燃煤烟气中As、Se、Pb的形态分布及S、Cl元素对其形态分布的影响

基于化学热力学平衡分析方法，计算分析了燃煤烟气中重金属As、Se、Pb的形态分布规律，研究了S、Cl等元素对As、Se、Pb的形态分布规律的影响。结果表明，氧化性气氛下，As以As₂O₅、As₄O₆、AsO等氧化物的形式存在；Se主要以SeO₂形式存在；Pb在1000 K以下主要是固态PbSO₄，1200 K以上为气态PbO。还原性气氛下，As在较低温度时为固态As₂S₂，900-1400 K以As₂、AsS、AsN气体共存，2000 K以上全部转化为气态AsO。Se在1100 K以下主要以气态H₂Se存在，1100 K开始生成SeS和Se₂气体，1800 K时主要是气态Se和少量气态SeO；Pb在中低温时主要是PbS，1800 K以上气态Pb为主要存在形态。S在还原性气氛下增大了AsS（g）、PbS（g）、SeS（g）的比例，氧化性气氛下对As、Se、Pb形态分布基本无影响；Cl无论在氧化还是还原气氛下对As、Se影响均较小，但对Pb的形态分布影响较大。     

The Investigation of Bulk and Surface Polariton Modes in Ga1?xNxAs by Using Infrared Magneto Spectroscopy

We present and discuss infrared magnetoplasma reflectivity and surface polariton modes in Ga_1–xN_xAs. It assumed that the sample is characterized by a magnetoplasma dielectric tensor. Surface polariton dispersion for two component magnetoplasma was calculated from reflectivity spectra data. We detect transverse optic phonon of GaN sublattice in 470 cm^-1. The origin of sharp feature in p-polarization reflectivity about 300 cm^–1 as well as LO phonon frequency of GaAs sublattice is due to Brewster mode. An interesting feature of surface modes in Voigt geometry is nonreciprocalicity, which means that the frequency changes when the direction of propagation is reversed. Also, the infrared magnetoplasma reflectivity of GaNAs should be providing determination of the electrons and heavy holes effective mass and carrier's concentration.     

A Highly Sensitive Spectrophotometric Assay of Bleomycins Based on the Fading Reaction of Some Halofluorescein Dyes

In weak acidic medium, anticancer antibiotics bleomycin A5 （BLMA5） and bleomycin A2 （BLMA2） can react with halofluorescein dyes such as erythrosin （Ery）, eosin Y （EY）, eosin B （EB） and rose bengal （RB） by virtue of electrostatic attraction and hydrophobic force to form the ion-association complexes, which can result in the fading reactions of four halofluorescein dyes. The maximum fading wavelengths of these four dyes were located at 527 nm for Ery, 515 nm for EY, 517 nm for EB and 546 nm for RB, respectively. The decrements of absorbance （AA） were directly proportional to the concentrations of bleomycin in a certain range. A new method for the determination of bleomycins anticancer drugs based on fading reactions of halofluorescein dyes has been developed. The method was not only highly sensitive but also simple and rapid. The molar absorptivities （ε） ranged from 1.5 × 10^5 to 7.5 × 10^5 L·mol^-1·cm^-1. It was applied to determination of the bleomycins in human serum, urine and rabbit serum samples. In this work, the spectral properties and the optimum reaction conditions were investigated. The structure of ion-association complexes and the reaction mechanism were discussed.     

Synthesis and structural characterization of [PhE(BNMe2)2]2 (E = P or As): Six-Membered P2B4 and As2B4 Rings with Unusual Structures

The reaction of either Li₂PPh or Li₂AsPh with the diborane(4) derivative B₂(NMe₂)₂Br₂ affords the compounds [PhP(BNMe₂)₂]₂ ( 1 ) or [PhAs(BNMe₂)₂]₂ ( 2 ) in good yield. Both 1 and 2 have cyclic structures featuring non-planar P₂B₄ or As₂B₄ six-membered rings which have chair configurations. Although all four borons in each ring have planar coordination, the two phosphorus or arsenic centers have different degrees of pyramidalization. Bond distances within the rings indicate that the B? B, B? P or B? As bonds are single, whereas the exo-B? N bond lengths are consistent with significant π-bonding. The ring structures of 1 and 2 are in sharp contrast to the related boron-nitrogen species (t-BuN)₂N₄Me₄ which has a nido-N₂B₄ framework. The attempted synthesis of the nitrogen analogue of 1 or 2 by using a similar approach did not result in the isolation of [PhN(BNMe₂)₂]₂, instead the tetramino diborane(4) species [B(NMe₂)NHPh]₂ ( 3 ), which has a structure similar to other tetramine diborane(4) compounds, was isolated.     

Zur Struktur zweier Arsen- und Antimontricarboxylate

Zusammenfassung Arsen-tris(2,2-dimethylpropionat) (1) kristallisiert monoklin in der Raumgruppe P2₁/n mita=926.2,b=2158.6,c=983.7 pm, =94.92° undZ=4. As hat gegenüber O die Koordinationszahl 3+3. Antimontripropionat (2) kristallisiert monoklin in der Raumgruppe P2₁/c mita=930.2,b=863.0,c=1575.2 pm, =90.27 undZ=4. Die Moleküle sind intermolekular zu Ketten verknüpft, wodurch Sb die Koordinationszahl 3+3 (+3) erreicht.

---

Structure of arsen(III) and antimony(III) carboxylates

Summary Arsen-tris(2,2-dimethylpropionate) (1) crystallizes monoclinic in the space group P2₁/n witha=926.2,b=2158.6,c=983.7 pm, =94.92°, andZ=4. As has a coordination number of 3+3. Antimony tripropionate (2) crystallizes monoclinic in the space group P2₁/c witha=930.2,b=863.0,c=1575.2 pm, =90.27, andZ=4. The molecules are bridged to chains; therefore, Sb reaches the coordination number 3+3 (+3).

     

Photoelectron core levels for enargite,Cu3AsS4

The mineral chemistry of enargite surfaces and near‐surfaces prepared by fracture within an ultrahigh vacuum are investigated using XPS and synchrotron radiation XPS (SRXPS). The purpose of the study is to identify surface core‐level line positions in high‐resolution photoelectron spectra. The XPS spectra obtained using monochromatic Al Kα radiation show that there are near‐identical monosulphide line positions in S 2p spectra for the As–S and Cu–S bonds in enargite. The SRXPS spectra for sulphur are remarkably similar to the XPS spectra for sulphur, showing that there is minimal difference in the chemical environment between sulphur atoms at the surface and in the mineral matrix. The Cu 2p XPS data have only cuprous contributions and a minor surface contribution. The surface Cu contribution is observed as a high‐binding‐energy tail in the Cu 2p_3/2 spectrum. The As 3d data for both XPS and SRXPS show contributions from arsenic atoms at the surface and in the bulk mineral matrix. The surface contribution is distinct and is found 1 eV below the bulk contribution. The results of the study suggest that, following fracture, the enargite surface is reorganized in such a manner that the surface is characterized by protrusions of individual arsenic atoms. Copyright © 2004 John Wiley & Sons, Ltd.     

Cathodic deposition of ternary In+As+Sb alloys and formation of InAsxSb1−x

In+As+Sb alloys have been deposited onto Ni and Ti cathodes from tartaric acid solutions at pH 2. Homogeneous deposits of composition suitable for achieving InAs_xSb_1−x can be obtained from this medium. The As-to-Sb ratio can be controlled by properly selecting solution composition and deposition potential.X-ray photoelectron spectroscopy and X-ray diffraction analyses show that formation of III–V compounds occurs at room temperature. In reacts preferentially with As rather than with Sb, but crystalline phases formed at room temperature are Sb-rich. After annealing the In+As+Sb alloys at 250°C, the composition calculated from cell parameters appears similar to that measured by energy-dispersive X-ray analysis, suggesting that the entire deposit has been converted into the InAs_xSb_1−x crystalline phase.     

Study on the electronic structure and optical properties of different Al constituent Ga1−xAlxAs

Using quantum mechanics GASTEP software package based on the first principle density function theory, the electronic structure and optical properties of Ga_1−xAl_xAs at different Al constituent are calculated. Result shows that with the increase of Al constituent, the band gap of Ga_1−xAl_xAs increases and varies from direct band gap to indirect band gap; the absorption band edge and the absorption peak move to high-energy side; the static reflectivity decreases. With the increasing of the incident photon energy, Ga_1−xAl_xAs shows metal reflective properties in certain energy range. With the increasing of Al constituent, static dielectric constant decreases and the intersection of dielectric function and the x-axis move towards high-energy side; the peak of energy loss function move to low-energy side and the peak value reduces.     

Distribution of arsenic species in environmental samples collected in Northern Chile

Gradient ion chromatographic separation coupled with ICP-MS was used to resolve and determine the most common arsenic species in environmental and biological samples of carrots, trout, soil, sediment and river water from Region II of Chile. The carrot and trout samples showed a concentration of 49 and 168 µg g^?1, respectively, of total As. Both concentrations are high considering the basal level. In the carrots, percentage of 45 and 31% of total As were found for As(III) and As(V) species, respectively. In the trout, the higher concentration related to AsB at 39% of the total As. As(III) and DMA were also present in relatively high concentrations. The River Loa and the soil in which the carrots are growing also present very high As(V) concentrations of 100 and 17 µg g^?1, respectively. The ratio between the concentration for the same As species found in the living organisms (carrots and trout) and the environment in which they grow (soil and water) can provide important information about the possible absorption or biotransformation of As species in living beings. As(III) and DMA are the species in which the greatest accumulation occurs with respect to the medium in which they are present, and biotransformation also appears to take place.     

Determination of As(III) using developed dispersive liquid–liquid microextraction and flame atomic absorption spectrometry

The method relies on selective complexation of As(III) with a suitable chelating agent followed by dispersive liquid–liquid microextraction (DLLME) method. Flame atomic absorption spectrometry (FAAS) equipped with microsample introduction system was utilised for determination of As(III). 1-Undecanol and acetone were used as extraction solvent and disperser solvent respectively. Some effective parameters on complex formation and extraction have been optimised. Under the optimum conditions, the enrichment factor of 108 for As(III) was obtained from 9.8?mL of water samples. The calibration graph was linear in the range of 2–15?µg?L^?1 with detection limits of 0.60?µg?L^?1 for As(III). The relative standard deviation (R.S.D.) for ten replicate measurements of 5.00?µ?gL^?1 of As(III) was 6.2%. Operation simplicity and high enrichment factors are the main advantages of DLLME for the determination of As(III) without necessity for hydride generation in water samples.