一种控制掺铒光纤激光器超混沌的方法——非线性延时反馈参数调制法

提出一种非线性延时反馈参数调制法来控制混沌/超混沌，给出了利用这种方法控制处于超混沌状态的双环掺铒光纤激光器的方案.数值模拟表明，只要延时时间和反馈强度合适就可以把双环掺铒光纤激光器从超混沌状态成功地控制到不同的周期状态. 关键词： 掺铒光纤激光器 超混沌 非线性延时反馈参数调制 混沌控制     

Structural manipulation of pyrochlores: Thermal evolution of metastable Gd2(Ti1−yZry)2O7 powders prepared by mechanical milling

The structural and microstructural characteristics of metastable Gd₂(Ti_1−yZr_y)₂O₇ powders prepared by mechanical milling have been studied by a combination of XRD and Raman spectroscopy. Irrespective of their Zr content, as-prepared powder phases present an anion-deficient fluorite-type of structure as opposed to the pyrochlore equilibrium configuration obtained for the same solid solution by other synthetic routes. These fluorites are stable versus thermal activation, at least up to temperatures of 800 °C. For the Ti-rich compositions, thermal treatments at higher temperatures facilitate the rearrangement of the cation and anion substructures and the relaxation of mechanochemically induced defects whereas for compositions with high Zr content, the fluorite crystal structure is retained even at temperatures as high as 1200 °C. Interestingly enough, transient pyrochlores showing a very unusual cation distribution were observed during the thermally induced defect-recovery process.     

氟化类金刚石薄膜的拉曼和红外光谱结构研究

关键词：     

三包层WⅠ和WⅡ型单模光纤波导色散特性的研究

研究了三包层WⅠ和WⅡ型单模光纤的波导色散特性。结果发现在相同条件下，三包层WⅠ和WⅡ型单模光纤零色散点的调节范围比传统的双包层W型单模光纤明显增大。详细分析了几何参量P、Q和光学参量R1、R2对单模传输时的波导色散特性和低次模截止频率的影响。所得的研究结果为获得更为理想的色散补偿、色散平坦光纤及设计新型无源光器件提供了重要的依据。计算波导色散的方法可推广到多包层光纤。     

Possible spectroscopic manifestation of the angular group induced bond alteration (AGIBA) effect in toluene

The most obvious consequence of the concept of aromaticity is the common confidence that in aromatic compounds, bond lengths do not alternate and are between typical to the single and double ones. However, in 1994, performing crystal structure investigations of substituted pyridines and their salts, Krygowski and co‐workers have discovered a very surprising angular group induced bond alteration (AGIBA) effect: It appears that some angular substituents, like methoxy or nitrozo groups, can induce bond alternation in aromatic rings. Crystal studies do not allow one to operate with liquids that are more common in organic chemistry. This paper presents the first possible evidence of spectroscopic manifestations of the AGIBA effect. Raman spectra of the liquid toluene are analyzed. It is found that instead of being single, the line corresponding to the ring breathing vibrations is clearly split by 1.0–1.4 cm^?1, thus indicating the presence of two (cis‐ and trans‐) AGIBA isomers. The energy difference between these isomers estimated in temperature dependent Raman studies is found equal to 6.68 kJ mol^?1. The low‐wavenumber line therefore corresponds to the cis‐AGIBA isomer and the high‐wavenumber line to the trans‐AGIBA isomer stabilized by the AGIBA effect. Copyright © 2007 John Wiley & Sons, Ltd.     

新型AFM探针的制备及应用

采用熔拉 -腐蚀复合方法 ,将普通单模石英光纤制成直锥形光纤探针。利用自制工具将探针打弯 ,制成悬臂式光纤探针 ,在AFM上取得了较理想的测试结果。将自制光纤探针和商用硅材料探针获得的两种扫描图像进行了对比 ,分析了悬臂式光纤探针的特点     

基于单光纤对模型的光纤束调制函数的建模与仿真

基于单光纤对光强调制特性的函数表达式,建立了双束型光纤束的调制函数,并引入一个虚拟轴间距参量,建立了随机型光纤束的光强调制函数.同时又在视内圈光纤束为单根粗光纤的情况下,建立了同轴I型和同轴型光纤束的光调制函数.在随机型和同轴型光纤束模型的基础上建立了双圈型(DC)和同轴随机型(C-R)光纤束的光调制系数.最后对上述光纤束的调制特性函数进行了计算机仿真实验.     

KrF准分子激光激发掺锗光纤折射率扰动的非线性过程

本文采用了一种简单的功率监测法,观察了KrF准分子激光对掺锗光纤折射率影响的非线性过程。观察到子纤芯折射率扰动过程中非稳定现象、饱和现象和折射率扰动的非线性。     

群色散光纤中高强度光脉冲传输与压缩的研究

考虑非线性四阶折射率,推导了光脉冲在群色散单模光纤中传输的非线性方程,并得到孤子型解析解.同时指出在Sech型光纤脉冲压缩实验中,光强度的阈值.     

用于曲面精密检测的新型光纤三角传感器研究

基于光纤传感技术和三角测量方法，提出了一种用于曲面检测的新型光纤三角传感器。根据所设计的轮辐式接收光纤结构，可以在测量曲面与传感头间位移时，首先获取被测点处微面元的倾斜信息，以便对传感器测量值进行实时误差修正，从而解决了被测表面倾斜对坐标测量带来的影响。该传感器还能有效地消除环境光干扰、光源波动、表面反射率变化等对测量带来的影响。建立了传感器测量的数学模型。理论分析和初步的实验结果证明了系统的有效性和实用性。该传感器系统不稳定性好于0.3%，横向分辨率好于8μm，高度分辨率好于0.1μm。