相场法模拟NiCu合金非等温凝固枝晶生长

利用相场模型与溶质场、温度场进行耦合计算,以Ni-40.83%Cu合金为例模拟了二元合金枝晶生长过程.系统研究相场模型中相场和温度场耦合强度对枝晶形貌和浓度分布的影响.模拟结果表明:随着耦合强度的增加,相场受温度场的影响加大,界面前沿变得不稳,扰动被放大,主枝上出现了二次枝晶.同时,枝晶尖端的生长速率增大,而枝晶尖端的曲率半径减小,枝晶前沿的溶质富集现象也更严重;另外,计算结果与Ivantsov理论符合较好. 关键词： 相场法 NiCu合金 枝晶生长 Ivantsov理论     

横向限制下凝固微观组织演化的相场法模拟

凝固过程中横向限制挡板的存在对晶体微观结构的演化存在重要的影响, 不同性质的横向挡板将产生不同的限制效应, 对最终凝固微观组织形成起着决定性作用. 本文利用非等温相场模型, 定性地模拟了纯金属Ni凝固过程中横向限制的存在对其枝晶微观形貌演化的影响, 研究了不同尺寸及性质的横向挡板对枝晶微观结构形成的影响, 讨论了横向限制对不同初始枝晶间距枝晶形貌发展的作用. 计算结果表明, 横向限制挡板的存在将直接影响凝固过程中微观组织的形貌演化过程并最终改变微观结构. 随着横向挡板间距的减小, 微观组织变化更加明显; 挡板初始温度越低, 枝晶形貌改变越明显; 初始枝晶间距越大, 形貌变化越明显; 不同挡板高度对微观结构具有基本相同的影响. 关键词： 相场模拟 微观组织演化 横向限制     

相场模型模拟液固界面各向异性作用下自由枝晶生长

采用自适应有限元方法求解相场模型,分别对界面能各向异性和界面动力学各向异性条件下自由枝晶生长过程进行了模拟.计算表明两种各向异性均显著影响枝晶的生长,随着各向异性的增大枝晶尖端生长速度增大,尖端半径降低. 两种各向异性对自由枝晶生长有着不同形式的影响,在界面能各向异性条件下,枝晶生长稳定性系数与各向异性系数成幂函数关系;而在动力学各向异性条件下,稳定性系数与各向异性系数成线性关系. 关键词： 界面能各向异性 动力学各向异性 自由枝晶生长 相场模型     

Numerical investigation of the interaction between the martensitic transformation front and the plastic strain in austenite

Phase-field simulations of the martensitic transformation (MT) in an austenitic matrix which has already undergone the plastic deformation are carried out. For this purpose the elasto-plastic phase-field approach of incoherent MT developed in a previous work [Kundin et al., 2011. A phase-field model for incoherent martensitic transformations including plastic accommodation processes in the austenite. J. Mech. Phys. Solids 59, 2082–2012] is used. The evolution equation for the dislocation density field is extended by taking into account the thermal and athermal annihilation of the dislocations in the austenitic matrix and the athermal annihilation at the transformation front. It is shown that the plastic deformation in the austenite caused by the MT interacts with the dislocation field and the MT front that leads to an inhomogeneous increasing of the total dislocation density. During the phase transformation one part of the dislocations in the austenite is inherited by the martensitic phase and this inheritance depends on the kinetics and the crystallography of MT. Another part of dislocations annihilates at the transformation front and decreases the dislocation density in the growing martensite. Based on the simulation results the specific type of phenomenological dependency between the inherited dislocations, the martensite phase fraction and the plastic deformation is proposed.     

相场晶体法模拟过冷熔体中的晶体生长

利用相场晶体(phase-field crystal)模型,采用有限差分法,模拟了过冷熔体中晶体生长过程,研究了不同相区、不同过冷度对晶体生长过程的影响.结果表明,在共存区中,随着演化的进行,晶体生长被抑制,液-晶边界层逐渐变厚;在单相区中,随着过冷度的增大,晶态区面积显著增加,液-晶边界层逐渐变薄.晶体生长速度和过冷度成近似线性的关系. 关键词： 相场晶体 自由能函数 过冷熔体 晶体生长     

Three-dimensional,fully adaptive simulations of phase-field fluid models

We present an efficient numerical methodology for the 3D computation of incompressible multi-phase flows described by conservative phase-field models. We focus here on the case of density matched fluids with different viscosity (Model H). The numerical method employs adaptive mesh refinements (AMR) in concert with an efficient semi-implicit time discretization strategy and a linear, multi-level multigrid to relax high order stability constraints and to capture the flow’s disparate scales at optimal cost. Only five linear solvers are needed per time-step. Moreover, all the adaptive methodology is constructed from scratch to allow a systematic investigation of the key aspects of AMR in a conservative, phase-field setting. We validate the method and demonstrate its capabilities and efficacy with important examples of drop deformation, Kelvin–Helmholtz instability, and flow-induced drop coalescence.     

液滴撞击圆柱内表面的数值研究

针对液滴撞击圆柱内表面的过程,利用基于相场的格子Boltzmann方法模拟液滴以不同初速度、从不同初始高度、撞击不同大小的圆柱内表面时液滴的形态变化,分析了液滴自身物性(如密度和黏性等)和圆柱内表面润湿性等因素对撞击现象的具体影响.研究发现:撞击韦伯数、密度比及动力黏性比、圆柱半径等对液滴撞击后沿圆柱内表面的铺展均有一定影响,较高的韦伯数下液滴可能会发生分裂;液滴初始高度对大密度比和动力黏性比的撞击影响较小;液滴反弹现象可能出现在接触角较大时;重力作用会抑制撞击后液滴的振荡.     

细胞尺度冰晶生长行为的相场数值模拟

细胞尺度的冻结损伤机制是实施低温手术及生物材料低温保存的关键,本文围绕低温条件下的微尺度冻结问题,应用相场模型对冰晶的形成过程进行了数值模拟,明确了相场模型相关重要参数的确定方法,并最终得到各向同性条件下,二维平面内冰晶的生长过程及其生长特点.     

A phase-field modeling of void swelling in the Austenitic stainless steel

Two-dimensional phase-field simulations of void swelling in the Austenitic stainless steel were performed for irradiated materials. A numerical model was established for void swelling with an implementation of the elasticity effect, and we examined the roles of the applied stress and grain boundary sink strength and Frenkel defect recombination in determining the void swelling rate. The obtained results were compared with the existing experimental observations.     

Phase-field study of the second phase particle effect on texture evolution of polycrystalline material

The second phase particle effect on texture evolution of polycrystalline material is studied through phase-field method. A unique field variable is introduced into the phase-field model to represent the second phase particles. Elastic interaction between particles and grains is also considered. Results indicate that in the presence of second phase particles the average particle diameter turns smaller than in the absence of these particles and retards texture formation by pinning effect. The second phase particles change the strain energy profile, which tremendously influences the pinning effect.