芹菜、草莓基质对甲胺磷等4种有机磷农药测定的影响

研究芹菜、草莓基质对甲胺磷、乙酰甲胺磷、氧化乐果、毒死蜱4种有机磷农药检测的影响。利用样品基质溶液配制标准样品,对比草莓、芹菜样品、丙酮溶液中4种农药的保留时间、峰形、峰面积。结果发现DB–5MS色谱柱上,丙酮溶液、芹菜基质、草莓基质中甲胺磷、乙酰甲胺磷、氧化乐果色谱峰出峰时间不完全重合,保留时间最大漂移0.1 min。丙酮溶剂、芹菜基质较草莓基质中的甲胺磷、乙酰甲胺磷、氧化乐果更容易出现峰拖尾现象,且芹菜基质溶液中相同浓度的甲胺磷、乙酰甲胺磷峰面积分别约是草莓基质溶液中的75%,90%。毒死蜱的保留时间、峰形、响应面积在草莓基质、芹菜基质、丙酮溶液中基本一样。     

HTS双饼线圈的加工工艺及实验研究

详细介绍了高温超导双饼线圈的加工工艺和流程,针对绕制时带材弯曲形变使临界电流退化的技术难点,重点阐述了其解决方法。在液氮温度、自场环境下对采用该加工工艺制作的YBCO双饼线圈及Bi2223/Ag双饼线圈进行低温实验,测试其V-I特性曲线。实验结果表明:该工艺制作的双饼线圈性能良好,工艺安全可靠,是合适的。同时,实验测量数据也为线圈在磁体中的进一步应用提供了可靠依据。     

Alternating-current losses in two-layer superconducting cables consisting of second-generation superconductors coated by U-shaped ferromagnetic materials

Alternating-current losses in a two-layer superconducting cable, each layer being composed of 15 closely-spaced rectangular wires made up of second-generation superconductors when the ends of wires are coated by either a non-magnetic or strong ferromagnetic material having a U profile is numerically investigated. Computations are carried out through the finite-element method. The alternating-current losses do not increase significantly if the relative permeability of the coating is increased three orders of magnitude, provided that the current amplitude is less than half of the critical current in a superconducting wire. However, the losses are much higher for ferromagnetic coating if the amplitude of the applied current oscillating at 50 Hz is close to the critical current. The ferromagnetic coating is seen to accumulate the magnetic field lines normally on its surfaces, while the field lines are parallel to the long axes of the wires, leading to more significant flux penetration in the coated regions. This facilitates a uniform low-loss current flow in the uncoated regions of the wires. In contrast, coating with a non-magnetic material gives rise to a considerably smaller current flow in the uncoated regions, whereas the low-loss flow is maintained in the coated regions. Moreover, the current flows in opposite directions in the coated and uncoated regions, where the direction in each region is converse for the two materials.     

纳米颗粒复合介电层柔性有机薄膜晶体管的制备与性能研究

使用聚酰亚胺(PI)作为柔性有机薄膜晶体管(OTFT)的衬底,通过掺入钛酸锶钡(BST)纳米颗粒来提高PVP聚合物栅介电层的电容,再使用聚甲基丙烯酸甲酯(PMMA)来修饰介电层,改善介电层薄膜的质量和性能,从而降低柔性OTFT的阈值电压,提高电流开关比和迁移率.测试结果表明,优化后的柔性OTFT阈值电压为-2.5V,电流开关比大于104,迁移率为0.0703 cm2/(V·s).器件在3 mm弯曲半径下依然可以正常工作,电流开关比保持在104级别.     

Investigations of ionization-induced injection of laser wake field acceleration using phenomenological model

We develop a phenomenological model to investigate dynamics of ionization-induced injection. In the ＂bubble＂ regime of laser wakefield acceleration （LWFA）, it is found that there is an upper limit for laser intensity of ionization-induced injection. In the plane perpendicular to the laser polarization, when the laser pulse is linearly polarized, ionization-induced injected electrons exhibit a filamented structure and semi-coherent betatron oscillation.     

线缆系统电磁脉冲效应测量系统研制和试验

分析了实验室瞬态X射线产生的系统电磁脉冲(SGEMP)效应测试所面临的技术问题,提出了解决方法、措施以及实验室模拟瞬态X射线的SGEMP模拟试验方法。通过电子屏蔽、电磁屏蔽、光电隔离、信号对称提取等特殊技术处理,解决了SGEMP效应模拟试验方法和测量系统抗X射线、抗电磁辐射等技术问题,并在大型瞬态X射线模拟源上,测出了瞬态X射线辐照时金属腔内线缆的SGEMP效应波形及幅值。     

方差可能无穷的“中度偏离”单位根过程的复合分位数估计

考虑一类"中度偏离"单位根过程,y_t=q_ny_t-1+u_t,其中qn=1+c/(k_n),k_n=o(n),c为一非零常数,{u_t}为随机扰动项序列.在允许扰动项方差无穷的条件下,构造q_n的复合分位数估计,并得到了该估计的渐近分布.最后通过数值模拟,在扰动项服从t(2)分布下,说明了该估计的稳健和有效性.     

电除尘器的脉冲电源研究北大核心CSCD

为解决电除尘器脉冲电源存在的负载上脉冲拖尾、电容剩余电压积累、负载上电压振荡问题,在充电二极管两端反向并联了一个辅助开关。详细分析了电路的工作原理,给出了选取影响负载上脉冲波形的关键元器件参数的理论依据,仿真分析和低压试验验证了解决方案的正确性。脉冲电源的改进,有利于进一步提高除尘效率和能量利用率。     

基于虚拟中心电流法的 HL-2M快控电源数学模型

针对中国环流器2号M(HL-2M)装置中用于核聚变物理实验等离子体的垂直不稳定性控制的快控电源拓扑结构，充分考虑线圈的自感与互感对输出的影响，构建出数学模型，首次提出并运用虚拟中心电流法，使得控制算法更加简单，采用多输入多输出的控制方法，利用2个参量控制3个变量。本文基于基本供电方案得到多线圈耦合电压，基于快控电源拓扑推导出快控电源电路方程，再将其合并得到最终的线圈电压数学模型，最后进行仿真验证。结果表明数学模型搭建正确，为今后进行进一步计算提供了坚实的基础。     

一种超导重力仪磁悬浮力的等效计算

为实现超导重力仪磁悬浮力的精确计算,以GWR型超导重力仪为模型基础,采用有限元的思想,将超导球表面电流理想化为多个等高共轴电流环,计算出各个电流环与超导线圈的作用力,求和得到线圈与超导球间的磁悬浮力。利用MATLAB完成计算程序实现,通过改变下线圈电流和上、下线圈电流比,获得满足一定条件的磁悬浮力及其梯度。选取合适的模型参数,计算出线圈对质量为m=4.069 g超导球的磁悬浮力大小为:Ftotal=3.988×10^-2N,磁悬浮力梯度为:-9.699×10^-3N/m,此时悬浮力梯度合适,满足系统稳定性和灵敏度的要求。