三包层WⅠ和WⅡ型单模光纤波导色散特性的研究

研究了三包层WⅠ和WⅡ型单模光纤的波导色散特性。结果发现在相同条件下，三包层WⅠ和WⅡ型单模光纤零色散点的调节范围比传统的双包层W型单模光纤明显增大。详细分析了几何参量P、Q和光学参量R1、R2对单模传输时的波导色散特性和低次模截止频率的影响。所得的研究结果为获得更为理想的色散补偿、色散平坦光纤及设计新型无源光器件提供了重要的依据。计算波导色散的方法可推广到多包层光纤。     

单晶光纤损耗谱测量装置

本文描述了一套用以测量单晶光纤损耗谱的装置。本装置由卤钨灯,单色仪,积分球,AgORbCs光电倍增管以及数据采集,处理和控制系统组成。可测量300～1150nm的光谱范围。利用本装置可获得单晶光纤的吸收光谱,透过率谱,散射光谱以及散射位置谱。     

Optical current transducer with bulk type Bi12SiO20 faraday sensor for power systems

Two types of optical current transducers (OCTs) have a bulk Faraday sensor inserted into the gap of an iron core and a porcelain insulator with optical fiber. The sensor consists of Bi₁₂SiO₂₀ (BSO) single crystal, a polarizer, and an analyzer. The OCTs satisfied the target performance requirement for fault location and metering and demonstrated maintained performance at some power utilities in Japan and the US. We have developed a fault location system that immediately detects the fault current with the OCTs, there by locating the fault section. The OCT can easily replace the existing support insulators for the disconnecting switch without any modifications to structure height or bus-bar. For metering requiring 0.3% class accuracy, use of a BSO with right optical rotatory power combined with BSO with left optical rotatory power results in a Faraday sensor with improved temperature characteristics. The OCT demonstrated 0.3% class accuracy for metering described in the current transformer Specifications of IEEE C57–13, 1993.     

光纤液位传感器检测原理探讨

叙述光纤液位传感器在贮油罐中的应用,提出实验所采用的方案。推导出液面高度公式,比较实现检测的两种电路的优缺点,同时对实验精度和测量范围进行了讨论。     

On Two Parallel Matched Gratings Demodulation Method of Fiber Grating Strain Sensor

The method of demodulation with two parallel matched fiber Bragg gratings( FBGs)system is introduced to enlarge the range of strain that can be detected by the FBG sensor system.     

Simplified analytic solutions and a novel fast algorithm for Yb-doped double-clad fiber lasers

In this paper, continuous wave Yb³⁺-doped double-clad fiber lasers (DCFLs) with linear-cavity are investigated theoretically and numerically using the rate equations. Under the steady state conditions, the simplified analytic solutions of Yb³⁺-doped DCFLs under considering the scattering loss are deduced in the strongly pump condition. Compared with the known analytic solutions in published literatures, our analytic solutions are more accurate, especially, at higher reflectivity of output mirror. In addition, a fast and stable algorithm based on the Newton-Raphson method is proposed to simulate numerically Yb³⁺-doped DCFLs. The results by simplified analytic solutions are in good agreement with those by the numerical simulation. Moreover, we have performed the optimization of an Yb³⁺-doped DCFL using the simplified analytic solutions and the numerical simulations, respectively.     

掺铒光纤放大器中上转换过程的影响

掺杂浓度的提高影响了掺铒光纤放大器(EDFA)的性能,对经典Giles模型提出了新的要求。首先研究了高掺杂下铒离子距离较小引起的上转换过程的机理,通过优化速率方程模型分析了上转换过程对EDFA的影响,得出了在泵浦光和信号光远远大于ASE光的假设下泵浦光和信号光沿光纤长度变化的近似表达式,并将该近似分析解与解析解进行了比较。仿真结果表明上转换过程会降低随光纤传输的信号光和泵浦光,影响EDFA的放大性能,并得出了当掺铒浓度大于2.95×1025m-3时,上转换过程的影响不能忽略的结论。     

Isomorphisms of fiber spaces over Teichmüller spaces

We will be mainly concerned with some important fiber spaces over Teichmuller spaces, including the Bers fiber space and Teichmuller curve, establishing an isomorphism theorem between "punctured" Teichmuller curves and determining the biholomorphic isomorphisms of these fiber spaces.     

Simultaneous Measurement of Particle Size and Particle Velocity by the Spatial Filtering Technique

The objective of this study was to compare the measuring results of a fiber‐optical probe based on a modified spatial filtering technique with given size distributions of different test powders and also with particle velocity values of laser Doppler measurements. Fiber‐optical spatial filtering velocimetry was modified by fiber‐optical spot scanning in order to determine simultaneously the size and the velocity of particles. The fiber‐optical probe system can be used as an in‐line measuring device for sizing of particles in different technical applications. Spherical test particles were narrow‐sized glass beads in the range 30–100 μm and irregularly shaped test particles were limestone particles in the range 10–600 μm. Particles were dispersed by a brush disperser and the measurements were carried out at a fixed position in a free particle‐laden air stream. Owing to the measurement of chord lengths and to the influence of diffraction and divergent angle, the probe results show differences from the given test particle sizes. Owing to the particle‐probe collisions, the mean velocity determined by the probe is smaller than the laser Doppler mean velocity.     

应用LiNbO_3声表面波驱动的全光纤声光频移器

介绍一种工作在10.7MHz的全光纤声光频移器.它由在LiNbO_3基片上制作的叉指电极换能器产生的声表面波驱动.当驱动电功率1.5W时,频移光转换效率达35％.