Research and application of coupled two-dimensional asymmetric bistable stochastic resonance system

Considering that the vibration signal of rolling bearing is very weak and difficult to be extracted under the working environment noise, a two-dimensional asymmetric bistable system (TDAB) is proposed. The system is coupled by two systems, and the weak signal is enhanced by adjusting the control system (monostable system) to adjust the controlled system (asymmetric bistable system). First, under the condition of adiabatic approximation system, the signal-to-noise ratio (SNR) is deduced, and analyzes the influence of different system parameters on the shape of potential function. Then the effects of each parameter on the SNR of the system are analyzed theoretically. Finally, combined with the adaptive intelligent algorithm, the parameters of the controlled system are optimized, and then the coupling coefficient and control system parameters are adjusted to obtain better system performance. The TDAB system obtained is applied to different bearing fault diagnosis and compared with different coupling systems. The experimental results show that the method can extract the characteristic frequency effectively and has good spectrum amplification performance and anti-noise capability. It is proved that the TDAB system can also have good detection effect in practical application.     

Rational Design of a Near-infrared Fluorescent Material with High Solid-state Efficiency,Aggregation-induced Emission and Live Cell Imaging Property

Near-infrared(NIR) fluorescent materials with high photoluminescent quantum yields(PLQYs) have wide application prospects. Therefore, we design and synthesize a D-A type NIR organic molecule, TPATHCNE, in which triphenylamine and thiophene are utilized as the donors and fumaronitrile is applied as the acceptor. We systematically investigate its molecular structure and photophysical property. TPATHCNE shows high T_gof 110℃ and T_d of 385℃ and displays an aggregation-induced emission(AIE) property. A narrow optical bandgap of 1.65 eV is obtained. The non-doped film of TPATHCNE exhibits a high PLQY of 40.3% with an emission peak at 732 nm, which is among the best values of NIR emitters. When TPATHCNE is applied in organic light-emitting diode(OLED), the electroluminescent peak is located at 716 nm with a maximum external quantum efficiency of 0.83%. With the potential in cell imaging, the polystyrene maleic anhydride(PMSA) modified TPATHCNE nanoparticles(NPs) emit strong fluorescence when labeling HeLa cancer cells, suggesting that TPATHCNE can be used as a fluorescent carrier for specific staining or drug delivery for cellular imaging. TPATHCNE NPs fabricated by bovine serum protein(BSA) are cultivated with mononuclear yeast cells, and the intense intracellular red fluorescence indicates that it can be adopted as a specific stain for imaging.     

Double Gaussian potential stochastic resonance method and its application in centrifugal fan blade crack detection

Stochastic resonance (SR) has been extensively utilized in the field of weak fault signal detection for its characteristic of enhancing weak signals by transferring the noise energy. Aiming at solving the output saturation problem of the classical bistable stochastic resonance (CBSR) system, a double Gaussian potential stochastic resonance (DGSR) system is proposed. Moreover, the output signal-to-noise ratio (SNR) of the DGSR method is derived based on the adiabatic approximation theory to analyze the effect of system parameters on the DGSR method. At the same time, for the purpose of overcoming the drawback that the traditional SNR index needs to know the fault characteristic frequency (FCF), the weighted local signal-to-noise ratio (WLSNR) index is constructed. The DGSR with WLSNR can obtain optimal parameters adaptively, thereby establishing the DGSR system. Ultimately, a DGSR method is proposed and applied in centrifugal fan blade crack detection. Through simulations and experiments, the effectiveness and superiority of the DGSR method are verified.     

基于三维荧光光谱法和PARAFAC对多环芳烃定性定量分析

三维荧光光谱法在研究多环芳烃(PAHs)类物质的荧光信息时起到了重要作用。多环芳烃类物质具有致癌性,难降解性,多由尾气排放,垃圾焚烧产生,危害着人类健康及环境,因此人们不断探索对多环芳烃检测的方法。实验选取多环芳烃中的苊和萘作为检测物质,利用FLS920荧光光谱仪,为避免荧光光谱仪本身产生的瑞利散射影响,设置起始的发射波长滞后激发波长40 nm,设置扫描的激发波长(λex)范围为:200~370 nm,发射波长(λem)范围为:240~390 nm,对多环芳烃进行荧光扫描获取荧光数据,采用三维荧光光谱技术结合平行因子算法对混合溶液中的苊和萘进行定性定量分析。实验选用的苊和萘均购于阿拉丁试剂官网,配制浓度为10 mg·L-1的一级储备液,再将一级储备液稀释,得到苊和萘浓度为0.5,1,1.5,2,2.5,3,3.5,4和4.5 mg·L-1的二级储备液,并将苊和萘进行混合。在进行光谱分析前需要对苊和萘的光谱进行预处理,采用空白扣除法扣除拉曼散射的影响,并采用集合经验模态分解(EEMD)消除干扰噪声。实验测得苊存在两个波峰,位于λex=298 nm,λem=324/338 nm处,萘存在一个波峰,位于λex=280 nm,λem=322 nm处。选用的PARAFAC算法对组分数的的选择很敏感,因此采用核一致诊断法预估组分数,估计值2和3的核一致值都在60%以上,分别对混合样品进行了2因子和3因子的PARAFAC分解,将分解后得到的激发发射光谱数据和各组分浓度数据进行归一化处理,并绘制光谱图,与归一化处理后的真实的激发发射光谱图和各组分浓度图进行对比。同时将PARAFAC得到的混合样本的预测浓度,通过计算回收率(R)和均方根误差(RMSEP)来判定定量分析的准确度。选择2因子时,各混合样品中苊和萘拟合度为95.7%和96.7%,平均回收率分别为101.8%和98.9%,均方根误差分别为0.0187和0.0316;选择3因子时,各混合样品中苊和萘拟合度为95.3%和95.8%,平均回收率分别为97%和102.5%,均方根误差分别为0.033和0.116,由三项指标可得选用2因子进行定性定量分析的效果明显好于选用3因子。分析实验结果表明,基于三维荧光光谱法和PARAFAC算法对混合样品进行定性定量分析,能够有效的判定混合样品的类别,同时能够成功的预测出混合样品的浓度。     

电枢膛内高速运动控制仿真与试验

电磁轨道发射的过程中，电枢在膛内高速运动时会受到电磁力、电枢初始正压力、摩擦力、空气阻力、烧蚀阻力等多种因素影响，电枢的出口速度呈现出在一定范围内波动的特征。为了提高电枢的出口速度精度，针对膛内电枢与轨道摩擦不均衡性和烧蚀程度不确定的特性，综合考虑脉冲成形网络的电路模型与电枢的动力学特征，建立了电枢在膛内的运动开环控制仿真模型。通过仿真，得出了脉冲电源模块触发时刻与电枢出口速度之间的关系，提出了电枢出口速度闭环控制模型，探究了电枢出口速度控制可行方案。结果表明:应用闭环控制算法，可实现对电枢出口速度的精确控制。     

消光式核壳二聚体传感器的设计与光谱特性分析

根据ITO/Au纳米核壳二聚体粒子在生物医学领域的应用合理性,设计了一种实时检测生物液体的核壳二聚体探针消光式传感器;由偶极子理论推导出输出波长与外界环境折射率关系;利用MATLAB设计ITO/Au纳米核壳二聚体粒子结构;采用软件DDSCAT7.3结合离散偶极近似法,利用二聚体有效半径模拟计算了300~950nm可见光到红外光波段不同核壳比、二聚体间距、以及不同介质折射率的消光光谱;根据传感芯片折射率与偶极共振、耦合八级共振的响应关系得出ITO/Au二聚体的折射率灵敏特性。与传统Ag/Au核壳纳米粒子相比,ITO/Au纳米核壳二聚体结构引入了可作为传感芯片灵敏性自参考参数的耦合八级共振峰,同时ITO/Au二聚体结构的折射率灵敏度可达到419nm/RIU。这些工作及其结果对制作消光式传感器具有重要的意义。     

TBOR-shaped electro-optic modulator with dual output based on double-layer graphene

We proposed an electro-optic modulator with two-bus one-ring (TBOR) structure to improve the extinction ratio and reduce insert loss. It has a dual output compared with one-bus one-ring structure. In addition, double-layer graphene makes it possible for the modulation in the visible to mid-infrared wavelength range. It shows that this new electro-optic modulator can present two switching states well with low insertion loss, high absorption and high extinction ratio. At $\lambda =1550\text{ nm}$, when the switching states are based on the chemical potential, ${\mu }_{\mathrm{c}}=0.38\text{ eV}$ and ${\mu }_{\mathrm{c}}=0.4\text{ eV}$, the insertion losses of both output ports are less than 2 dB, the absorption of the output port coupled via a micro-ring reaches 45 dB and the extinction ratio reaches 14 dB. When the refractive index of the dielectric material is 4.2, the applied voltage will be less than 1.2 V, thus can be used in low-voltage CMOS technology.     

Effects of van der Waals force on nonlinear vibration of electromechanical integrated electrostatic harmonic actuator

An electromechanical integrated electrostatic harmonic actuator is promising for the miniaturization of electromechanical devices. As the dimensions of the actuator decrease, the effects of the van der Waals force become obvious. In this study, by considering the nonlinearity of electrostatic and van der Waals forces, nonlinear vibration equations of the flexible ring of an electrostatic harmonic actuator are deduced. Using these equations, the nonlinear free vibration and nonlinear forced response of the actuator are investigated. The effects of the van der Waals force on the nonlinear vibration of the flexible ring are analyzed. Results show that these effects of the van der Waals force are relatively obvious under some conditions and should be considered.