光致变色二芳基乙烯抗疲劳特性实验研究

提出了一种简单直观的方法研究光致变色材料二芳基乙烯/PMMA膜的抗疲劳特性.通过测量样品在漂白和呈色过程中探测光的透过率,分析该样品光致变色过程的最佳曝光量,在此基础上测量样品的抗疲劳特性.结果显示:在漂白和呈色过程中,激发红光和紫光的最佳曝光量为分别为1 900 J/cm2和600 mJ/cm2,表明该材料对红光不敏感,对紫光比较敏感.定义漂白-呈色过程中,探测光透过率稳定值差下降为第一次循环的50%时样品已经疲劳.通过交替的漂白-呈色循环,测得这种二芳基乙烯材料的擦写次数为27次.     

氧化硅负载的固体碱上乙醛的气相缩合反应

在氧化硅负载的含碱金属固体碱催化剂上乙醛能有效地缩合生成丁烯醛及丁烯醇，反应具有中等转化率，较好的造反性，和稳定性，考究了不同反应条件对催化性能的影响，并对可能的反应生相进行了探讨。     

纳米晶PbTiO3负载CuO催化NO分解

A large specific surface area perovskite-type mixed oxide PbTiO₃ supported cupric oxide was synthesized as a catalyst for NO decomposition and characterized by techniques such as XPS, XRD, H₂-TPR before and after NO decomposition reactions. The catalytic properties were tested with a fix-bed micro-reactor. The results showed that the PbTiO₃ was inactive for the reactions, but 1wt % Cu/PbTiO₃ catalyst gave fairly good activities for NO decomposition at temperature as low as 473 K. Copper species were found well-dispersed but weakly interacted with the support before NO decomposition, and the NO decomposition caused significant change in the environment of the copper species, which became Cu(Ⅰ) and most probably incorporated into surface crystal lattice of the nano-sized PbTiO₃. In NO reaction, a large amount of oxygen atoms from the decomposition of NO penetrated into the nano-sized PbTiO₃ support and caused small expansion of crystal lattice. The transport of oxygen between the copper species and the catalyst support may be helpful to speed up the kinetic regeneration of active metal sites from oxygen occupancy and resulted in good catalytic performance.     

CuO/γ-Al2O3单分散催化剂的XAFS研究

采用XAFS方法研究浸渍法制备并于低温焙烧的CuO/γ-Al2O3催化剂的局域结构.对于CuO负载量小于单层分散阈值的CuO/γ-Al2O3(0.4mmol/100m2),结果表明,CuO物种是以层状分散的孤立原子簇存在于γ-Al2O3载体表面,其第一近邻Cu-O配位环境的结构与晶态CuO的相似,键长和配位数分别为0.195nm和4.对于CuO负载量等于单层分散阈值的CuO/γ-Al2O3(0.8mmol/100m2),已有少量的CuO纳米颗粒生成.对于CuO负载量大于单层分散阈值的CuO/γ-Al2O3(1.2mmol/100m2),其结构与多晶CuO的相近.基于CuO在γ-Al2O3载体上的三种不同分散状态的结构特点,我们提出了CuO/γ-Al2O3催化剂的结构模型.     

Dispersion state and catalytic properties of vanadia species on the surface of V_2O_5/TiO_2 catalysts

The dispersion state and catalytic properties of anatase-supported vanadia species are studied by means of X-ray diffraction (XRD), laser Raman spectroscopy (LRS), H2 temperature-programmed reduction (TPR) and the selective oxidation of o-xylene to phthalic anhydride. The almost identical values of the experimental dispersion capacity of V2O5 on anatase and the surface vacant sites available on the preferentially exposed (001) plane of anatase suggest that the highly dispersed vanadium cations are bonded to the vacant sites on the surface of anatase as derived by the incorporation model. When the loading amount of V2O5 is far below its dispersion capacity, the dispersed vanadia species might mainly consist of isolated VOx species bridging to the surface through V-O-Ti bonds. With the increase of V2O5 loading the isolated vanadia species interact with their nearest neighbors (either isolated or polymerized vanadia) through bridging V-O-V at the expenses of V-O-Ti bonds, resulting in the increase of the ra     

SrTi0.9M0.1O3-δ钙钛矿型氧化物催化剂甲烷氧化偶联反应性能的研究

The structure and catalytic properties of SrTi_0.9M_0.1O_3-δ (M=Mg，Al， Zr) perovskite-type catalysts for ox-idative coupling of methane (OCM) have been studied by using X-ray diffraction (XRD)，X-ray photoelectron spectroscopy (XPS) and temperature-programmed desorption of oxygen(O₂-TPD) methods. It has been shown that doping the cations of lower valence (e.g. Mg²⁺， Al³⁺) to the B site of SrTi_0.9M_0.1O_3-δ perovskite-type catalysts results in the higher content of adsorbed oxygen species on the surface of catalysts and thus higher C₂-selectivity for OCM reaction. It is suggested that the oxygen vacancies of SrTi_0.9M_0.1O_3-δ (M=Mg， Al， Zr) perovskite-type catalysts are the sites responsible for oxygen activation， and the adsorbed oxygen species on the surface of SrTi_0.9M_0.1O_3-δ catalysts are the main active species for OCM reaction.     

一些金属氧化物在TiO_2(锐钛矿)载体上的分散 嵌入模型的应用

一些金属氧化物在ＴｉＯ２（锐钛矿）载体上的分散＊嵌入模型的应用徐斌董林陈懿（南京大学化学系亚微观固态化学研究所，南京２１００９３）关键词嵌入模型，金属氧化物，分散容量，锐钛矿我们曾以γ－Ａｌ２Ｏ３，ＣｅＯ２和ＳｉＯ２为载体研究了离子化合物的分散，认为...     

CuO/γ-Al2O3单分散催化剂的XAFS研究

采用XAFS方法研究浸渍法制备并于低温焙烧的CuO/γ-Al2O3催化剂的局域结构.对于CuO负载量小于单层分散阈值的CuO/γ-Al2O3(0.4 mmol/100 m2),结果表明,CuO物种是以层状分散的孤立原子簇存在于γ-Al2O3载体表面,其第一近邻Cu－O配位环境的结构与晶态CuO的相似,键长和配位数分别为0.195 nm和4.对于CuO负载量等于单层分散阈值的CuO/γ-Al2O3(0.8 mmol/100 m2),已有少量的CuO纳米颗粒生成.对于CuO负载量大于单层分散阈值的CuO/γ-Al2O3(1.2 mmol/100 m2),其结构与多晶CuO的相近.基于CuO在γ-Al2O3载体上的三种不同分散状态的结构特点,我们提出了CuO/γ-Al2O3催化剂的结构模型.     

Chemical preparation and investigation of Fe-P-B ultrafine amorphous alloy particles

A series of Fe-P-B ultrafine amorphous alloy particles has been prepared by the chemical reduction method The composition and size of the particles have been effectively adjusted.Mossbauer spectroscopy in addition to sonic other techniques has been used to investigate the reaction process,the factors that influence the preparation,the crystallization of the particles,and the interactions between the components within them.The results indicate that the co-deposition of iron,phosphorus and boron atoms in the solution at room temperature forms Fe-P-B amorphous alloy particles,and a preferential bonding of Fe-P bond to Fe-B one exists in the particles.