贝壳粉对铅(Ⅱ)吸附性能的研究

制备了不同粒径的贝壳粉,并将此材料作为铅(Ⅱ)的吸附剂,研究贝壳粉的的吸附性能。结果表明:介质pH为7.0时,铅(Ⅱ)的吸附容量随贝壳粉的粒径减小和温度的升高而增大。     

稀土元素对Ti0.26Zr0.07V0.24Mn0.1Ni0.33贮氢合金微观结构和电化学性能的影响

本文研究了稀土元素对Ti0.26Zr0.07V0.24Mn0.1Ni0.33合金的微观结构和电化学性能的影响。结果表明,Ti0.26Zr0.07V0.24-xMn0.10Ni0.33REx(RE=Ce,Nd,Gd;x=0.01)合金均有V基固溶体相和C14型Laves相两相组成。合金中两相的晶格参数随加入稀土元素的不同而发生变化。稀土元素部分取代可改善合金电极的活化性能。然而,对合金电极的其他性能影响因元素种类不同而各异。Ce取代增大了合金电极的最大放电容量,Nd元素可以有效改善合金的高倍率放电性能。工作温度对合金电极的放电容量影响较大,Nd和Gd在333 K最大放电容量可达426和465 mAh.g-1。过高的温度使其循环容量衰减加剧。     

Evaluation of measurement uncertainty in EA–IRMS: for determination of δ 13C value and C-4 plant sugar content in adulterated honey

In this study, the method for determining the stable carbon isotope ratio value was validated. Measurement uncertainty of stable carbon isotope ratio value of whole honey and its extracted protein derived from repeatability, reference gas, reference standards and calibration curve was calculated by applying the “bottom-up” approach according to Eurachem/CITAC guide. The expanded uncertainties for all results ranged from 0.14 to 0.19 ‰, with most of them between 0.15 and 0.16 ‰ (the coverage factor k = 2, the level of confidence p is approximately 95 %). The percentage contribution of each source to the relative combined uncertainty was calculated. The data indicated that calibration curves have more contribution to the relative combined uncertainty than repeatability and reference standards. On the other hand, the measurement uncertainty of C-4 sugar content in honey was estimated. Based on these results, 58 honey samples, such as acacia, chaste, Northeast China black bee, flowers and jujube honey, have been gathered to determine the C-4 plant sugar content adulteration in honey by elemental analyzer with an isotope ratio mass spectrometer. It can be found that all honey samples were not adulterated by C-4 plant sugar.     

硼的添加对Ti0.26Zr0.07V0.24Mn0.1Ni0.33贮氢合金结构和电化学性能的影响

Ti_0.26Zr_0.07V_0.24Mn_0.1Ni_0.33Bx(x=0~0.10)系列合金均有V基固溶体相和C14型Laves相两相组成。添加B可提高Ti_0.26Zr_0.07V_0.24 Mn_0.1Ni_0.33合金的放电容量, Ti_0.26Zr_0.07V_0.24Mn_0.1Ni_0.33B0.1合金电极在60 mA·g^-1电流放电时的放电容量达到476.7 mAh·g^-1.B的添加不同程度地降低了合金的高倍率放电性能, 使合金电极表面上电化学反应的电荷转移电阻(R_ct)显着增加, 交换电流密度(I₀)显着降低。添加B可显着改善Ti_0.26Zr_0.07V_0.24Mn_0.1Ni_0.33合金电极的高温放电性能, Ti_0.26Zr_0.07V_0.24Mn_0.1Ni_0.33B_0.025合金电极在343 K高温下其放电容量达到525.6 mAh·g^-1.     

苯并咪唑-5,6-二羧酸Mn(II)和Cd(II)混配配合物的合成、结构及性质

在水热条件下,合成了2个配位聚合物{[Mn（Hbidc）（2,2''-bpy）（H₂O）₂]·1.5H₂O}_n（1）和{[Cd（Hbidc）（phen）][Cd（phen）₂Cl₂]}_n（2）（H₃bidc=苯并咪唑-5,6-二羧酸,2,2''-bpy=2,2''-联吡啶,phen=菲咯啉）,并通过X射线单晶衍射、红外、元素分析、X射线粉末衍射和热重对配合物结构进行了表征。配合物1是一维无限zig-zag链结构,可以通过O-H…O和N-H…O氢键的相互作用形成三维超分子结构。配合物2也是一维无限链结构。此外,测试了配合物1和2的固体紫外吸收光谱和研究了配合物2的固体荧光性能。     

Stability and stabilization for the coupling permanent magnet synchronous motors system with input delay

Nonlinear Dynamics - This paper studied the problem of stability and stabilization for a coupling permanent magnet synchronous motors (CPMSMs) system with input delay. Input delays caused by...     

集中载荷作用下不同边界条件的弯曲厚矩形板的受迫振动

运用边界积分法研究了四边简支、两对边固定另两对边简支、四边固定三种复杂边界条件下厚矩形板的受迫振动问题,求解过程清晰,从而给出了受迫振动控制方程和挠曲面方程。通过在Matlab平台上进行数值计算,得出了图表形式的计算结果,并与有限元模拟值进行对照。研究表明,边界积分法用于求解厚矩形板的受迫振动问题的准确性,本文推导的控制方程和挠曲面方程的正确性,进而对工程实际中的各种相关问题具有一定的现实意义,也为求解此类问题提供了一种新途径,可以直接运用到工程实际中。     

Sunlight assisted photodegradation by tin oxide quantum dots

Rutile phase of SnO₂ quantum dots of average size of 2.5 nm were synthesized at a growth temperature of 70 °C and characterized with XRD, TEM, FTIR and Raman analysis. The effective strain within the lattice of SnO₂ quantum dots was calculated by Williamson–Hall method. The broad peaks in XRD as well as Raman spectra and the presence of Raman bands at 569 and 432 cm⁻¹ are due to lower crystallinity of nanoparticles. The optical band gap of SnO₂ quantum dots was increased to 3.75 eV attributed to the quantum size effect. SnO₂ quantum dots were annealed in air atmosphere and the crystallite size of the particles increased with annealing temperature. Sunlight assisted photodegration property of SnO₂ quantum dots was investigated with vanillin as a model system and it shows the photodegradation efficiency of 87%. The photoluminescence and photodegradation efficiency of nanocrystallite SnO₂ decreases with increase of crystallite size contributed to the reduction in population of defects and surface area.     

Study on LiFe<Subscript>1 − <Emphasis Type="Italic">x</Emphasis></Subscript>Sm<Subscript><Emphasis Type="Italic">x</Emphasis></Subscript>PO<Subscript>4</Subscript>/C used as cathode materials for lithium-ion batteries with low Sm component

LiFe_1???x Sm _x PO₄/C cathode materials were synthesized though a facile hydrothermal method. Compared with high-temperature solid-phase sintering, the method can allow for the fabrication of low Sm content (2 %), a scarce and expensive rare earth element, while the presence of an optimized carbon coating with large amount of sp²-type carbon sharply increases the material’s electrochemical performance. The high-rate dischargeability at 5 C, as well as the exchange current density, can be increased by 21 and 86 %, respectively, which were attributed to the fine size and the large cell parameter a/c as much. It should be pointed out that the a/c value will be increased for the LiFePO₄ Sm-doped papered by both of the two methods, while the mechanism is different: The value c is increased for the front and the value a is decreased for the latter, respectively.