Chelating Metal Ions in a Metal-Organic Framework for Constructing a Biomimetic Catalyst Through Post-modification

Crystal engineering, as a burgeoning technology, has been widely used to construct metalloporphyrins biomimetic catalysts. Herein, a bimetallic metal-organic framework (MOF) was constructed by 4-(4-carboxyphenyl)-1,2,4-triazole ligand, Co²⁺ and Zr⁴⁺ metal ions by solvothermal reaction(named PFC-88). A N,N-chelation site was found between the two adjacent ligands in PFC-88, consequently a porphyrin-like structure was obtained through chelating Fe³⁺ in this site by post-modification, named PFC-88-Fe. The result of a single crystal X-ray technology verified that Fe ions were successfully metalated in the N,N-chelation site of PFC-88, which is assisted by the X-ray absorption near-edge structure(XANES) spectra. An o-phenylenediamine oxidation reaction was applied to assessing the catalytic activity of PFC-88-Fe, in which the absorbance increases of phenazine-2,3-diamine at λ=418 nm were recorded by absorption spectroscopy in kinetic mode, exhibiting the application potential as a biomimetic catalyst.     

Green synthesis and characterization of Tb-Fe-O-Cu ceramic nanocomposite and its application in simultaneous electrochemical sensing of zinc,cadmium and lead

In this work, a green technique for preparing TbFeO₃/CuO was reported by employing Crataegus and Lantana Camara leaves as fuel and alkalizing agents, respectively. The new sensor based on the perovskite-type nanocomposite was employed as a sensitive and selective platform to detect Pb(II), Zn(II) and Cd(II) simultaneously. TbFeO₃/CuO/Carbon paste electrode (CPE) exhibited a large specific surface area and great electrical conductivity, which enhanced electron transport in the electrochemical process considerably. Moreover, square wave anodic stripping voltammetry (SWASV) was used for the investigation of some factors influencing the sensor sensitivity like pH, modifier concentration, as well as accumulation time and potential. Therefore, the low detection limit (LOD) and a wide linear range were obtained at optimum conditions. In this study, a linear range between 0.9 and 110 µg/L for three ions and LOD of 0.48, 0.29 and 0.12 for zinc, cadmium and lead were achieved, respectively. Moreover, TbFeO₃/CuO/CPE was employed to detect zinc, cadmium and lead ions simultaneously in the real samples so that the results have shown consistency with a standard inductively coupled plasma (ICP).     

以磷化铁为添加剂沿(111)面生长磷掺杂金刚石大单晶

掺杂是调控金刚石性能的一种重要手段。本文采用温度梯度法,在5.6 GPa、1 312 ℃的条件下,选用Fe₃P作为磷源进行磷掺杂金刚石大单晶的合成。金刚石样品的显微光学照片表明,随着Fe₃P添加比例的增加,金刚石晶体的颜色逐渐变深,包裹体数量逐渐增加,晶形由板状转变为塔状直至骸晶。金刚石晶形的变化表明Fe₃P的添加使生长金刚石的V形区向右偏移,这是Fe₃P改变触媒特性的缘故。红外光谱分析表明,Fe₃P的添加使金刚石晶体中氮含量上升,这说明磷的进入诱使氮原子更容易进入金刚石晶格中。激光拉曼光谱测试表明,随着Fe₃P添加比例的增加,所合成的掺磷金刚石的拉曼峰位变化不大,其半峰全宽(FWHM)值变大,这说明磷的进入使得金刚石晶格畸变增加。XPS测试结果显示,随着Fe₃P添加比例的增加,金刚石晶体中磷相对碳的原子百分含量也会增加,这意味着添加Fe₃P所合成的金刚石晶体中有磷存在。     

Terahertz generation in quantum cascade structures by two-color deriving fields: An approach to reach inversion population via optical pumping

In this paper, a quantum cascade laser (QCL) design is proposed based on GaAs/AlGaAs material system, which simultaneously operates at three widely separated wavelengths (${\lambda }_1=11.1\mu m,{\lambda }_2=14.1\mu m$ and ${\lambda }_{THz}=60\mu m$). In the design, all the wavelength radiations are achieved by the engineering of the electronic spectrum via the quantum-well widths and the applied electric field in a single active region within a same waveguide. The mid-infrared (mid-IR) wavelengths are obtained by adoption a dual-upper-state active region, and the proposed design aims to use both the mid-IR radiations as the coherent deriving fields to populate the upper THz lasing state to aid the THz-laser population inversion via optical pumping instead of direct electrical injection. A detailed analysis of electronic transport in the structure is carried out using a multi-level rate-equation model. The results show that the proposed structure offers an alternative approach to room temperature THz generation in QCLs.     

材料表征方法理论与实践课程的改革与建设*

通过与超星专业慕课制作团队合作搭建网络教学平台,将线上慕课教学与线下实验教学相结合,对材料表征方法理论与实践课程进行了全方位的改革。与传统实验教学相比,改革后的课程不仅能够激发学生的学习兴趣,实现时间空间的相对自由,还可以完善考核机制,提升教学质量,从而为高校化学研究生实验课程的改革提供一定的借鉴意义。     

Effect of oxygen on regulation of properties of moderately boron-doped diamond films

Regulation of oxygen on properties of moderately boron-doped diamond films is fully investigated. Results show that, with adding a small amount of oxygen (oxygen-to-carbon ratio < 5.0%), the crystal quality of diamond is improved, and a suppression effect of residual nitrogen is observed. With increasing ratio of O/C from 2.5% to 20.0%, the hole concentration is firstly increased then reduced. This change of hole concentration is also explained. Moreover, the results of Hall effect measurement with temperatures from 300 K to 825 K show that, with adding a small amount of oxygen, boron and oxygen complex structures (especially B₃O and B₄O) are formed and exhibit as shallow donor in diamond, which results in increase of donor concentration. With further increase of ratio of O/C, the inhibitory behaviors of oxygen on boron leads to decrease of acceptor concentration (the optical emission spectroscopy has shown that it is decreased with ratio of O/C more than 10.0%). This work demonstrates that oxygen-doping induced increasement of the crystalline and surface quality could be restored by the co-doping with oxygen. The technique could achieve boron-doped diamond films with both high quality and acceptable hole concentration, which is applicable to electronic level of usage.     

Application of advanced nuclear analytical techniques for the electrocatalyst's characterization: Paving the path for mechanistic investigations

As the application of electrocatalyst continues to expand, envisaging the hidden mechanisms occurring at various length scale affecting the catalytic efficiency became important. To enhance the stability of electrocatalyst and reduce the cost, it is of paramount importance to reveal the active site's dynamics (using in situ techniques for getting the real-time information) which directly affect the reactions such as oxygen evolution reaction, hydrogen evolution reaction, and so on. Since such reactions are crucial for many engineering and scientific applications, in situ characterization techniques are required, which could capture such reactions happening at a different length and time scale. This article analyzes the recent progress made in the field of electrocatalyst's characterization using in situ neutron techniques. The article also paves the future path and has delineated the future challenges involved in multiscale correlative techniques (e.g., neutron techniques in the combination of synchrotron or microscopic techniques) used for getting the multiscale (atomic to micrometer range) mechanistic information about the electrocatalyst's working and degradation.     

基于TOPSIS模型的机场网络节点重要度评估

在机场网络中单个机场节点的失效往往会对其他的节点产生影响,特别是关键节点的失效会波及整个网络.准确客观的识别重要节点机场关乎整个机场网络的安全运营.本文分析了机场网络拓扑特性中的度、集聚系数和接近度指标,考虑了机场旅客吞吐量和所在城市人口等交通经济特性指标,使用熵权法确定权重的基础上,应用TOPSIS法构建综合评价体系模型,最后以华东地区机场网络为例进行节点重要度排序.结果表明与单一指标的评估结果相比,该方法更加全面客观的确定不同属性指标的权重,避免了不同指标取值的差异性,使评价更加全面,更符合机场网络实际运营情况.