ : Yb,Er@NaLuF₄ : Eu@SiO₂ upconversion nanoparticles (UCNPs). The AuNPs are grown on the photoanode film including TiO₂-HSs and UCNPs by a simple in situ plasmonic treatment. As a result, an impressive power conversion efficiency of 14.13 % is obtained, which is a record for N719 dye-based dye-sensitized solar cells, demonstrating great potential for the solar cells toward commercialization. This obvious enhancement is ascribed to a collaborative mechanism of the TiO₂-HSs exhibiting excellent light-scattering ability, of the UCNPs converting near-infrared photons into visible photons and of the AuNPs presenting outstanding surface plasmon resonance effect. Notably, a steady-state experiment further reveals that the champion cell exhibits 95.33 % retainment in efficiency even after 180 h of measurements, showing good device stability.