数值模拟飞秒激光加热金属的热电子发射

研究了超短超强激光脉冲与薄膜靶相互作用中产生的电子热发射.当超短激光脉冲与薄膜靶相互作用时,首先入射超短脉冲激光对吸收深度内的自由电子进行热激发,接下来热激发电子将能量传递到附近的晶格,再通过电子和晶格二体系的热传导,以及电子晶格间的热耦合,将能量传递到材料的内部.因此,电子在皮秒级甚至更短的时间内不能与晶格进行能量耦合,使电子温度超出晶格温度很多,电子热发射就变得非常明显了.用双温方程联合Richardson-Dushman方程的方法对飞秒脉冲激光照射金属靶的电子热发射进行了研究,结果发现电子热发射对飞     

Ti-45at.% Al合金定向凝固过程中显微组织演化的计算机模拟

采用基于溶质扩散控制模型CA方法对Ti-45at.% Al合金定向凝固过程中显微组织演化过程进行了数值模拟.模拟结果表明,在温度梯度较高时,初生晶核间距无论大小,均可通过分枝或竞争生长而使一次胞晶/枝晶间距得到调整.在抽拉速度一定情况下,随着温度梯度增加,胞晶/枝晶间距减小,在温度梯度一定情况下,随着抽拉速度增大,观察到胞晶/枝晶混合结构,混合结构区随温度梯增大而增大,模拟结果与实验观察相符合. 关键词： Ti-45at.% Al合金 定向凝固 组织演化 数值模拟     

Optical Switching in Silicon Nanowaveguide Ring Resonators Based on Kerr Effect and TPA Effect

We analyze theoretically the 1 × 2 low-power all-optical switching in silicon nanowaveguide ring resonators （RR） based on the Kerr effect and two-photon absorption （TPA）, and give a comparison between both the all-optical switches. The calculation shows that the switching power of the TPA-RR switch is 3 orders smaller than that of the Kerr-RR switch. The switching time for both the switches is about 100ps.     

Annealing effects on the microwave permittivity and permeability properties of Fe79Si16B5 microwires and their micowave absorption performances

This paper reports that amorphous magnetic microwires(Fe79Si16B5) have been fabricated by a melt-extraction technique and have been annealed at 600°C and 750°C respectively.Differential scanning calorimeter measurements show that nanocrystalline magnetic phase(α-Fe) has been formed in the amorphous matrix when it was annealed at 600°C.Hard magnetic phase(Fe2B) was formed in the microwires annealed at 750°C,which increases the magnetic coercivity.Microwave permittivity and permeability are found to be dependent on the microstructures.The permittivity fitting results show that multi Lorentzian dispersion processes exist.For microwires annealed at 750°C,their resonance peaks due to the domain wall movements and natural resonance are found higher than those of microwires annealed at 600°C.The microwave absorption performance of microwires annealed at 600°C is found better than microwires annealed at 750°C.     

Influence of laser mode on splitting beam illumination effect of Dammann grating

The influences of various laser modes on the splitting beam effect of Dammann grating are studied in theory and by numerical simulation. The results show that fundamental mode laser resembles plane wave while high order mode laser differs from plane wave in the splitting beam effect by Dammann grating. Therefore, the fundamental mode laser is more suitable to be the light source to improve the energy efficiency in far-distance image detecting systems, such as laser image ladar, which use Dammann grating in the ilhlmination svstem.     

Bi2Sr2CaCu2O8单晶S-N转变的E-J特性

我们应用脉冲电流的方法测量了Bi2Sr2CaCu2O8单晶在4特斯拉强场下的大电流时等温E－J特性,我们观察到在大电流时,样品电阻率ρ迅速增大,随着电流的继续上升,经过一段正曲率增长阶段,几乎达到饱和值,最后经过一段负曲率上升,达到正常态,显示出完整的S形,应用尹道乐等人的统一物质方程理论,给出了实验曲线较好的数值拟合,根据拟合结构,讨论了理论中各个参量的物理意义。     

La1/8Ca7/8MnO3/Sr0.95Nb0.05TiO3异质结的整流特性和磁输运性质

在5%Nb掺杂的SrTiO3衬底上用磁控溅射法外延生长了La1/aCa7/aMnO3薄膜形成异质结,该异质结有类似于传统P-n结的整流特性.磁场下扩散电压减小,当温度低于130 K以下,扩散电压的减小非常明显.这和在此温度以下,La1/8Ca7/aMnO3出现自旋倾斜态密切相关.我们计算出异质结的结电阻和磁致电阻(MR),在不同大小的正负偏压,不同磁场下,都得到负的MR值.我们给出界面附近的La1/8Ca7/8MnO3的能带结构并分析了外加磁场对洪德耦合,Jahn-Teller畸变等机制的作用,来解释该异质结的磁输运行为.结果有助于了解高Ca掺杂锰氧化物异质结的性质.     

量子纠缠态的普适远程克隆

提出一种任意两粒子纠缠态1→2普适远程克隆方案. 此方案仅需一个特殊的四粒子纠缠态作为量子信道, 就可使处于空间不同位置的两个接收者分别以5/6的保真度得到任意输入态的近似拷贝, 该保真度远高于已有方案中的保真度. 将方案推广到任意两粒子纠缠态1→N(N>2)普适远程克隆的情况, 可使处于不同地点的N个接收者分别以(2N+1)/(3N)的保真度得到输入态的近似拷贝. 另外, 提出一种以上述单个特殊四粒子纠缠态作为量子信道, 在多目标量子比特受控非门和 关键词： 量子纠缠态 普适远程克隆 保真度     

A Scheme for Generating Entangled Squeezed States Based on Cavity QED

We propose a scheme for generating entangled squeezed vacuum states of electromagnetical fields. The scheme is based on cavity QED. In this scheme, an atom interacts, successively, with a classical field, two quantum cavity fields, and another classical field. By detecting the final states of the atom, the two quantum cavity fields will be projected to an entangled state.