Curdlan as a Polymeric Starting Material to Access C6-Modified Glucose Derivatives

We evaluated the potential of a linear β-1,3-glucan (curdlan) as a starting material to access C6-modified glucose derivatives and found that 6-bromo-6-deoxyglucose, 6-azide-6-deoxyglucose, and 6-acetamido-6-deoxyglucose could be readily prepared from curdlan through its C6-selective and quantitative modifications and subsequent acid-catalyzed hydrolysis.     

Efficient and enantioselective total syntheses of heliannuols A and K

The second-generation enantioselective synthesis of heliannuol A and the first enantioselective total synthesis of heliannuol K (via two routes) have both been accomplished efficiently; (heliannuol A, nine steps and 25% yield; heliannuol K, seven steps and 47% yield). Highlights of our synthetic strategy include a substrate-controlled chirality transfer in the Lewis acid mediated Claisen rearrangement of the allyl aryl ether for the key construction of a tertiary stereogenic center at the benzylic position followed by, for heliannuol A, ring-closing metathesis, diastereoselective epoxidation, and regioselective cleavage of the epoxide; and for heliannuol K, ring-closing metathesis and conjugate reduction of the eight-membered enone.     

Synthesis and optical properties of fluorene‐based polymers incorporating organosilicon unit

The synthesis and optical properties of polymers bearing the repeating unit of terfluorene and various organosilicon groups were investigated. Polymers with high molecular weight and good solubility could be obtained by Suzuki coupling polymerization from silylene‐containing fluorene‐based dibromo monomers and 9,9‐dihexylfluorene‐2,7‐bis(trimethyleneborate). From UV spectra of polymers bearing acyclic silylene bridge, the organosilicon units not only interrupted a π‐conjugation but also contributed to an electronic communication between connected fluorenes. The emission maximum wavelengths (ca. 400 nm) blue‐shifted when compared with that of polyfluorene (418 nm) and the fluorescence quantum yields were considerably high (>0.82) in the CHCl₃ solution. On the other hand, rather broad emission was observed at 480 nm and the fluorescence quantum yield was quite low (0.004) in the solution‐state PL spectrum of tetraphenylsilole‐containing polymer. The polymer emitted visible green light in the spin‐coated film. The fluorescence peak intensity at 486 nm gradually decreased when the film was illuminated with the UV light of 359 nm in air. © 2007 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 45: 4786–4794, 2007     

High Ethene/Ethane Selectivity in 2,2′‐Bipyridine‐Based Silver(I) Complexes by Removal of Coordinated Solvent

Following removal of coordinated CH₃CN, the resulting complexes [Ag^I(2,2′‐bipyridine)][BF₄] ( 1 ) and [Ag^I(6,6′‐dimethyl‐2,2′‐bipyridine)][OTf] ( 2 ) show ethene/ethane sorption selectivities of 390 and 340, respectively, and corresponding ethene sorption capacities of 2.38 and 2.18 mmol g^?1 when tested at an applied gas pressure of 90 kPa and a temperature of (20±1) °C. These ethene/ethane selectivities are 13 times higher than those reported for known solid sorbents for ethene/ethane separation. For 2 , ethene sorption reached 90 % of equilibrium capacity within 15 minutes, and this equilibrium capacity was maintained over the three sorption/desorption cycles tested. The rates of ethene sorption were also measured. To our knowledge, these are the first complexes, designed for olefin/paraffin separations, which have open silver(I) sites. The high selectivities arise from these open silver(I) sites and the relatively low molecular surface areas of the complexes.     

Organosulfide‐Catalyzed Diboration of Terminal Alkynes under Light

An efficient metal‐free diboration of terminal alkynes is reported. In the presence of a catalytic amount of organosulfides under light, the addition of bis(pinacolato)diboron (B₂pin₂) to terminal alkynes takes place efficiently to produce the corresponding double borylation products in good yields. Mechanistic studies indicate that this metal‐free sulfide‐catalyzed diboration of alkynes likely occurs by generation of a boryl‐centered radical with the aid of light and a sulfide, since such a radical was detected in the reaction mixture by electron spin resonance (ESR) spectroscopy. The present form of catalysis (sulfide/light) is thought to be unprecedented and provides a new means of preparation for organoboranes without heavy metal contamination in the products, which is highly desired in the preparation of drugs and electronic materials.