聚3-甲基噻吩修饰量子点硫化铅连接TiO2纳米结构膜的光电化学研究

采用原位化学法在纳米结构TiO2电极上制备了量子点PbS(Q-PbS), 并用电化学方法在TiO2/Q-PbS表面聚合3-甲基噻吩[poly(3-Methylthiophene), PMeT]. 研究结果表明, PMeT和Q-PbS单独修饰纳米结构TiO2电极和PMeT修饰Q-PbS连接纳米结构TiO2电极的光电流产生的起始波长都向长波方向移动; 在可见光区光电转换效率均比纳米结构TiO2的光电转换效率提高显著; PMeT与Q-PbS修饰的纳米结构TiO2之间存在p-n异质结. 在一定条件下p-n异质结的存在有利于光生电子/空穴的分离, 提高了光电转换效率.     

阳极氧化膜In2O3（Ⅰ）—膜的形成和电子性质

利用循环伏安法和X射线光电子能谱技术(XPS)研究In在碱性溶液中的电极反应,结果表明通过阳极氧化可在In电极表面形成In_2O_3膜.探讨能获得较高光电转换量子效率的In_2O_3膜的电化学制备方法,并利用Mott-Schottky图、光电流谱和电反射光谱的测量测定膜的半导电性质.     

Mycotoxins Detection Based on Electrochemical Approaches

Electrochemical biosensors have attracted much attention in mycotoxin bioanalysis. In this review, three electrochemical biosensor technologies for mycotoxins were reviewed, including general electrochemistry, photoelectrochemistry, and electrochemiluminescence. Based on the classification of multiple electrochemical detection methods, the design schemes, recognition mechanism and probe materials were described in detail. Moreover, the characteristics and limitations of these electrochemical biosensors were summarized. The challenges and future trends of electrochemical biosensor development in mycotoxin bioanalysis were also briefly discussed in the end. This review is expected to provide some inspirations for point-of-care testing in electrochemical sensors for mycotoxins and further electrochemical analysis application.     

光电化学生物分析研究进展

光电化学生物分析是近年来新出现并发展迅速的一种分析技术,其检测原理是基于在光照下识别元件和目标分子之间的生物识别作用造成光电活性物质产生的电信号的改变,以实现对待测物的定量测定。由于其灵敏选择性检测的优点及其在生物分析中的巨大潜力,该方法吸引了较多的关注,并且在检测性能和生物传感应用等方面也取得了较大进步。本文针对光电化学生物分析中常见的四种应用领域,即直接光电化学检测、光电化学酶检测、光电化学核酸检测以及光电化学免疫分析,综述了近年来国内外在光电化学生物分析研究领域的最新进展,并对其未来发展进行了展望。     

不对称菁染料敏化纳米TiO2的光生电流过程

用光电化学方法研究了不对称菁类染料敏化TiO2纳米结构电极的光电转换过程.结果表明,该染料的电子激发态能级位置与TiO2纳米粒子导带边位置匹配较好,光激发染料后,其激发态电子可以注入到TiO2纳米多孔膜的导带,从而使TiO2纳米结构电极的吸收光谱和光电流谱红移至可见光区,其 IPCE(Incident photon-to-electron conversion efficiency)值最高可达84.3%.并进一步结合现场紫外-可见吸收光谱研究了外加电势对激发态染料往TiO2纳米多孔膜注入电子过程的影响.     

水热法合成纳米TiO_2及其在Grtzel电池中的应用

By varying the hydrolysis and hydrothermal processing parameters in preparing TiO2 nanoparticles different sizes of TiO2 nanoparticles are obtained.(1) At higher autoclaving temperature,lower pH and longer autoclaving period,larger sizes of TiO2 nanoparticles are prepared.(2) The nanoporous electrodes made from sintering smaller TiO2 nanoparticles show relatively poor IPCE and low absorption in UV-Vis spectrum,(3) Higher IPCE can be achieved with TiO2 nanoporous electrodes made from sintering larger TiO2 nanoparticles.These electrodes are suitable for studying behavior of the photoelectrochemistry of dye sensitized nanoporous electrodes.     

纳米结构TiO2/3-甲基噻吩和2-噻吩甲酸共聚物复合膜电极光电化学性能

用光电流作用谱、光电流-电势图等光电化学方法研究了ITO/3-甲基噻吩和2-噻吩甲酸共聚物(CTCMT)膜电极和ITO/TiO₂/CTCMT复合膜电极的光电转换性质.结果表明,CTCMT膜为p型半导体,禁带宽度为2.36eV,价带位置为-5.52eV.在ITO/TiO₂/CTCMT复合膜电极中存在p-n异质结,在一定条件下异质结的存在有利于光生电子-空穴对的分离.CTCMT膜修饰ITO/TiO₂电极可使光电流增强,光电流起始波长红移至600nm以上,使宽禁带半导体电极的光电转换效率得到改善.     

Au/PATP/PANI膜电极和Au/PATP/PANI/TiO2膜电极的光电化学

聚苯胺（PANI）是一种结构、 性质不同于聚乙炔和聚吡咯的新型导电高聚物,有着十分广泛的应用[1,2].近年来利用光电化学研究聚苯胺的电子结构、 掺杂情况引起人们的重视[3～5].在酸性溶液中电聚合制备聚苯胺的循环伏安曲线上出现两对氧化还原峰,其峰值电位分别为E11/2=0.13 V和E21/2=0.7 V(对饱和甘汞电极).通过改变电极电位,可获得部分氧化态、还原态、氧化态等3种状态的聚苯胺.部分氧化态具有金属导电性,还原态和氧化态均为绝缘体.本文测量3种状态聚苯胺膜电极的光电响应,首次得到其光电流谱,发现聚苯胺一些新的光电化学实验结果.提出了覆盖绝缘体的金属内发射的光电化学模型.同时,在聚苯胺膜上电沉积纳米TiO2微粒膜,得到广谱区的复合光电材料.     

3d过渡金属掺杂TiO2纳米晶膜电极的光电化学研究

应用原子力显微镜和X射线粉末法对3d过渡金属离子Cr(Ⅲ),Fe(Ⅲ),Mn(Ⅱ),Co(Ⅱ),Ni(Ⅱ),Cu(Ⅱ)和Zn(Ⅱ)掺杂TiO₂纳米晶粒(简写为m^3d-TiO₂)作了表征,并用光电化学方法研究了m^3d-TiO₂纳米结构多孔膜电极.实验结果表明,m^3d-TiO₂纳米粒子的颗粒较均匀,粒径约为15nm,其晶型为锐钛矿和板钛矿的混晶.在所研究的m^3d-TiO₂中,只有Zn²⁺-TiO₂电极的光电流大于未掺杂的TiO₂纳米结构多孔膜电极.3d金属离子的掺杂引起各电极的光电流信号在一定波长范围内出现p-n转型现象.     

Photoelectrochemically driven processes at the N,N,N′,N′-tetrahexylphenylenediamine microdroplet|electrode|aqueous electrolyte triple interface

Novel photoelectrochemical processes are observed upon irradiation of the liquid|liquid|solid triple interface at microdroplets of N,N,N′,N′-tetrahexyl-para-phenylenediamine (THPD) deposited onto a basal plane pyrolytic graphite electrode and immersed in aqueous electrolyte solution. In the presence of neutral THPD, cathodic photo responses, and in the presence of THPD⁺, anodic photo responses with anion-dependent characteristics, are observed. A maximum in the photocurrents observed at intermediate coverage of the electrode surface suggests that the triple interface THPD|electrode|aqueous electrolyte is the reaction zone. This is the first report of photoelectrochemical processes at this type of interface. Electronic Publication