Synthesis and toxicity assay of ceramic nanophosphors for bioimaging with near-infrared excitation

Yttrium hydroxyl carbonate (Y(OH)CO₃) precursors were synthesized by the homogeneous co-precipitation method in the presence of polyacrylic acid (PAAc). Resultant precursor particle size is about 15–20 nm with narrow size distribution whereas the particle size is smaller than those acquired by the conventional homogeneous precipitation method. Effective decrease of Y(OH)CO₃ particle size was found to be higher for the presence of weak polyanionic ionomer such as PAAc than the presence of strong polyanionic ionomer such as sodium polystyrene sulfonate (PSS). It was observed that the morphology and size of the precursors are almost unchanged after the calcination process. Er³⁺ doped Y₂O₃ nanoparticles were synthesized by PAAc assisted homogeneous co-precipitation method showed bright green (550 nm) and red (660 nm) upconversion (UC) as well as near-infrared (NIR) fluorescence (1550 nm) under 980-nm excitation. UC and NIR fluorescence bioimaging and in-vitro cytotoxicity assay of Er³⁺ doped Y₂O₃ nanoparticles were successfully attempted with commercially available macrophages and B-cell hybridomas. Cellular uptake of nanoparticles is evidenced from bright field, UC and NIR fluorescence images of macrophages.     

XANES speciation of mercury in three mining districts – Almadén,Asturias (Spain), Idria (Slovenia)

The mobility, bioavailability and toxicity of mercury in the environment strongly depend on the chemical species in which it is present in soil, sediments, water or air. In mining districts, differences in mobility and bioavailability of mercury mainly arise from the different type of mineralization and ore processing. In this work, synchrotron‐based X‐ray absorption near‐edge spectroscopy (XANES) has been taken advantage of to study the speciation of mercury in geological samples from three of the largest European mercury mining districts: Almadén (Spain), Idria (Slovenia) and Asturias (Spain). XANES has been complemented with a single extraction protocol for the determination of Hg mobility. Ore, calcines, dump material, soil, sediment and suspended particles from the three sites have been considered in the study. In the three sites, rather insoluble sulfide compounds (cinnabar and metacinnabar) were found to predominate. Minor amounts of more soluble mercury compounds (chlorides and sulfates) were also identified in some samples. Single extraction procedures have put forward a strong dependence of the mobility with the concentration of chlorides and sulfates. Differences in efficiency of roasting furnaces from the three sites have been found.     

Determination of adsorption heats of individual adsorption complex by combination of microcalorimetry and FTIR spectroscopy

Adsorption of CO as a probe molecule on K-FER zeolites differing in Si/Al ratio was investigated. Successful determination of adsorption heats of individual adsorption complexes formed upon adsorption of CO molecules on K-FER zeolites at 300 K by combination of IR spectroscopy with adsorption microcalorimetry is reported. Adsorption heat of bridged carbonyl complexes, where CO molecule interacts with two nearby extraframework K⁺ cations, was experimentally determined for the first time. It was found that bridged complexes on dual cationic sites exhibit adsorption heat of 34.8 kJ mol^?1, whereas monodentate carbonyls on single isolated K⁺ cation exhibit adsorption heat of only 26.2 kJ mol^?1 and adsorption heat of isocarbonyls was 21.5 kJ mol^?1.     

Binding of Dopamine to Alpha-Synuclein is Mediated by Specific Conformational States

Parkinson’s disease is the second most common neurodegenerative disorder, in which both alpha-synuclein (α-syn) and dopamine (DA) have a critical role. α-Syn is known to be natively unstructured in equilibrium with subpopulations of more compact structures. It is these compact structures that are thought to be linked to amyloid formation. In the presence of DA, α-syn yields a diverse range of SDS-resistant, non-amyloid oligomers, however the precursor state conformation has not been established. Here, three DA molecules have been observed to bind per α-syn monomer by electrospray-ionization-ion mobility spectrometry-mass spectrometry (ESI-IMS-MS). Each of these DA molecules binds exclusively to the extended conformation of α-syn, and binding is not observed in the compact state of the protein. Measurements of collisional cross sectional areas show that the incremental uptake of DA pushes the protein towards a highly extended population, becoming fully populated upon the binding of three DA ligands. Tyrosine (Tyr) as a closely related structural analog, exhibited limited binding to the protein as compared with DA, with a maximum of two ligands being observed. Those Tyr ligands that do bind were observed as adducts to the extended conformation akin to DA. These findings suggest DA is able to modulate α-syn self-assembly by inducing the population of a highly extended state.

An automated headspace solid-phase microextraction followed by gas chromatography–mass spectrometry method to determine macrocyclic musk fragrances in wastewater samples

A fully automated method has been developed for determining eight macrocyclic musk fragrances in wastewater samples. The method is based on headspace solid-phase microextraction (HS-SPME) followed by gas chromatography–mass spectrometry (GC-MS). Five different fibres (PDMS 7 μm, PDMS 30 μm, PDMS 100 μm, PDMS/DVB 65 μm and PA 85 μm) were tested. The best conditions were achieved when a PDMS/DVB 65 μm fibre was exposed for 45 min in the headspace of 10 mL water samples at 100 °C. Method detection limits were found in the low ng L^?1 range between 0.75 and 5 ng L^?1 depending on the target analytes. Moreover, under optimized conditions, the method gave good levels of intra-day and inter-day repeatabilities in wastewater samples with relative standard deviations (n?=?5, 1,000 ng L^?1) less than 9 and 14 %, respectively. The applicability of the method was tested with influent and effluent urban wastewater samples from different wastewater treatment plants (WWTPs). The analysis of influent urban wastewater revealed the presence of most of the target macrocyclic musks with, most notably, the maximum concentration of ambrettolide being obtained in WWTP A (4.36 μg L^?1) and WWTP B (12.29 μg L^?1), respectively. The analysis of effluent urban wastewater showed a decrease in target analyte concentrations, with exaltone and ambrettolide being the most abundant compounds with concentrations varying between below method quantification limit (<MQL) and 2.46 μg L^?1.

Properties of two amide‐based hydrophilic interaction liquid chromatography columns

Hydrophilic interaction liquid chromatography is a separation technique suitable for the separation of moderately and highly polar compounds. Various stationary phases (SPs) for hydrophilic interaction liquid chromatography are commercially available. While the SPs based on the same type of ligand are available from different providers, they can display a distinct retention characteristics and separation selectivity. The current work is focused on characterization and comparison of the separation systems of two amide‐based HPLC columns from two producers, i.e. XBridge Amide column and TSK gel Amide‐80 column. Several characterization procedures (tests) were used to investigate the differences between these columns. The chromatographic behavior of selected analytes indicates that multimodal interactions are responsible for retention and separation on these columns. Multiple testing approaches were used in order to reveal subtle differences between the SPs. Both amide‐based columns showed certain differences in retention, selectivity, and plate counts. Based on the tests used in this study, we conclude that the investigated columns provide a different degree of H‐bonding interactions.     

Ion‐Transfer Electrochemistry of Rat Amylin at the Water–Organogel Microinterface Array and Its Selective Detection in a Protein Mixture

The behavior of proteins and polypeptides at electrified aqueous–organic interfaces is of benefit in label‐free detection strategies. In this work, rat amylin (or islet amyloid polypeptide) was studied at the interface formed between aqueous liquid and gelled organic phases. Amylin is a polypeptide that is co‐secreted with insulin from islet beta‐cells and is implicated in fibril formation. In this study, rat amylin was used, which does not undergo aggregation. The polypeptide underwent an interfacial transfer process, from water to the gelled organic phase, under applied potential stimulation. Cyclic voltammetry revealed steady‐state forward and peak‐shaped reverse voltammograms, which were consistent with diffusion‐controlled water‐to‐organic transfer and thin‐film stripping or desorptive back‐transfer. The diffusion‐controlled forward current was greater when amylin was present in an acidic aqueous phase than when it was present in an aqueous phase at physiological pH; this reflects the greater charge on the polypeptide under acidic conditions. The amylin transfer current was concentration dependent over the range 2–10 μM , at both acidic and physiological pH. At physiological pH, amylin was selectively detected in the presence of a protein mixture, which illustrated the bioanalytical possibilities for this electrochemical behavior.     

Biparametric potentiometric analytical microsystem for nitrate and potassium monitoring in water recycling processes for manned space missions

The construction and evaluation of a Low Temperature Co-fired Ceramics (LTCC)-based continuous flow potentiometric microanalyzer prototype to simultaneously monitor the presence of two ions (potassium and nitrate) in samples from the water recycling process for future manned space missions is presented. The microsystem integrates microfluidics and the detection system in a single substrate and it is smaller than a credit card. The detection system is based on two ion-selective electrodes (ISEs), which are built using all-solid state nitrate and potassium polymeric membranes, and a screen-printed Ag/AgCl reference electrode. The obtained analytical features after the optimization of the microfluidic design and hydrodynamics are a linear range from 10 to 1000 mg L⁻¹ and from 1.9 to 155 mg L⁻¹ and a detection limit of 9.56 mg L⁻¹ and 0.81 mg L⁻¹ for nitrate and potassium ions respectively.