气固射流床射流深度的研究

在３００×５１×２６００ｍｍ的二维射流床中，采用多路毕托管测试系统，对包括三种双组份混合物在内的五种物料的射流深度进行了考察。结果表明，射流管径、射流气速对射流深度都有影响，本文尤其考察了环隙气量与射流深度的关系，发现在同样的射流气速下，环隙气速增大则射流深度降低，得出了综合各种影响因素的关联式。     

Influence of Cyclodextrin Complexation on the in vitro Human Skin Penetration and Retention of the Sunscreen Agent, Oxybenzone

The objective of this study was to investigate the influence of cyclodextrins on the cutaneous availability of the sunscreen oxybenzone. The interaction between oxybenzone and hydrophilic α-, β- and γ-cyclodextrin derivatives was studied in water by phase-solubility analysis. Among the available cyclodextrins, hydroxypropyl-β-cyclodextrin (HP-β-CD) and especially sulfobutylether-β-cyclodextrin (SBE-β-CD) had the greatest solubilizing activity. Ethanol–water solutions containing oxybenzone free or complexed with HP-β-CD or SBE-β-CD were applied to human skin in Franz diffusion cells and the amount of sunscreen permeated into the different cutaneous compartments was determined by HPLC. As much as 20.5% of the oxybenzone applied dose diffused within the skin tissue after 6 h application. Between 39.4% and 54.9% of the penetrated UV filter was localized in the stratum corneum, with no significant difference between uncomplexed oxybenzone or its complex with HP-β-CD. Conversely, the amount retained in the stratum corneum was markedly decreased (ca. 50%) by complexation with SBE-β-CD. Considerable quantities of oxybenzone accumulated into the viable epidermis (5.7% of the applied dose) and dermis (6.2% of the applied dose) from the preparation containing the free UV filter. The sunscreen penetration to the deeper living layers of the skin was remarkably lower (1.0% and 2.0% of applied dose for epidermis and dermis, respectively) upon application of the sunscreen complexed with SBE-β-CD, whereas HP-β-CD had no effect. In addition, photostability experiments demonstrated that SBE-β-CD complexation did not alter the sunscreen photochemical properties.     

Real-time onboard wind and windshear determination,part 2: Detection

This paper is concerned with windshear detection in connection with real-time wind identification (Ref. 1). It presents a comparative evaluation of two techniques, one based on the shear/downdraft factor and one based on the wind difference index. The comparison is done with reference to a particular microburst, that which caused the 1985 crash of Flight Delta 191 at Dallas-Fort Worth International Airport.The shear/downdraft factor has the merit of combining the effects of the shear and the downdraft into a single entity. However, its effectiveness is hampered by the fact that, in a real situation, the windshear is accompanied by free-stream turbulence, which tends to blur the resulting signal. In turn, this results in undesirable nuisance warnings if the magnitude of the shear factor due to free-stream turbulence is temporarily larger than that due to true windshear. Therefore, proper filtering is necessary prior to using the shear/downdraft factor in detection and guidance. One effective way for achieving this goal is to average the shear/downdraft factor over a specified time interval . The effect of on the average shear/downdraft factor is studied.     

Real-time onboard wind and windshear determination,part 1: Identification

Standard wind identification techniques employed in the analysis of aircraft accidents are post-facto techniques; they are processed after the event has taken place and are based on the complete time histories of the DFDR/ATCR data along the entire trajectory. By contrast, real-time wind identification techniques are processed while the event is taking place; they are based solely on the knowledge of the preceding time histories of the DFDR/ATCR data.In this paper, a real-time wind identification technique is developed. First, a 3D-kinematic approach is employed in connection with the DFDR/ATCR data covering the time interval preceding the present time instant. The aircraft position, inertial velocity, and accelerometer bias are determined by matching the flight trajectory computed from the DFDR data with the flight trajectory available from the ATCR data. This leads to a least-square problem, which is solved analytically every seconds, with / small.With the inertial velocity and accelerometer bias known, an extrapolation process takes place so as to predict the inertial velocity profile over the subsequent -subinterval. At the end of this subinterval, the extrapolated inertial velocity and the newly identified inertial velocity are statistically reconciled and smoothed. Then, the process of identification, extrapolation, reconciliation, and smoothing is repeated. Subsequently, the wind is computed as the difference between the inertial velocity and the airspeed, which is available from the DFDR data. With the wind identified, windshear detection can take place (Ref. 1).As an example, the real-time wind identification technique is applied to Flight Delta 191, which crashed at Dallas-Fort Worth International Airport on August 2, 1985. The numerical results show that the wind obtained via real-time identification is qualitatively and quantitatively close to the wind obtained via standard identification. This being the case, it is felt that real-time wind identification can be useful in windhsear detection and guidance, above all if the shear/downdraft factor signal is replaced by the wind difference signal (Ref. 1).This paper and its companion (Ref. 1) are based on Refs. 2–4.This research was supported by the Aviation Research and Education Foundation and by Texas Advanced Technology Program, Grant No. TATP-003604020.     

A stratospheric chemical reaction controlling climatic change

It has been established from geological studies that change in the atmospheric content of carbon dioxide gas commenced about one hundred million years ago. The likely origin of this change is advanced as being the onset of the Brewer circulation caused by the rise in terrain induced by tectonic plate movement. It is demonstrated that tectonic plate movement can be affected by impacts from external bodies which penetrate the crust of the Earth. The consequences of the change in atmospheric concentration of carbon dioxide are proposed as first, extinctions and reductions in animal numbers, including primates, as a result of changes in body chemistry of these animals and second, a change in the rate of weathering of rocks giving rise to changes in the availability of chemicals such as calcium and potassium which are essential for plant and animal life. This latter change contributing to the extinctions and reductions in animal numbers. It is shown that the change in weathering can account for the rise to dominance of angiosperm plants. It is concluded that there were several simultaneous evolutionary environments on Earth which were a function of altitude which gave rise to a vertical variation in atmospheric content of carbon dioxide. This variation disappeared with rise of terrain and the onset of the Brewer circulation. Such changes are advanced and being much more important than any changes in temperature caused by greenhouse effects since the disappearance of atmospheric variations in carbon dioxide allowed animal migration. It is demonstrated that the conditions of extinction could be reintroduced by human activities.     

考虑防御系统延迟使其预测误差最大的突防弹道设计

对中段多脉冲机动突防弹道的设计问题进行了研究。采用的原理与方法有别于成熟的航天器多脉冲变轨,而是基于路径规划的思想对弹道设计问题简化。考虑敌方防御系统延迟,改进多脉冲点火模型,并基于变射面的思想对关机点参数进行了设计及优化。然后,从使敌方预测误差最大的角度提出评价函数,并利用遗传算法进行优化。最后,给出了一种同时满足导弹机动突防与打击精度要求的多脉冲弹道设计方法。从模型的可行性,方法的有效性、灵活性、迭代效率及精度等方面进行了仿真验证分析。在PC机仿真中,20 s内就设计出一条保证打击精度的中段突防弹道。结果表明,建立的模型是可行的,提出的突防弹道设计方法是快速有效的。     

Time domain identification and ranking of noise sources in a pneumatic nail gun

This paper investigates the noise sources in a pneumatic nail gun. The study combines two complementary experimental approaches. The first uses simultaneous data observation, with sound, acceleration and air pressure signals simultaneously recorded in conjunction with a nail gun motion high speed video. This strategy allows the identification of the physical processes involved in the operation of the machine at different time instants, as well as the associated noise generation mechanisms. However, since multiple noise sources radiate at the same time, this observation technique is not sufficient for noise source identification and ranking. Thus, a second approach introduces a selective wrapping procedure, and the strategy assures a reliable classification of the noise sources. The investigation considers the following noise origins: the air exhaust, the machine body and the workpiece/worktable.     

Catalytic activity of Pt and Pd in gaseous reactions of H2 and CH4 oxidation at low pressures

1. Download : Download high-res image (85KB)
2. Download : Download full-size image

     

Effective detection of benzoyl peroxide in flour based on parameter selection of Raman hyperspectral system

Penetration depth and spatial resolution of Raman hyperspectral imaging system were studied for effective detection of benzoyl peroxide in flour. The determinations of parameters were achieved by using the single-band background-correct image of a benzoyl peroxide Raman characteristic band and a simple threshold method. The selected parameters were used to detect mixture samples with different concentrations. Percentage of detected benzoyl peroxide pixels was positively correlated to its concentration. The result shows that parameters selected in this study are effective for the detection of benzoyl peroxide additive in flour and can be used for quantitative analysis in the future.