Structural manipulation of pyrochlores: Thermal evolution of metastable Gd2(Ti1−yZry)2O7 powders prepared by mechanical milling

The structural and microstructural characteristics of metastable Gd₂(Ti_1−yZr_y)₂O₇ powders prepared by mechanical milling have been studied by a combination of XRD and Raman spectroscopy. Irrespective of their Zr content, as-prepared powder phases present an anion-deficient fluorite-type of structure as opposed to the pyrochlore equilibrium configuration obtained for the same solid solution by other synthetic routes. These fluorites are stable versus thermal activation, at least up to temperatures of 800 °C. For the Ti-rich compositions, thermal treatments at higher temperatures facilitate the rearrangement of the cation and anion substructures and the relaxation of mechanochemically induced defects whereas for compositions with high Zr content, the fluorite crystal structure is retained even at temperatures as high as 1200 °C. Interestingly enough, transient pyrochlores showing a very unusual cation distribution were observed during the thermally induced defect-recovery process.     

A microspectroscopic study of the electronic homogeneity of ordered and disordered Sr2FeMoO6

Disordered Sr₂FeMoO₆ shows a drastic reduction in saturation magnetization compared to highly ordered samples, moreover magnetization as a function of the temperature for different disordered samples shows qualitatively different behaviours. We investigate the origin of such diversity by performing spatially resolved photoemission spectroscopy on various disordered samples. Our results establish that e_xtensive electronic inhomogeneity, arising most probably from an underlying chemical inhomogeneity in disordered samples, is responsible for the observed magnetic inhomogeneity. It is further pointed out that these inhomogeneities are connected with composition fluctuations of the type Sr₂Fe_1+x Mo_1-x O₆ with Fe-rich (x > 0) and Mo-rich (x < 0) regions. Dedicated to Prof J Gopalakrishnan on his 62nd birthday.     

Synthesis,characterization and properties of methylaminocellulose

Homogeneously prepared tosylcelluloses (TC) with degrees of substitution (DS) of DS_Tos 0.1–1.8 were used as intermediates for the synthesis of methylaminocelluloses (MAC) by nucleophilic substitution with methylamine. TC with DS_Tos up to 1.1 were shown to be valuable intermediates for selective synthesis of MAC with DS_MA varying from 0.1 to approximately 1. No nucleophilic substitution was observed at higher DS_Tos. At the chosen reaction conditions (60 °C, 48 h) residual tosyl moieties remained unchanged and little hydrolysis took place. The samples obtained were characterized by means of elemental analysis, FTIR and ¹³C CP/MAS NMR spectroscopy. ¹³C CP/MAS NMR spectroscopy was found to be an efficient tool for quantification of DS_MA. Furthermore, the swelling behaviour in water was investigated and preliminary tests concerning the bilirubin adsorption capacity of MAC were carried out.     

Formulation for XPS spectral change of oxides by ion bombardment as a function of sputtering time

XPS measurement revealed that the original state of TiO₂ was changed to Ti₂O₃ and TiO by ion bombardment. TiO₂ decreased and Ti₂O₃ increased at the initial stage. TiO increased at a later stage than Ti₂O₃. Each of them saturated after enough sputtering time.A formulation was proposed in order to explain the change of XPS spectra for oxides as a function of ion sputtering time. This formulation was based on reaction equations that contain two reduction processes (from TiO₂ to Ti₂O₃ and from Ti₂O₃ to TiO), and sputtering effects. Using four fitting parameters (two reduction coefficients, sputtering yield and information depth), the present formula was fitted to the experimental results. The fitting results agree satisfactorily with the experimental results. The calculation shows that the reduction coefficient from TiO₂ to Ti₂O₃ is about ten times larger than that from Ti₂O₃ to TiO. This calculation predicts that surface composition of an oxide that is changed by ion bombardment will reach a different value depending on its bulk composition. Moreover, the present formulation can determine the chemical states of compounds changed by ion bombardment.     

Photoemission study of the modification of the electronic structure of transition-metal overlayers on TiO2 surfaces II. Cr on TiO2(0 0 1)

The electronic states of the Cr overlayers on TiO₂(0 0 1) surfaces have been investigated using angle-resolved and resonant photoemission spectroscopy with synchrotron radiation. At lower coverages, Cr deposition on TiO₂(0 0 1) creates two well separated in-gap emissions due to the formation of surface Ti³⁺ (3d¹) ions and Cr³⁺ (3d³) ions. At higher coverages, the in-gap emission is developed into the 2-peak-structure emission of Cr 3d character. The corresponding state is considered to be of metallic nature from the viewpoint of the high ability of oxygen adsorption, but has no Fermi edge, indicating a possibility of forming small Cr clusters on TiO₂(0 0 1) at this stage.     

Microsolvation of phthalocyanines in superfluid helium droplets.

Experimental and theoretical investigations of the spectroscopy of molecules in superfluid helium droplets provide evidence for the key role of the first helium layer surrounding the dopant molecule in determining the molecule's spectroscopic features. Recent investigations of emission spectra of phthalocyanine in helium droplets revealed a doubling of all transitions. Herein, we present the emission spectra of Mg-phthalocyanine and of phthalocyanine-argon clusters in helium droplets, which confirm the splitting as a general effect of the helium environment. A scheme of levels is deduced from the emission spectra and attributed to quantized states of the first helium layer surrounding the dopant molecule.     

Synthesis and characterization of polyaniline doped with organic acids

Spectroscopic [UV–visible and Fourier transform IR (FTIR)] and thermal properties of chemically synthesized polyanilines are found to be affected by varying the protonation media (acetic, citric, oxalic, and tartaric acid). The optical spectra show the presence of a greater fraction of fully oxidized insulating pernigraniline phase in polyaniline doped with acetic acid. In contrast, the selectivity in the formation of the conducting phase is higher in oxalic acid as a protonic acid media. The FTIR spectra of these polymers reveal a higher ratio of the relative intensities of the quinoid to benzenoid ring modes in acetic acid doped polyaniline. Scanning electron micrographs revealed a sponge‐like structure derived from the aggregation of the small granules in acetic acid and oxalic acid doped polyaniline. A three‐step decomposition pattern is observed in all the polymers, regardless of the protonic acid used for the doping. The second step loss related to the loss of dopant is found to be higher in the oxalic acid doped polymer. In accordance with these results the conductivity is also found to be higher in oxalic acid doped material. The temperature dependent conductivity measurements show the thermal activated behavior in all the polymers. © 2004 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 42: 2043–2049, 2004     

Molecular flow and wall collision age distributions

The use of storage cells has become a standard technique for internal gas targets in conjunction with high energy storage rings. In case of spin-polarized hydrogen and deuterium gas targets the interaction of the injected atoms with the walls of the storage cell can lead to depolarization and recombination. Thus the number of wall collisions of the atoms in the target gas is important for modeling the processes of spin relaxation and recombination. It is shown in this article that the diffusion process of rarefied gases in long tubes or storage cells can be described with the help of the one-dimensional diffusion equation. Mathematical methods are presented that allow one to calculate collision age distributions (CAD) and their moments analytically. These methods provide a better understanding of the different aspects of diffusion than Monte Carlo calculations. Additionally it is shown that measurements of the atomic density or polarization of a gas sample taken from the center of the tube allow one to determine the possible range of the corresponding density weighted average values along the tube. The calculations are applied to the storage cell geometry of the HERMES internal polarized hydrogen and deuterium gas target. Received 9 July 2001 and Received in final form 18 September 2001     

Ab-initio simulation of elastic constants for some ceramic materials

Athermal elasticity for some ceramic materials (α-Al₂O₃, SiC (α and β phases), TiO₂ (rutile and anatase), hexagonal AlN and TiB₂, cubic BN and CaF₂, and monoclinic ZrO₂) have been investigated via density functional theory. Energy-volume equation-of-state computations to obtain the zero pressure equilibrium volume and bulk modulus as well as computations of the full elastic constant tensor of these ceramics at the experimental zero pressure volume have been performed. The present results for the single crystal elasticity are in good agreement with experiments both for the aggregate properties (bulk and shear modulus) and the elastic anisotropy. In contrast, a considerable discrepancy for the zero pressure bulk modulus of some ceramics evaluated from the energy-volume fit to the computational zero pressure volume has been observed.     

Applications of density functional theory methods in millimeter‐wave spectroscopy

Density functional theory (DFT), using the most common functionals, and ab initio quantum chemistry methods are used to calculate the rotational constants and dipole moments of the astrophysically important molecules HCN, CH₃CN, CH₃CNH⁺, HCCCN, and HCCNC. As far as millimeter‐wave spectroscopy is of interest the DFT methods performed well with most functionals, giving results within ±1% of experiments for rotational constants and ±3% for dipole moments. Analyzing the results obtained with all theoretical models, it may be concluded that the Becke's three‐parameter exchange functional and the gradient‐corrected functional of Lee, Yang, and Paar (B3LYP) and Becke's three‐parameter functional with Perdew–Wang correlational functional [B3PW91/6‐31G(d, p)] give the best performances. A detailed analysis of the electron correlation effects shows that HCCCN is more stable than is HCCNC, by 1.16 eV, with important contribution arising from triple excitations. This result is also compared with those obtained with DFT methods. Despite occasional difficulties, DFT with the currently available functionals are of great utility in quickly assessing spectroscopic parameters of astrophysical interest. © 2002 Wiley Periodicals, Inc. Int J Quantum Chem, 2003