CTAB assisted hydrothermal synthesis, controlled conversion and CO oxidation properties of CeO2 nanoplates, nanotubes, and nanorods

In this work, CeO₂ nanoplates were synthesized by a hydrothermal reaction assisted by hexadecyltrimethylammonium bromide (CTAB) at 100-160 °C. The size of nanoplates was around 40 nm. Further experiment showed that the controlled conversion of nanoplates into nanotubes, and nanorods can be realized by changing the reaction time, temperature, and CTAB/Ce³⁺ ratio value. X-ray diffraction (XRD), transmission electron microscopy (TEM), and Brunauer-Emmett-Teller (BET) nitrogen adsorption-desorption measurements were employed to characterize the samples. The CO oxidation properties of nanorods, nanoplates, and nanotubes were investigated. An enhanced catalytic activity has been found for CO oxidation by using CeO₂ nanoplates as compared with CeO₂ nanotubes and nanorods, and the crystal surfaces (100) of CeO₂ nanoplates were considered to play an important role in determining their catalytic oxidation properties.     

Effect of precursor concentration on the growth of zinc oxide nanorod arrays on pre-treated substrates

Well aligned zinc oxide nanorod arrays (ZNAs) synthesized by a simple chemical bath deposition method were fabricated on pre-treated Si substrates. By keeping the molar VI/II ratio constant, the effect of precursor concentration on the growth and optical quality of the ZNAs was investigated. The as-synthesized ZNAs were characterized by field emission scanning electron microscopy (FESEM), x-ray diffraction (XRD) and photoluminescence spectroscopy (PL). FESEM images show that both the diameter and aspect ratio of the ZNAs increase dramatically as the precursor concentration increases. The XRD analysis indicates that all the as-grown ZNAs are crystalline and are preferentially oriented along the c-axis. The high intensity ratio of the UV emission to visible emission in the room temperature PL spectra illustrate that high optical quality ZNAs were produced.     

Synergistic upconversion effect in NaYF4:Yb,Tm nanorods under dual excitation of 980 nm and 808 nm

NaYF₄:Yb³⁺,Tm³⁺ nanorods are prepared with hydrothermal method. The upconversion luminescent properties are investigated under dual excitation of 980 nm and 808 nm. The blue emission is observed at about 475 nm under dual excitation. The intensity is 2.6 times higher than the total intensity of the two corresponding single wavelength excitations, showing a synergistic upconversion effect occurring there. The dual wavelength excitation not only effectively decreases non-radiative relaxation pumped by 980 nm but also reduces the rate of the back energy transfer from Tm³⁺ to Yb³⁺ pumped by 808 nm. The result provides a possible new way to further improve the upconversion efficiency of rare earth doped phosphor.     

ZnO thin film with nanorod arrays applied to fluid sensor

A ZnO guiding layer with nanorod arrays grown on a 90°-rotated ST-cut (42°45) quartz substrate was used to fabricate a Love wave fluid sensor. ZnO nanorod arrays synthesized on the guiding layer enhance the sensitivity of the flow rate. ZnO thin films were deposited by radio frequency magnetron sputtering and ZnO nanorod arrays were then synthesized on the thin films via the hydrothermal method. The crystalline structure and surface morphology of ZnO thin films and nanorod arrays were examined by X-ray diffraction and scanning electron microscopy. The effects of the thickness of ZnO thin film and the surface morphology of ZnO nanorod arrays on the sensitivity of flow rate were investigated. A linear response between flow rate and the return loss of the sensor with one-port resonator type can be obtained by adjusting the thickness of ZnO thin film and the length of nanorod arrays.     

针状纳米MnxNi0.5-xZn0.5Fe2O4的共沉淀法制备及表征

通过在碱液中共沉淀Mn²⁺、Ni²⁺和Fe²⁺后制备了棒状的前躯体,前躯体于不同温度煅烧后制得了Mn_xNi_0:5-xZn_0:5Fe₂O₄棒状体. 利用X射线衍射仪和透射电镜对棒状体的物相、形貌及粒径进行了表征,并利用振动样品磁强计对磁性能进行研究. 结果表明长径比大于15的棒状,随着x值的增加,Mn_xNi_0:5-xZn_0:5Fe₂O₄样品的直径增加,长度下降,长径比变小,当x=0.5时其直径在50 nm左右而长径比减小到7～8. 随着x值的增加,样品的矫顽力先增加后减少,x值达到0.4时样品的矫顽力再次增加,当煅烧温度为600 oC,x=0.5时样品的矫顽力最大为134.3 Oe. 饱和磁化强度随着x值的增加先增加后减少,当煅烧温度为800 oC和x=0.2时达到最大为68.5 Oe.     

In2O3敏化ZnO纳米棒阵列的性能及其光电催化活性

以掺氟SnO₂ (FTO)导电玻璃为基底, 采用水热法制备了ZnO纳米棒阵列. 通过In(NO₃)₃水溶液水洗的方法, 合成了In₂O₃敏化ZnO纳米棒阵列光催化剂. 采用场发射扫描电子显微镜(FESEM), X射线能谱(EDX), X射线衍射(XRD)及紫外-可见漫反射光谱(UV-Vis DRS)对样品的形貌、结构、组成、晶相等进行一系列的表征. 以罗丹明B (RhB)为目标降解物, 探究了In₂O₃敏化ZnO 纳米棒阵列光电催化活性. 采用场诱导表面光伏技术(FISPV)研究了不同含量的In₂O₃敏化ZnO纳米棒阵列在光照射下的光生电荷行为. 结合电化学工作站检测不同样品的光电流, 随着In₂O₃敏化量的改变, 光电流和开路电压也随之改变. 并探讨了In₂O₃敏化ZnO纳米棒阵列光生电荷行为与光电催化活性之间的关系. 结果表明, 适量In₂O₃敏化的ZnO光催化剂在可见光下2 h内对罗丹明B的降解效率达到95%, 是单纯ZnO纳米棒阵列的2.4倍.     

Selective synthesis of CdWO4 short nanorods and nanofibers and their self-assembly

Single-crystalline CdWO₄ nanorods and nanofibers are selectively prepared based on hydrothermal treatment with cetyltrimethylammonium bromide (CTAB) as capping molecule and ordinary inorganic reactant as precursors through exactly controlling the pre-treated condition. With almost uniform breadth and pointed ends, the obtained short nanorods show a relatively thick nature along [010] direction and self-assemble to an ordered structure with (001) and (010) faces, respectively, while the as-prepared nanofibers are flexible and vertically self-assemble to form woven network. The mechanism of selective preparation and self-assembly was also discussed. Both obtained nanorods and nanofibers display a very strong blue-green luminescence property at room temperature.     

Effect of excitation and detection angles on photoluminescence spectrum from ZnO nanorod array

The angular dependent photoluminescence from ZnO nanorod array was investigated. Variations in the excitation and detection angles provided to reveal a blue shift and then splitting of a near-band edge emission into two bands. It is suggested that the observed phenomenon is caused by an inhomogeneous distribution of the emission along the nanorod length. The spatially resolved cathodoluminescence measurements confirmed that indeed the emission along the length of the nanorod is inhomogeneous and the top and bottom parts of the nanorod exhibit different emission spectra.     

Facile synthesis of Nb2O5 nanorod array films and their electrochemical properties

Nb₂O₅ nanorod array films were synthesized by a facile hydrothermal process using niobium metal foil and NH₄F as precursors. The Nb₂O₅ nanorods stand on the niobium metal foil substrate and are less than 100 nm in diameter and about 1 μm in length. X-ray diffraction (XRD) and high resolution transmission electron microscopy (HRTEM) characterizations indicate that these nanorods have orthorhombic structure and grew longitudinally along 〈0 0 1〉 direction. The nanorod growth mechanism was discussed. Thermal annealing at a temperature below 500 °C did not change the microstructure of nanorods but improve the crystallinity. The Nb₂O₅ nanorod array films have been tested as cathode material for lithium battery, which showed a good specific capacity up to 380 mAh g⁻¹ even after 50 charge/discharge cycles.