离子束合成钇硅化物的结构及红外谱特征

将稀土金属钇离子注入到n型单晶Si(111)中制备出钇硅化物埋层.利用x射线衍射、卢瑟福背散射和傅里叶红外吸收谱测量分析了样品的结构、原子的埋层分布和振动模式.结果表明，Y离子在注入过程中已与基底中的Si原子形成了YSi2结构相.真空下的红外光辐照处理促使YSi2择优取向生长，埋层中Si与Y的平均原子浓度比由24下降为20，与六方YSi2的化学计量比一致.还给出了钇硅化物的特征红外吸收谱.     

Effect of secondary electrons from latent tracks created in YBCO by swift heavy ion irradiation

Swift heavy ions (SHI) with electronic energy loss exceeding a value of 14.4 keVnm⁻¹ create amorphized latent tracks in YBCO type superconductors. In the low fluence regime of an ion beam where tracks do not overlap, a decrease of the superconducting transition temperature as probed through resistivity studies, is not expected due to availability of percolating current paths. The present study however shows T_c decrease by about 1–3 K in thin films of YBCO when irradiated by 250 MeVAg ions at 79 K at a fluence of 5×10¹⁰–1×10¹² ionscm⁻². The highest fluence used in the present study is three times less than the fluence where track overlapping becomes significant. The T_c tends to increase towards the preirradiation value on annealing the films at room temperature. To explain this unusual result, we consider the effect of ion irradiation in inducing materials modification not only through creation of amorphized latent tracks along the ion path, but also through creation of atomic disorder in the oxygen sublattice in the Cu–O chains of YBCO by the secondary electrons. These electrons are emitted radially from the tracks during the passage of the SHI. Considering the correlation between the charge state of copper and its oxygen coordination, we show in particular that the latter process is a consequence of the inelastic interaction of the SHI induced low-energy secondary electrons with the YBCO lattice, which result in chain oxygen disorder and T_c decrease.     

Si微电阻桥温度分布与热传导特性的显微Raman光谱研究

采用显微Raman光谱方法对红外目标模拟器中重掺杂Si微电阻桥单元的热传导特性进行研究，根据Si桥的实际特性建立相应的Raman散射模型，通过测量Raman峰位的移动得到高功率激光辐照下测量点的温度.对Si桥桥面分别进行了沿某些特殊线段的逐点线扫描和覆盖全部桥面的面扫描，得到各点的温升及其分布.用基于有限元分析的软件结合Si桥结构参数对各测量点的温升进行了模拟计算，其结果在热导分布的基本趋势上与实验相一致.实验细致地揭示了热导分布的局域起伏，反映出实际器件的不均匀性，为改进器件设计、优化器件性能提供了实验依据. 关键词： Raman光谱 Si桥 温度分布 热导     

Load-Carrying Capacity of Circular Plates Made of a Fiber-Reinforced Composite

The load-carrying capacity of circular plates made of a fiber-reinforced composite and loaded with axisymmetric transverse forces under axisymmetric boundary conditions is investigated. The plates can be freely supported or clamped along their contour. To the known yield condition used, in the plane of main bending moments, there correspond irregular hexagons, which depend on the mechanical properties of composite constituents and some characteristic geometrical parameters. It is shown that, depending on the ratio of ultimate radial and circumferential bending moments, in the plastic state, the circular plates (the central part of the clamped plates) take the form of a cone or a frustum of cone. For each of the cases, the limit load is found, which is a function of the above-mentioned mechanical parameters. The statically allowable fields of bending moments and the corresponding allowable fields of deflection rates are determined. The solutions found are exact. Special cases for the freely supported plates are analyzed, and the results obtained are presented in the form of graphs.__________Translated from Mekhanika Kompozitnykh Materialov, Vol. 41, No. 2, pp. 177–192, March–April, 2005.     

Speciation Analysis of Inorganic Tin (Sn(II)/Sn(IV)) by Graphite Furnace Atomic Absorption Spectrometry Following Ion-Exchange Separation

A new method based on anion exchange resin separation and graphite furnace atomic absorption spectrometry (GFAAS) detection is proposed for the determination of inorganic tin species. The result showed that Sn(IV) was quantitatively retained on the resin when [HCl] = 9.0 mol · L⁻¹, but Sn(II) could not be adsorbed on the resin under the same condition. Thus, a separation of Sn(II) and Sn(IV) has been realized. When the concentration of NaOH solution was between 2.0–7.0 mol · L⁻¹, Sn(IV) that adsorbed on the resin could be eluated from the resin completely. Meanwhile, under the atmosphere and the nitrogen states, the translation between Sn(II) and Sn(IV) was investigated. Under the optimal conditions, the detection limit of Sn(IV) is 0.40 μg · L⁻¹ with RSD of 2.3% (n = 5, c = 2.0 μg · L⁻¹). The proposed method was applied to the speciation analysis of tin in different water samples and the recovery of total Sn was in the range of 98.7–101.7%. In order to verify the accuracy of the method, a certified reference water sample was analyzed and the results obtained were in good agreement with the certified value.     

Organic synthesis based on cathodic deprotonation of acids

The results of studies on electrosynthesis involving carb- and heteroanions generated by cathodic deprotonation of acids (CDA), carried out in the laboratory headed by the author, are surveyed. These studies resulted in the elaboration of efficient electrochemical versions of the known Michaelis-Becker, Wittig-Horner, and Perkin reactions; electrochemical analogs of homolytic aromatic substitution, alkylation, heterocyclization,etc. were developed. Based on CDA, convenient and promising methods for preparing variousN-, O-, P-, S-, andC-alkylated and arylated substances have been developed.Translated fromIzvestiya Akademii Nauk. Seriya Khimicheskaya, No. 8, pp. 1411–1422, August, 1995.The author is grateful to Professor V. A. Dorokhov, Professor V. P. Litvinov, and researchers from the laboratories of N. D. Zelinsky Institute of Organic Chemistry headed by them, who participated in joint studies.The work was carried out with financial support from the International Science Foundation (Grant No. MHYOO).     

激光二极管端面抽运的棒状Yb：YAG激光器

分析了影响激光二极管抽运Yb：YAG激光器调Q效率的参量，推导了激光二极管端面脉冲抽运Yb：YAG晶体的速率方程，解出了双程抽运情况下的净抽运量子产率。利用数值计算方法，模拟了净抽运量子产率与晶体长度，抽运光脉冲宽度等关系，得出晶体长度的优化可以提高Yb：YAG激光器输出效率。计算了词Q Yb：YAG激光器的最大增益、最大储能，分析了放大自发辐射对于Yb：YAG能量存储的影响。同时给出了激光二极管端面抽运调Q Yb：YAG优化设计方法。这些分析和计算为实际器件的研制提供参考。     

17N+197Au反应中碎片与中子的符合测量

在3?3?.4MeV/u ¹⁷N束轰击¹⁹⁷Au靶产生的反应中,利用放置于不同角度组合的17个中子探测器(4°—83°)和14个半导体望远镜(2.3°—9.0°)对反应产物碎片与中子进行了符合测量.经对所得实验角分布积分得到Z=3—6元素的同位素产额分布.在参加者-旁观者模型框架下,采用¹⁷N原子核内部的不同密度分布计算了同位素产额分布并与实验数据做比较.     

Skin-Depth Theory Explaining Anomalous Picosecond-Terawatt Laser Plasma Interaction II

The anomaly of ion emission at laser irradiation of targets measured by Badziak et al. was analyzed on the background of the extensive research in the past. In contrast to the irradiation with lasers of longer than 100 ps pulse duration, a drastic decrease of the maximum ion energies was measured with ps pulses. Very strange was the observation that the number of emitted fast ions was intensity independent. The usual ponderomotive or relativistic self-focusing theory and related processes could not explain the results. Instead a direct interaction within the skin depth of the irradiated target was concluded. This model confirms the plane geometry nonlinear force interaction in the ps range producing fast plasma blocks moving perpendicular off or into the target. The block moving into the target opens a new scheme of laser fusion by modifying the experiments of Norreys et al. The use of relatively low subrelativistic laser intensities for the new scheme of laser fusion is evaluated on the background of the long years studies of nonlinear force driven plasma blocks and earlier interpenetration fusion reactions for providing the parameters for expected fusion gains much higher than the experiment of Norreys et al. for a fusion power scheme.