Direct breath figure formation on PMMA and superhydrophobic surface using in situ perfluoro-modified silica nanoparticles

Breath figure formation was carried out directly on the surface of poly(methylmethacrylate) using a mixture of a good solvent, tetrahydrofuran, and a nonsolvent, water. Direct breath figure formation was coined for this method and a mechanism was proposed to describe the figure formation by the method based on hypothesizes available for the normal breath figure formation. The proposed mechanism is such that the sonication effect, immersion time, and water content on characteristics of the obtained figures can be explained. The figured surface was then made superhydrophobic with a water contact angle of 175° using in situ growing of perfluoro modified silica nanoparticles inside the figure cell by one-pot method. The spherical modified silica nanoparticles were detected being trapped by figure features providing a mechanical entrapment of the low-surface energy nanoparticles. © 2013 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys, 2013     

Enhanced photo-catalytic activity of TiO2 nanostructured thin films under solar light by Sn and Nb co-doping

In this study, preparation of Sn and Nb co-doped TiO₂ dip-coated thin films on glazed porcelain substrates via sol–gel process have been investigated. The effects of co-doping content on the structural, optical, and photo-catalytic properties of applied thin films have been studied by X-ray diffraction (XRD), field emission SEM (FE-SEM), high resolution transmission electron microscopy (HR-TEM), and UV–Vis absorption spectroscopy. Surface chemical state of thin films was examined by atomic X-ray photoelectron spectroscopy (XPS). XRD results suggest that adding impurities has a great effect on the crystallinity and particle size of TiO₂. Titania Rutile phase formation in thin film was promoted by Sn⁴⁺ addition but was inhibited by Nb⁵⁺ doping. The prepared co-doped TiO₂ photo-catalyst films showed optical absorption edge in the visible light area and exhibited excellent photo-catalytic ability for degradation of methylene blue (MB) solution under solar irradiation. Comparison with undoped and Sn or Nb-doped TiO₂, codoped TiO₂ shows an obviously higher catalytic activity under solar irradiation.     

Green,rapid, and highly efficient syntheses of α,α′-bis[(aryl or allyl)idene]cycloalkanones and 2-[(aryl or allyl)idene]-1-indanones as potentially biologic compounds via solvent-free microwave-assisted Claisen–Schmidt condensation catalyzed by MoCl5

A new, green, and highly efficient protocol for the expeditious preparation of some α,α′-bis[(aryl or allyl)idene]cycloalkanones and 2-[(aryl or allyl)idene]-1-indanones via a simple microwave-assisted Claisen–Schmidt condensation reaction catalyzed by MoCl₅ was successfully developed. Outstanding features of the current methodology include the use of solvent-free conditions, simple operation, use of a very inexpensive and available catalyst, low catalyst loading, short reaction times, high yields of the pure products, no harmful by-products, easy workup, and also the applicability of microwave irradiation as a clean source of energy. Furthermore, a gram-scale reaction was successfully conducted, proving the scalability of this current Claisen–Schmidt condensation reaction.     

Spectroscopic analysis of the interaction between Co3O4 nanoparticles and acid phosphatase

Monatshefte für Chemie - Chemical Monthly - In this study, the structure and stability of acid phosphatase in its interaction with Co3O4 nanoparticles are evaluated through absorbance, enzyme...     

Fabrication of Electrochemical Sensor Based on CeO2−SnO2 Nanocomposite Loaded on Pd Support for Determination of Nitrite at Trace Levels

Here, an electrochemical sensor based on CeO₂‐SnO₂/Pd was prepared and used for highly selective and sensitive determination of nitrite in some real samples. This nanocomposite was characterized by various methods like X‐ray photoelectron spectroscopy, X‐ray diffraction, energy dispersive spectroscopy, Fourier‐transform infrared spectroscopy, field emission scanning electron microscopy, and transmission electron microscopy. The electrochemical behavior of the sensor was evaluated by cyclic voltammetry. The results showed excellent catalytic property of the nanocomposite as a an electrocatalyst for nitrite oxidation. In the following, the experimental parameters affecting the analytical signal for nitrite were optimized. Under the optimal conditions, the limit of detection and sensitivity of the sensor were calculated as 0.10 μM and 652.95 μA.mM^?1.cm^?2, respectively. Also, the response of the sensor was linear in the range of 0.36 to 2200 μM of nitrite. Finally, some of the inherent features of the sensor such as repeatability, reproducibility and stability were examined after evaluation of the sensor selectivity in the presence of several interfering species.     

The design of bells with harmonic overtones

Musical bells have had limited application due to the presence of inharmonic partials in the lower part of their acoustic spectra. A series of bells has been designed that contains up to seven partial frequencies in the harmonic series beginning at the fundamental frequency. This was achieved by choosing geometries for finite-element analysis models in which as many purely circumferential bending modes as possible occurred at frequencies below any mode with an axial ring node. The bell models were then fine tuned using gradient projection method shape optimization and the resulting profiles were cast in silicon bronze. A range of bell geometries and timbres is analyzed using psycho-acoustic models and is discussed in relation to European carillon bells.     

A new method for finding the center of gravity of polygons

A direct and easy general method is described for finding the center of gravity of all types of convex and concave polygons such as quadrilaterals, pentagons, hexagons and n-sided polygons.     

ZnBr2 catalyzed domino Knoevenagel-hetero-Diels–Alder reaction: An efficient route to polycyclic thiopyranoindol annulated [3,4-c]quinolone derivatives

Various novel polycyclic thiopyranoindol annulated [3,4-c]quinolone derivatives were synthesized via domino Knoevenagel-hetero-Diels–Alder reactions of indoline-2-thions and novel N-acrylated anthranilaldehydes in refluxing ethanol as a solvent in the presence of 20 mol% ZnBr₂ as a Lewis acid catalyst. All reactions proceed with high yields with excellent regio- and stereoselectivity.     

Synthesis and in vitro antibacterial evaluation of 6-substituted 4-amino-pyrazolo[3,4-<Emphasis Type="Italic">d</Emphasis>]pyrimidines

Pyrazolo[3,4-d]pyrimidines are one of the most important classes of fused heterocyclic compounds which exhibit a broad range of biological and medicinal properties. They are known as anticancer, antifungal, antibacterial, antiviral and anti-inflammatory agents. In this study, some new 6-substituted 4-amino-pyrazolo[3,4-d]pyrimidine derivatives were prepared via reaction of 5-amino-3-methyl-1-phenyl-1H-pyrazole-4-carbonitrile with various nitriles in the presence of sodium ethoxide as catalyst. The inhibitory properties of synthesized compounds were studied according to CLSI guidelines against some pathogenic bacteria including four gram-positive strains (Streptococcus pyogenes, Staphylococcus aureus, Bacillus cereus and Bacillus subtilis subsp. spizizenii) and three gram-negative strains (Pseudomonas aeruginosa, Shigella flexneri and Salmonella enterica subsp. enterica). The antibacterial effects of all derivatives were compared with those of antibiotics belonging to different classes. The values were reported as inhibition zone diameter (IZD), minimum inhibitory concentration (MIC) and minimum bactericidal concentration (MBC). The effect of substituents on the biological activity of derivatives was discussed as well. The inhibitory effect of compound 6a, was shown to be the most, with MIC values in the range of 32–4096 μg/mL. Since most of the synthesized compounds were effective against Streptococcus pyogenes and Pseudomonas aeruginosa, they can be considered as inhibitors of these two bacteria.