全文获取类型
收费全文 | 138篇 |
免费 | 56篇 |
国内免费 | 16篇 |
专业分类
化学 | 53篇 |
晶体学 | 45篇 |
力学 | 16篇 |
综合类 | 9篇 |
数学 | 2篇 |
物理学 | 85篇 |
出版年
2023年 | 1篇 |
2022年 | 3篇 |
2020年 | 3篇 |
2019年 | 1篇 |
2018年 | 4篇 |
2017年 | 5篇 |
2016年 | 14篇 |
2015年 | 1篇 |
2014年 | 8篇 |
2013年 | 5篇 |
2012年 | 3篇 |
2011年 | 2篇 |
2010年 | 3篇 |
2009年 | 6篇 |
2008年 | 23篇 |
2007年 | 19篇 |
2006年 | 12篇 |
2005年 | 25篇 |
2004年 | 14篇 |
2003年 | 11篇 |
2002年 | 3篇 |
2001年 | 9篇 |
2000年 | 5篇 |
1999年 | 2篇 |
1998年 | 3篇 |
1997年 | 4篇 |
1996年 | 3篇 |
1995年 | 2篇 |
1994年 | 4篇 |
1993年 | 6篇 |
1992年 | 1篇 |
1991年 | 3篇 |
1990年 | 1篇 |
1988年 | 1篇 |
排序方式: 共有210条查询结果,搜索用时 15 毫秒
1.
Cr靶电流对Cr改性类石墨薄膜摩擦磨损性能的影响 总被引:2,自引:0,他引:2
采用闭合场非平衡磁控溅射离子镀设备,在不同Cr靶电流参数下制备Cr改性类石墨薄膜,测试了薄膜的硬度、结合强度、摩擦系数和比磨损率,采用扫描电子显微镜和透射电子显微镜观察薄膜的显微结构.结果表明:改变Cr靶电流不仅能够改变薄膜的化学成分,而且能够改变薄膜的显微结构;随着Cr靶电流增加,薄膜的断口出现纤维状结构,并逐渐发展为柱状结构;Cr的加入使得类石墨薄膜形成周期性层状结构;在干摩擦条件下,随着Cr靶的电流增加,GLC膜的摩擦系数先减小而后增大;当载荷较小时,薄膜的比磨损率随Cr靶电流的增加而增大,载荷较大时薄膜的比磨损率变化不大.化学成分和显微结构的变化引起GLC膜硬度和韧性的变化,从而改变了薄膜的摩擦磨损性能. 相似文献
2.
将Mg粉、Zr粉和B粉按比例混合获得Mg1-xZrxB2(x=5%10%和20%),压制成型后,在流通氩气的条件下于800℃烧结2h.利用X射线衍射仪(XRD)、扫描电子显微镜(SEM)分析烧结后样品的显微结构和化学组成,采用差热分析(DTA)观察Zr掺杂对MgB2分解温度的影响,并用物性测试仪(PPMS)测试样品的超... 相似文献
3.
研究了硼酸钙掺量对电瓷的相结构、显微结构、电气性能和机械性能的影响。通过不同硼酸钙添加量的电瓷在不同烧结温度条件下的断裂强度、气孔率、电阻率,结合电瓷的晶相结构和显微结构的变化,探讨其构效关系。结果表明:硼酸钙含量的增加或烧结温度升高,电瓷的电阻率和气孔率降低。但当硼酸钙掺量超过10%,烧结温度超过1120℃之后,电阻率和气孔率的变化不明显。电瓷的断裂强度随着硼酸钙的添加而提高,当硼酸钙含量超过10%后开始降低,添加量为10%时电瓷的断裂强度随着烧结温度而提高,1120℃后无显著变化。硼酸钙促进莫来石相的析出,但硼酸钙含量过高时,会促进CaAl_2Si_2O_8形成,降低莫来石相的析出量,并使其形貌从细针状向短柱状和粒状发生转变。硼酸钙掺量恒定时,提高烧结温度可促进细针状莫来石相的生成。 相似文献
4.
用固相反应和高能球磨合成后续热处理两种方法分别得到钙钛矿结构Nd0.7Sr0.3MnO3氧化物.两种不同方法得到的多晶样品,虽然晶体结构相同,化学成分和晶粒大小相近,但它们电输运性质却表现出很大差异.用固相反应法制得的样品的电阻几乎不随负载电流的变化而变化,即不表现电致电阻行为;而通过高能球磨合成后续热处理方法得到的样品电阻随外加电流增大而急剧减小,出现显著电致电阻效应.产生这种截然不同电输运特性的原因可能与样品的显微结构和界面性质有关.
关键词:
电致电阻效应
显微结构
钙钛矿结构锰氧化物
界面电阻 相似文献
5.
Microstructure and Optical Properties of AgxO Prepared by Direct-Current Magnetron-Sputtering Method 下载免费PDF全文
Two series of AgxO films are prepared on glass substrates by dc magnetron-sputtering method at room temperature and 90℃ under different oxygen to argon gas ratio (OAR) conditions. The mierostrueture is investigated by XRD and SEM in order to obtain the information on the component evolution of AgO+Ag2O to Ag2O. Its optical properties are investigated by reflectance and absorption spectroscopy to extract the information on metallic and dielectric behaviour evolution of Ag2O, AgO and silver particles and the interband transition. The results indicate that the AgxO film prepared at room temperature is mainly made up of AgO and Ag2 O clusters while Ag2O is the primary component of AgxO prepared at 90℃. The AgxO film mainly consisting of the primary component shows indirect interband transition structure occurring at 2.89eV. Combination of increasing OAR and substrate temperature is an effective method to lower the threshold of thermal decomposition temperature of AgxO and to deal with the bottleneck of short-wavelength optical and magneto-optieM storage. 相似文献
6.
7.
Due to the low absorption contrast of plant tissues, traditional x-ray radiography has not been included in the microscopic techniques used in the identification of traditional Chinese medicines (TCMs). With the development of x-ray phase contrast imaging (XPCI) in recent years, weakly absorbing materials could also be imaged by x- rays. Here we investigate microstructures of TCMs utilizing XPCI based on a nano-focus x-ray tube. The results demonstrated that XPCI is capable of revealing the microstructures of TCMs used as judging criteria in the identification of TCMs. The major advantages of the new method are nondestructivity, no special demand for sample preparation and suitability for thick samples. 相似文献
8.
以相位光栅为实验对象,开展了基于数字显微全息技术的相位物体三维显微结构信息的再现研究.在Mach-Zender透射式实验系统的基础上,分别采用显微物镜和无透镜放大方式,对相位光栅进行放大,以提高系统横向分辨率.在显微物镜放大系统中,菲涅耳近似数值再现算法与双波长技术相结合,抑制主要系统噪音,获得相位光栅的显微结构三维分布.在无透镜放大数字显微全息系统中,分别利用菲涅耳近似法和卷积方法再现原始物波前,并提出相减法消除系统主要球面误差,获得相位光栅的深度信息.实验结果与Veeco干涉仪测试结果比对表明,光栅周期和深度结构与干涉仪测试数据相符. 相似文献
9.
采用体视显微镜和偏光显微镜,对比观察了耀州窑北宋青瓷白色中间层和唐代、五代青瓷化妆土之间的微观结构.结果显示,在体视显微镜下中间层和化妆土层均为白色薄层,但在偏光显微镜下明显可见化妆土层,未见中间层.并探讨了这些现象与二者的化学组成和形成机理的关系. 相似文献
10.