Analogues of Coherent and Dissipative Structures in Social and Historical Processes

An analogy between social and hydrodynamic processes is developed. The relation of the state system to the passionarity theory suggested by L. N. Gumilev is discussed.     

Dynamics of Random One-Dimensional ±J Systems

Finite chains of a two-state random Potts spin model with periodic boundary conditions are studied within Glauber dynamics. The spin exchange is assumed random with frustration between ferro and antiferromagnetic values (±J). Time-dependent fluctuations are induced by periodic temperature oscillations. Master type differential equations for spin correlation functions are solved within linear response theory. The spectrum of relaxation times are calculated at different temperatures. The ±J Potts glass chains undergo a zero temperature phase transition. The barriers against inversion of the spin chain take only two values; 0 and 2|J|. The temperature behaviour of specific heat is characterized by rounded peaks. The frequency dependence displays two plateaus for the real part of specific heat and two corresponding peaks for the imaginary part. The dynamic specific heat is not affected by the longest relaxing mode like susceptibility. The time separation of the modes is demonstrated by the Cole-Cole plots.     

灰色模型的最优化及其参数的直接求法

基于灰色模型的内涵表达式和白化方程响应式均为等比级数的观点,提出了一种不用求ago值、均值,不涉及灰色微分方程,白化微分方程概念,直接求灰色模型参数a,c的方法,通过此方法建立的新模型不仅从理论上可保证是在满足给定评价标准为模拟绝对误差平方和最小(或模拟相对误差平方和最小)、给定精度条件下的最优化模型,从而结束了灰色模型只有更优,没有最优的历史.并从理论上证明了新模型具有白化指数律重合性、白化系数律重合性,伸缩变换一致性.最后通过实例编程验证该方法具有可操作性,且预测精度高,效果好.     

Number albedo measurements from stratified layers of iron,concrete and aluminium

A layer of stratified combination composed of selected radiation shielding materials acquires better shielding property. Albedo is used in such measurements as an integral measure ofγ-ray scattering. The stratified slabs of alternating heterogeneous layers have been found to have a virtual homogeneous property with a definite effective atomic number. The angular distribution of back-scattered photons as well as the total number albedo values for iron, aluminium and concrete in stratified combination for 662 keV and 1250 keV photons are reported.     

Experimental verification of drop/impact simulation for a cellular phone

Conducting drop tests to investigate impact behavior and identify failure mechanisms of small-size electronic products is generally expensive and time-consuming. Nevertheless, strict drop/impact performance criteria for hand-held electronic products such as cellular phones play a decisive role in the design because they must withstand unexpected shocks. The design of product durability on impact has heavily relied on the designer's intuition and experience. In this study, a reliable drop/impact simulation for a cellular phone is carried out using the explicit code LS-DYNA. Subsequently globallocal experimental verification is accomplished by means of high-speed photography and impact response measurement. Using this methodology, we predict potential damage locations in a cellular phone and compare them with real statistical data. It is envisaged that development of a reliable methodology of drop/impact simulation will provide us with a powerful and efficient vehicle for improvement of the design quality and reduction of the product development cycle.     

用于双光子激发荧光寿命显微成像的高重复频率皮秒扫描相机

建立了一台基于新研制的高重复频率皮秒扫描相机的双光子激发荧光寿命显微成像系统,重点介绍所研制的高重复频率皮秒扫描相机。为了在高时间分辨力的同时扩大时间测量范围,实现大面积两维空间高时间分辨取样测量,从而提高采样速率和更有效地发挥扫描相机的作用,设计和研制了一种大面积、高时间分辨力扫描变像管和一种重复频率高达1MHz的斜坡电压扫描电路。基于上述关键部件所研制的扫描相机具有重复频率高、扫描速度可调、时间分辨力高、工作面积大、非线性低、触发晃动小等优点。用钛宝石飞秒激光器作为激光脉冲源,通过脉冲提取器将76MHz的高重复频率降低为1MHz,采用可调延时器和标准具对扫描相机的时间分辨力、扫描速度和非线性进行标定。该系统的时间分辨力达到6.5ps,非线性为2.60%,可测量的时间范围从十几皮秒到几十纳秒。测量了若丹明6G和香豆素314两种标准荧光染料的荧光寿命,取得了与参考文献一致的实验结果。     

葛仙米对丁草胺胁迫的响应

研究了丁草胺对可食用蓝藻葛仙米(Nostoc sphaeroides)生理和代谢活性的影响．用不同浓度的丁草胺处理葛仙米,结果显示低浓度(5 mg·L-1)丁草胺使其光合作用、呼吸作用和光合系统Ⅱ活性增强,高浓度丁草胺(>5 mg·L-1)限制其光合作用、呼吸作用和光合系统Ⅱ活性．同时丁草胺对葛仙米膜结构和功能具有破坏作用,随着丁草胺处理浓度增大,质膜透性不断增大,丙二醛和超氧自由基阴离子含量升高；在低浓度丁草胺处理时,类胡萝卜素含量增加,超氧化物歧化酶(SOD)活性增强,高浓度丁草胺处理时,类胡萝卜素含量降低,SOD活性下降；表明葛仙米对低浓度的丁草胺胁迫具有一定的耐受能力,但高浓度的丁草胺对其生理和代谢构成威胁；针对目前葛仙米野生生境中丁草胺的用量,建议限制丁草胺在葛仙米产地的使用,以保护日益稀缺的葛仙米资源．     

The response of microstructure to processing in a series of poly(siloxaneimide) copolymers

Poly(siloxaneimide) (PSI) segmented copolymers exhibit organized microdomains if the blocks are sufficiently incompatible. As with neat diblock and triblock copolymers, the processing route employed to prepare films of PSI materials is expected to influence the dimensions and/or morphology of the resultant microstructure. In this work, small-angle neutron scattering (SANS) is utilized to characterize the disordered microstructure found in films of a series of PSI copolymers which are subjected to solvent casting and various thermal treatments. Microstructural dimensions such as the periodicity and correlation length are deduced from the Teubner-Strey (TS) model for disordered microemulsions. The scattering intensity of each copolymer up to q = 5.0 nm^?1, where q is the scattering vector, is found to scale as q^?2.8+?0.1. Results indicate that processing the materials as cast films or as melt-pressed films allowed to cool slowly has a small, but discernible, effect on microstructural characteristics. SANS profiles of films quenched from elevated temperatures reveal a clear transition in microdomain periodicity, which correlates well with the glass transition temperature of the imide microphase in these and other materials of similar chemical structure. © 1993 John Wiley & Sons, Inc.     

Experimental investigation on large deflection response of a frame impacted by a moving body

This paper reports on the experimental investigation of the dynamic large deflection response of a portal frame impacted at its midspan by a body moving at a certain speed. Both the deflection and velocity vs. time curves of the midspan and the dynamic history of a number of desired locations were recorded during the process of response. On the basis of the test data, the momentum and kinetic energy conversion between the frame and the moving body in the impact process are realized, and the occurrence and expansion of plastic regions are described. Investigation results show that the initial collision is approximately ideally inelastic, and that the elastic deformation plays a considerable role in the response though the input energy is much larger than the maximum elastic energy capacity of the beam member; therefore, in a general impact, the energy ratio should not be regarded as a sufficient criterion for a rigid—plastic solution. The ratios of the impulse transferred to and the energy absorbed by the frame in the initial collision to that carried by the moving body before impact is only related to the ratiobetween the equivalent mass of the frame paticipating in the initial collision and the mass of the impacting body, having nothing to do with the impacting velocity to a certain extent.