两性树脂解吸动力学的研究──温度对扩散系数的影响

本文采用浅床法对阳离子在弱酸强碱两性树脂相内的扩散速度进行了研究。发现温度升高 ,其粒内扩散系数增大 ,离子价态越高 ,扩散过程的活化能就越大 ,表明温度的改变对高价阳离子的扩散速度的影响更显著     

Eu3+在Ba2TiSi2O8中的发光

The barium titano-silicate phosphors doped with Eu³⁺ were synthesized by high temperature solid state reaction. The structures of as-synthesized samples were characterized by powder XRD. The maximum peaks of emission spectra of Ba₂TiSi₂O₈ and Ba₂TiSi₂O₈∶Eu³⁺ were respectively located at 450 and 618 nm, coming from the transitions of charge-transfer bands of Ti⁴⁺-O^2- and forced electric-dipole transition ⁵D₀-⁷F₂ of Eu³⁺. The luminous mechanisms of Ba₂TiSi₂O₈ and Ba₂TiSi₂O₈∶Eu³⁺ were suggested. The effects of concentration of Eu³⁺ on the luminous performance of Ba₂TiSi₂O₈∶Eu³⁺ were also studied and the results showed that the optimum concentration of Eu³⁺ was 0.12 mol per mole of matrix.     

An optimal scheme for top quark mass measurement near the t threshold at future e~+e~- colliders

A top quark mass measurement scheme near the t production threshold in future e~+e~- colliders, e.g. the Circular Electron Positron Collider(CEPC), is simulated. A χ~2 fitting method is adopted to determine the number of energy points to be taken and their locations. Our results show that the optimal energy point is located near the largest slope of the cross section v. beam energy plot, and the most efficient scheme is to concentrate all luminosity on this single energy point in the case of one-parameter top mass fitting. This suggests that the so-called data-driven method could be the best choice for future real experimental measurements. Conveniently, the top mass statistical uncertainty can also be calculated directly by the error matrix even without any sampling and fitting. The agreement of the above two optimization methods has been checked. Our conclusion is that by taking 50 fb~(-1) total effective integrated luminosity data, the statistical uncertainty of the top potential subtracted mass can be suppressed to about 7 Me V and the total uncertainty is about 30 Me V. This precision will help to identify the stability of the electroweak vacuum at the Planck scale.     

氟硅酸化学沉淀法净化萃余酸中的镁

通过二次回归正交设计,实验研究了化学沉淀法净化未经浓缩的革余酸中镁离子的工艺条件,对氟硅酸用量、萃余酸水去除量、反应温度和反应时间四个因子进行了研究。实验结果表明:当氟硅酸用量为95.71g,除水量为80.41g,反应温度为36.02℃,反应时间为45.03min时,可使镁离子去除率达到最佳值,达到生产优等DAP的磷酸要求;实验得到的镁去除率(y)与氟硅酸用量(z_1)、除水量(z_2)、反应温度(z_3)和反应时间(z_4)的模型预测方程为:y= 59.1785-0.541156z_1+0.425071z_2-0.660951z_3-1.635317z_1²+1.768750z_1z_2-6.392974z_22+1.768750z_1z_2-6.392974z_2²+1.011250z_1z_3-0.978750z_2z_3-0.611140z_32+1.011250z_1z_3-0.978750z_2z_3-0.611140z_3²-1.106885z_42-1.106885z_4².     

弱酸强碱两性树脂解吸动力学的研究

本文采用浅床解吸法对离子在弱酸强碱两性树脂相内的扩散进行了研究．结果表明：阳离子所带电荷越多．其粒内扩散系数就越小，阴离子体积越大．电荷多．则粒内扩散系数也越小。     

Cu(I)-Ce(IV)-Y吸附剂的制备及其脱硫性能研究

采用液相离子交换Cu、Ce离子制备了Cu(I)-Y、Ce(IV)-Y和Cu(I)-Ce(IV)-Y吸附剂,利用XRD、BET等技术对吸附剂进行了表征。通过静态实验考察了制备条件对Cu(I)-Ce(IV)-Y吸附剂脱硫性能的影响,通过固定床实验研究了吸附剂的穿透硫容,同时,在含噻吩与苯并噻吩的正辛烷模拟油中,分别加入甲苯、环己烯、吡啶配成新的模拟油,探究了吸附剂的脱硫选择性。结果表明,离子交换时间48 h,焙烧温度550℃,Cu/Ce物质的量比1∶1下制备的Cu(I)-Ce(IV)-Y吸附剂具有适宜的脱硫活性。在含甲苯、环己烯模拟油中,Cu(I)-Ce(IV)-Y吸附剂具有最好的脱硫性能,相同浓度的甲苯、环己烯和吡啶对各吸附剂脱硫性能的影响顺序为吡啶环己烯甲苯。引入Cu+可改善吸附剂的脱硫活性,引入Ce4+可改善吸附剂对硫化物的选择性,Cu+和Ce4+的协同作用使Cu(I)-Ce(IV)-Y兼具有高的硫容和抗芳烃、烯烃能力。     

电位滴定法测定两性树脂的表观解离常数

本文通过对ＨＣｌ型弱酸强碱两性树脂的电位滴定数据的测定,获得了该类树脂的等电点以及在中性盐存在下的表观解常数等数据,并结结果进行了解释。     

镍磷物质的量比对负载型Ni2P/MCM-41催化剂结构及加氢脱硫性能的影响

以MCM-41为载体,采用一种简捷、温和法制备了负载型Ni₂P/MCM-41催化剂。用H₂程序升温还原(H₂-TPR)、X射线衍射(XRD)、N₂吸附比表面积测定(BET)和X射线光电子能谱(XPS)分析对催化剂进行了表征。以1%(质量分数)二苯并噻吩(DBT)的十氢萘溶液为原料,在连续固定床反应装置上,研究了初始Ni/P物质的量比对催化剂HDS活性的影响,并考察了催化剂的稳定性。结果表明,初始Ni/P物质的量比为1/2和1/3的前驱体,在390 ℃下还原时得到单一的Ni₂P相。初始Ni/P物质的量为1/2时,得到的催化剂活性最好。在反应温度340 ℃、压力3.0 MPa、氢/油体积比500、质量空速2.0 h^-1时,DBT的转化率接近100%。     

Ni_2P催化剂的低温还原法合成及其HDS性能

在低还原温度下程序升温还原法制备了Ni2P/MCM-41催化剂,并采用H2-TPR、TG-DTG、XRD、BET、XPS等手段对制备的催化剂进行了表征,考察了还原温度对活性相Ni2P形成以及催化剂二苯并噻吩HDS性能的影响。结果表明,在210~390℃下还原得到的催化剂活性相为单一的Ni2P相;在390℃下还原得到的催化剂具有最高的二苯并噻吩HDS活性,在反应温度340℃、反应压力3.0 MPa、氢/油体积比500、质量空速(WHSV)2.0 h-1的条件下二苯并噻吩HDS转化率达到99.0%。     

5株细菌产L-多巴黑色素的比较研究

对5株细菌所产黑色素的物理和化学性质及发酵进行了比较研究。结果表明：尽管这些不同来源的黑色素在理化性质上存在一定差异，但它们的基本框架结构及主要基团是一致的，且在发酵过程中都检测到L-多巴，说明它们都属于多巴类黑色素；不同菌株在同一条件下和同一菌株在不同条件下发酵黑色素的产量差别很大。其中WS和H2的黑色素产量可分别达到1720mg／L和1040mg／L，有进一步开发成为工业发酵生产黑色素应用菌株的潜力。