非晶调制多层膜Nb/Si中的互扩散研究

利用原位Ｘ射线衍射技术得到非晶调制多层膜Ｎｂ／Ｓｉ中的互扩散系数与退火温度的关系，调制周期Ｌ＝３.２ｎｍ的非晶调制多层膜是用粒子溅射方法制备的．温度范围为４２３—５２３Ｋ的有效互扩散系数通过原位测量多层膜的一级调制峰强度与退火温度之间的关系而得到．利用缺陷陷阱延迟扩散机制解释了所得到的扩散系数与退火温度的关系．建立了可以解释较小前置系数的模型 关键词：     

坩埚下降法生长的LiNbO3,Fe:LiNbO3,Zn:Fe:LiNbO3单晶的吸收光谱特性

用紫外可见光谱(UV／Visible Spectra)测试并研究了坩埚下降法生长的LiNbO3、Fe：LiNbO3，以及Zn：Fe：LiNbO3晶体的吸收特性。分析了产生这些吸收特性的原因以及与工艺生长方法的内在联系。研究结果表明：LiNbO3单晶沿晶体生长方向，其紫外吸收边向长波方向移动，且在350—450nm波段的吸收也逐渐增大，这是由于Li的分凝与挥发，逐渐产生缺锂所造成的；在Fe：LiNbO3单晶中观察到Fe^2 离子在480nm附近的特征吸收峰，并发现沿生长方向，Fe^2 离子的浓度逐渐增加，这与提拉法生长得到的晶体不同；在Fe：LiNbO3单晶中掺入质量分数为1．7％ZnO后，吸收边位置发生蓝移，而掺杂质量分数达到3．4％时，观察到有红移现象。Fe^2 离子在Zn：Fe：LiNbO3单晶中的浓度与ZnO掺杂量有密切关系。在掺杂质量分数1．7％ZnO的Fe：LiNbO3单晶中，Fe^2 离子从底部到顶部的浓度变化比在掺杂质量分数3．4％ZnO晶体中大，这是由于Zn^2 抑制Fe^2 离子进入Li位的能力随掺杂量的增加而逐渐减弱造成的。就该下降法工艺技术对Fe^2 离子在晶体中的浓度分布的影响作了分析。     

High-Average-Power Nanosecond Quasi-Phase-Matched Single-Pass Optical Parametric Generator in Periodically Poled Lithium Niobate

A pulsed nanosecond optical parametric generator (OPG) in periodically poled lithium niobate (PPLN) crysal is presented. The pump laser is an acousto-optically Q-switched Nd:YVO4 laser with the maximum average power of 6.58 W. When the repetition rate is 50kHz and the pulse width of the pump source is 80ns, the maximum average total output power of the single-pass PPLN OPG is about 1.9 W, which includes 1.322 W of 1.536μm signal radiation. The length of the PPLN crystal is only 38.7mm (at room temperature) with a grating period of 28.93μm (at room temperature). The 1.502-1.536μm signal radiation and 3.652-3.465μm idler radiation are obtained by adjusting the PPLN crystal temperature from 155℃ to 250℃.     

具有高机械强度的掺Er~(3 )∶TeO_2-Nb_2O_5玻璃的光谱性质研究

熔制了掺铒碲铌玻璃样品(100-X)TeO2-XNb2O5(X=5,10,15,20mol%),测试了其密度、折射率、转变温度、析晶温度、维氏机械强度、吸收光谱、荧光光谱、荧光寿命等参量。利用Judd-Ofelt和McCumber理论分别计算了铒离子强度参量Ωt(t=2,4,6)和受激发射截面σemi的大小,研究了掺铒碲铌玻璃样品光谱参量对Nb2O5成分的依赖性,并与典型的碲锌钠玻璃(75TeO2-20ZnO-5Na2O)在热学、机械强度、光谱性质和放大品行四个方面进行了比较.     

Pseudo-Spin-Valve Trilayer Using Amorphous CoNbZr Layer： Giant Magnetoresistance, Domain Structures and Potentials for Spin-Electronic Devices

We propose a pseudo-spin-valve (PSV) trilayer using amorphous CoNbZr Mloy for soft magnetic layers. The giant magnetoresistance (GMR), domain structures and their variation upon thermal annealing are investigated. The GMR effect is not only stable up to 300℃ but also enhanced due to the improvement of the interfaces between Cu and magnetic layers. With high annealing temperature, the magnetoresistance (MR) ratio decreases rapidly as a result of serious layer interdiffusion. Dense stripe domains, which disappear after annealing at 300℃ for 1h, are observed in the sandwiched films. It is found that after patterning to elliptic stripe with aspect ratio of 6:1, the trilayers have a single domain and their MR ratio increases. The dynamic MR behaviour under an ac magnetic field indicates that the patterned stripes have good linear MR responses. Therefore, it is believed that the CoNbZr/Cu/Co PSV trilayers have strong potentials for spin-electronic devices including magnetic random access memory.     

SnO2-Nb2O5/MgAl2O4/α-Al2O3催化环氧乙烷水合制乙二醇

采用水热稳定的MgAl2O4尖晶石对-αAl2O3载体表面进行修饰,采用具有较强亲水性能的SnO2对活性组分Nb2O5进行修饰,制备了SnO2-Nb2O5/MgAl2O4/-αAl2O3催化剂,并用于环氧乙烷水合制乙二醇反应.采用X射线衍射、红外光谱和程序升温脱附研究了Sn/Nb摩尔比对催化剂酸性、环氧乙烷在催化剂表面的吸附状态和吸附强度以及催化剂性能的影响.结果表明,Sn/Nb摩尔比明显影响催化剂的组成和结构;催化剂的结构不同,环氧乙烷在催化剂表面的吸附强度存在明显差别,催化剂的催化性能明显不同.