[Bmim]PF6疏水性离子液体敏感膜H2 PO4-离子选择性电极测定土壤中总磷含量

制备了以1-丁基-3-甲基咪唑六氟磷酸盐([Bmim]PF_6)-疏水性离子液体液膜为敏感膜的H_2PO_4~-离子选择性电极(H_2PO_4~--ISE),并在pH 4.66的0.1mol·L~(-1)乙酸-乙酸钠缓冲溶液中,在30℃,以Ag|AgCl|[Bmim]Cl为参比电极,研究该离子电极对H_2PO_4~-的电位响应。试验结果表明:H_2PO_4~-浓度在1.0×10~(-1)～1.0×10~(-5 )mol·L~(-1)内的负对数值,-lg[H_2PO_4~-]与其相应的电位值之间呈线性关系,斜率为-25.4mV·dec~(-1),响应时间为3min。应用此方法测定了土壤样品中总磷的含量,称取通过0.150mm样筛的土样0.300 0g,以少量水湿润后,加入硫酸8mL及高氯酸10滴,混匀后加热消煮至溶液开始转白,继续消煮20min,冷却后加水定容至100 mL,放置过夜,取上清液1.0mL,加入pH 4.66乙酸-乙酸钠缓冲溶液1.0mL,混匀,将H_2PO_4~--ISE插入其中,电极两端分别接至电位计,稳定3min,记录其电位值,所得5个样品的测定值与钼酸铵光度法的测定值基本一致。     

用于超级电容器的层状Co3O4/Ti纳米片柔性电极及其低电荷转移电阻

采用水热合成法,在Ti网上原位生长多孔层状Co_3O_4纳米片,并优化了电荷转移电阻。通过X射线衍射(XRD)、扫描电子显微镜(SEM)和透射电子显微镜(TEM)对产物的结构、形貌进行表征,及对电极的电化学性能进行测试。结果表明,材料是由排列良好的微米矩形二维薄片组成,且具有均匀的孔隙分布。这种独特的微纳米结构的超级电容器电极材料降低了电极的电荷转移电阻,增强了活性物质的结构稳定性,从而提高了电极的电化学性能,在电流密度为100 mA·g-1时,电极循环1 000次后,电容保持率为91.8%,电荷转移电阻(Rct)为0.29Ω。这些显著的超电容性能归因于合理的二维层状结构在柔性基底钛网上的生长及柔性Co_3O_4/Ti电极活性材料的高利用率。     

利用升华物质2,4,6-三异丙基-1,3,5-三氧杂环己烷作模板剂制备聚苯胺包覆的中空硫电极材料

本文首次提出采用升华物质为模板,制备聚苯胺包覆的中空硫电极材料. 首先通过Na₂S₂O₃和稀HCl反应,在具有升华特性的ADD(2,4,6-三异丙基-1,3,5-三氧杂环己烷)微粒表面沉积一层S,然后在S的表面再沉积聚苯胺包覆层. 在经60 ^oC干燥12小时后,其中的ADD自然挥发,得到聚苯胺壳体包覆的中空硫复合物. SEM、TEM和TG分析表明,制得的聚苯胺包覆中空硫的粒径约为2 μm,硫含量为61.1%. 在500 mA·g^-1充放电电流下,首次放电比容量为776.2 mAh·g^-1,库仑效率为95.9%. 100次充放电循环后,放电比容量为524.7 mAh·g^-1. 由于聚苯胺包覆物的聚苯胺膜具有抑制聚硫锂向外的扩散作用,以及包覆物中的空间对放电时S的膨胀具有缓冲作用,聚苯胺包覆中空硫粉末的放电比容量和充放电稳定性均明显高于未包覆聚苯胺的中空硫和化学制备的硫. 这种制备导电聚合物包覆中空硫的新方法具有操作简单、成本低廉的优点,有进一步发展的前景.     

锂硫电池中电极过程的原位可视化研究进展

锂硫电池被认为是极具应用潜力的下一代能源存储器件之一.在锂硫电池中,对电极-电解质界面物质结构和演变规律的深入探究及认知对其进一步发展至关重要.本文结合多种原位可视化技术,包括扫描探针显微术、电子显微术、X射线以及光学显微术,概述了近年来在锂硫电池中界面成像分析的研究进展.主要讨论了在硫正极界面、硫/硫化锂演变、多硫化物溶解以及在锂负极界面、固液界面层形成、锂沉积行为等问题,有助于理解锂硫反应的基本原理并提出优化方案.     

La-Ti/SnO2-Sb/RuO2-Co电极制备及其处理垃圾渗滤液研究

以纯钛为基体材料,并以热氧化的方式制备La-Ti/SnO_2-Sb/RuO_2-Co电极,采用X-射线衍射仪(XRD)、扫描电子显微镜(SEM)及X-射线能量色散谱(EDS)对电极涂层表面形貌和晶体结构进行表征。采用制备的La-Ti/SnO_2-Sb/RuO_2-Co电极作为阳极,不锈钢为阴极,构建电化学反应器,对老龄垃圾渗滤液进行降解。结果表明在电流密度为65 mA/cm~2、Cl-浓度为4 500 mg/L、初始pH=9和反应时间为6 h的最佳反应条件下,La-Ti/SnO_2-Sb/RuO_2-Co电极对NH_3-N和COD的去除率分别达到86.5%、61%。     

Langevin study of neutron emission in the reactions ^16O＋^181Ta and ^19F＋^178Hf^＊

The pre-scission neutrons measured in the reactions 16O 181Ta and 19F 178Hf are studied via a Langevin equation coupled with a statistical decay model. We find that because of the mass asymmetry of different entrance channels, the spin distributions of compound nuclei would be different, consequently, the measured neutrons in these two reactions would also different. This means that the entrance channel will affect the particle emission in the fission process of hot nuclei.     

基于非线性偏振旋转效应的多波长光纤激光器

多波长光纤激光器是未来波分复用光通信系统的理想光源,提出和展示了一个基于非线性偏振旋转效应的多波长光纤激光器,非线性偏振旋转诱导的强度相关非均匀损耗能有效地抑制均匀加宽增益介质掺铒光纤中的模式竞争,从而使光纤激光器在室温下产生稳定的多波长输出,实验实现了最多18个波长的多波长输出.另外,此激光器没有使用传统的滤波器,而是在激光腔内插入一段保偏光纤,保偏光纤与偏振相关隔离器构成一等效Lyot双折射光纤周期性滤波器.利用这种在线型的双折射光纤滤波器简化了光纤激光器的结构,使它更易于集成.还实验研究了多波长输出随抽运功率的演化,发现抽运功率对多波长的均匀性影响很大.     

Pt/Ti Electrodes of PZT Thin Films Patterning by Novel Lift-Off Using ZnO as a Sacrificial Layer

We achieve a successful novel lift-off of patterning Pt/Ti electrodes on SiO2/Si substrates by employing ZnO sacrificial layer deposition and patterning, successive uniform Pt/Ti deposition and final lift-off. Then we deposit PZT thin films on the electrodes. Compared with the conventional lift-off processes for the electrodes, this novel process does not need post-annealing, which must be performed after conventional lift-off process. It is demonstrated that the electrodes patterned by the novel lift-off process have stronger adhesion. The electrodes and the PZT films on the electrodes are more compact and smoother than those by the conventional lift-off process.     

Preparation and Characterization of BPO Film as Electrode for Using of FeRAM

Conductive perovskite BaPb03 （BPO） films as a potential electrode material of PZT capacitors used in ferroelectric random access memory are prepared by rf magnetron sputtering. An x-ray diffractometer and standard four probe method are employed to investigate the dependence of growth conditions on crystal structure and conductivity of BPO films. It is found that BPO films with perovskite phase can be obtained at substrate temperatures above 425℃, and the sample with the lowest resistivity is obtained at 450℃ under pure argon atmosphere. Using this BPO film as electrode, ferroelectric properties of BPO/PZT/BPO and Pt/PZT/BPO sandwiched structures are evaluated. Their remanent polarization and coercive field are 36.6 ℃/cm^2 （81.3 k V/cm） and 36.9℃/cm^2 （89.1 kV/cm）, respectively. The coercive field of the former structure is lower than that of the latter, but remanent polarizations are almost the same. In addition, the results imply that BPO electrode is helpful to improve the fatigue resistance of PZT. The reasons are discussed.