考虑单元劈裂的流-固耦合连续-非连续方法及定向水力压裂模拟

为了更真实地模拟水力压裂过程中的岩石变形、裂缝扩展及流体流动,在自主开发的拉格朗日元与离散元耦合的连续-非连续方法的基础上,发展了一种流-固耦合方法。在该方法中,裂缝可沿四边形单元对角线和单元边界扩展,流体流动满足立方定律。通过与单一裂缝非稳态渗流模型及KGD模型的理论解进行对比,验证了该方法的正确性。由定向射孔水力压裂的模拟结果可以发现,(1)距离射孔越远,流体压力越小;随着时间的增加,裂缝中流体压力降低。(2)随着射孔角度的增加,裂缝起裂和扩展过程中的流体压力及转向距离增加;随着x方向水平应力的增加,裂缝起裂和扩展过程中的流体压力增加;两个方向水平应力之差越大,裂缝转向距离越小。(3)随着时间的增加,裂缝区段数目的增速变慢,这与裂缝体积增加变快有关。     

Theoretical analysis of magnetic sensor output voltage

The output voltage is an important parameter to determine the stress state in magnetic stress measurement, the relationship between the output voltage and the difference in the principal stresses was investigated by a comprehensive application of magnetic circuit theory, magnetization theory, stress analysis as well as the law of electromagnetic induction, and a corresponding quantitative equation was derived. It is drawn that the output voltage is proportional to the difference in the principal stresses, and related to the angle between the principal stress and the direction of the sensor. This investigation provides a theoretical basis for the principle stresses measurement by output voltage.     

Abnormal levels of seven amino neurotransmitters in depressed rat brain and determination by HPLC‐FLD

The determination of amino acids with actions like neurotransmitters or modulators has been increasingly important for diagnosis in many neuropsychiatric diseases. A rapid and simple high‐performance liquid chromatography with fluorescence detection method was developed for simultaneous determination of seven amino acids: aspartate (Asp), glutamate (Glu), serine (Ser), glutamine (Gln), glycine (Gly), taurine (Tau) and γ‐aminobutyric` acid (GABA). Homoserine was used as an internal standard. The analysis was performed on a BDS column with methanol and 50 mm sodium acetate solution (pH 6.5) using a simple gradient elution. Several parameters of the developed method were validated including linearity, accuracy, precision, extraction recovery and stability, which were within the acceptable range. The method was successfully applied to determination of real samples: hippocampus and cortex in depressed rats exposed to chronically unpredictable stress in order to study if there existed differences in the seven amino acids levels between depressed rats and control. The results showed that Asp, Gly, Tau and GABA significantly decreased with increasing Gln in the hippocampus of depressed rats, compared with that of the control group, among which obviously lower level of Asp and higher level of Gln in cortex were observed. The analytical method and the results could be useful for clinical diagnosis and further insight into pathophysiological mechanism of depression.     

Wall shear stress and near-wall convective transport: Comparisons with vascular remodelling in a peripheral graft anastomosis

Fluid dynamic properties of blood flow are implicated in cardiovascular diseases. The interaction between the blood flow and the wall occurs through the direct transmission of forces, and through the dominating influence of the flow on convective transport processes. Controlled, in vitro testing in simple geometric configurations has provided much data on the cellular-level responses of the vascular walls to flow, but a complete, mechanistic explanation of the pathogenic process is lacking. In the interim, mapping the association between local haemodynamics and the vascular response is important to improve understanding of the disease process and may be of use for prognosis. Moreover, establishing the haemodynamic environment in the regions of disease provides data on flow conditions to guide investigations of cellular-level responses.     

Behavior of a PZT ring under non-uniform mechanical stress

Ring-shaped lead zirconate titanate (PZT) piezoelectric vibrators were subjected to non-uniform mechanical stress applied by bolt clamping. The effect of mechanical stress on the effective electromechanical coupling factor (k_eff) and mechanical quality factor (Q_m) of the thickness and wall thickness modes was studied by an equivalent electric circuit analysis. The initiation and propagation of cracks under mechanical stress were also discussed based on the resonance method and the indentation technique. k_eff for both the thickness and wall thickness modes decreased with increase in mechanical stress due to de-poling of the PZT. Q_m of the thickness mode dropped sharply with increase in mechanical stress while Q_m of the wall thickness mode remained almost unchange. Existence of microcracks in a PZT vibrator can be detected by the occurrence of spurious vibrations at the wall thickness mode in the electrical impedance vs. frequency spectra.     

Fluidization of Nano-size Particles

Fluidization and collapsing bed experiments were performed with 'Tullanox', 10nm diameter fumed silica. The minimum fluidization velocity was determined to be 0.0115m/s at the unusually low volume fraction of solids of 0.0077. The solids volume fraction was measured using a -ray densitometer. Fluidization was without large bubbles, with a high bed expansion ratio. The highest granular temperature was of the order of that of Geldart B particles, as measured by Cody et al. (1996). The sedimentation process was simulated using a two-fluid hydrodynamic model. The input into the model was a measured solids stress modulus and an agglomerate size determined from the settling curves. With these two rheological parameters, there was good agreement between the sedimentation theory and the experiment. This study shows that the standard collapse bed experiment used in industry is a good test of rheological properties of particles.     

Modeling of the DTG Curves for Oxidation of a Nanosized Molybdenum Ferrite Coupling Mechanics and Diffusion

From a model for isothermal oxidation kinetics in nanosized ferrite spinels based on a diffusion-induced stress effect, the authors present a modeling of the DTG curves for the oxidation of Fe²⁺ and Mo³⁺ cations on octahedral sites of a molybdenum ferrite. This has been made by considering that the chemical diffusion coefficient is given by the relation , when D _o is a pre-exponential factor, E _a ^′ an activation energy and V _a an activation energy induced by the oxidation. This revised version was published online in July 2006 with corrections to the Cover Date.     

Analysis of film strain and stress in a film-substrate cantilever system

The bending problem of a magnetic film-nonmagnetic substrate cantilever system is studied by using the principle of energy minimization. Emphasis is placed on the analysis of geometrical and physical parameter dependence of the neutral plane, internal film stress and strain of the cantilever system, and then the influence of such a parameter on the bending characteristic is presented. The results indicate, owing to the anisotropic expanding feature of the magnetostriction, that the neutral plane is generally anisotropic, and moves downwards rapidly with the increasing thickness ratio. Meanwhile, the bounding rigidity of substrate on the film will decrease with the increasing thickness ratio, and thus release the film stress, i.e., it decreases, but the film strain increases. The effect of Poisson’s ratio of the materials on the film strain, the stress and the neutral plane in the direction transverse to the magnetization is prominent. For the strain and the stress in the magnetization, however, the role of Poisson’s ratio is inconspicuous. This property is due to the initiative elongating (or contracting) feature of the magnetic film along its magnetization. Supported by the National Natural Science Foundation of China (Grant No. 10762001), the Key Project of the Chinese Ministry of Education (Grant No. 206024), and the Program for New Century Excellent Talents in University of China (Grant No. NCET-2005-0272)     

用雷诺应力模型计算旋风分离器中气-固两相流动

针对分离器内部的复杂的三维强旋转、气-固两相湍流运动,采用雷诺应力模型(SSG),利用贴体网格技术,模拟计算了分离器内部流动,并将计算结果与实验数据进行分析、比较。分离器内的固体颗粒运动采用涉及湍流扩散影响的随机轨道模型和确定轨道模型,在流场计算的基础上,模拟了不同直径的颗粒在分离器内的运动规律及颗粒分离效率,并同理论和实验得到的数据进行了比较。     

The effect of liquid crystal structure on the rheological properties of nitrocellulose-dimethylacetamide solutions

Solutions of Pyro grade nitrocellulose (NC) in dimethyl acetamide (DMA), containing between 42.5% and 60% NC (w/w), have been studied by differential scanning calorimetry and polarised light microscopy. The results showed that NC forms a lyotropic liquid crystal structure in DMA. A transition from the liquid crystal phase to an isotropic phase occurred over the temperature range 27 °C to 67 °C, and the enthalpy of transition increased with NC concentration. Rheological properties were determined using an extrusion rheometer with a slit die. The solutions were shown to have a yield stress for flow which increased with increasing NC concentration. The solutions were also found to be thixotropic.