电感耦合等离子体质谱法测定煤矸石中微量锗和镓

建立了测定煤矸石中微量锗和镓的电感耦合等离子体质谱法。煤矸石试样经高温灰化,用硝酸-氢氟酸-高氯酸-磷酸分解,以电感耦合等离子体质谱法测定其中的锗和镓。通过在线三通加入内标元素铑,消除非质谱干扰;通过选择干扰元素的异质同位素进行定量测定,采用数学公式在线校正,消除质谱干扰。与分光光度法进行比对,锗、镓测定结果的相对偏差为-0.63%~0.28%。克服了常规化学分析方法步骤繁琐、耗时长、工作量大的不足。该法测定结果的相对标准偏差小于3%(n=6),加标回收率为97.4%~102.5%。该方法具有检出限低、快速、简便、线性范围宽、多元素同时测定等优点,分析误差满足化学分析法的要求,可用于煤矸石中锗和镓的测定。     

海洋生物体中稀土元素的微波消解电感耦合等离子体质谱测定研究

建立了微波消解样品处理、电感耦合等离子体质谱法测定海洋生物体中稀土元素的方法.用人发标准参考物质(GBW09101)、植物标准参考物质(GBW07603)以及实际样品标准加入回收的方法对文中所述的分析流程进行确认.实验结果表明,所建立方法的测定结果与标准参考物质的标准值或推荐值一致;样品标准加入实验的回收率在97%～104%之间.方法的定量下限为0.01～0.31 ng·g-1(10σ,n=10,干样).     

Effect of HF addition on the microwave-assisted acid-digestion for the determination of metals in coal by inductively coupled plasma-atomic emission spectrometry

The microwave-assisted acid-digestion for the determination of metals in coal by ICP-AES was investigated, especially focusing on the necessity of adding HF. By testing five certified reference materials, BCR-180, BCR-040, NIST-1632b, NIST-1632c, and SARM-20, it was found that the two-stage digestion without HF (HNO₃ + H₂O₂ was used) was very effective for the pretreatment of ICP-AES measurement. Both major metals (Al, Ca, Fe, and Mg) and minor or trace metals (Co, Cr, Cu, Mn, Ni, Pb, and Zn) in coal gave good recoveries for their certified or reference values. The possibility of ‘HF-memory effect’ was cancelled by the use of a set of vessels which had been never contacted with HF. Twenty-four Japanese standard coals (SS coals) were analyzed by the present method, and the concentrations of major metals measured by the present method provided very high accordance with those from the authentic JIS (Japanese Industrial Standard) method.     

鲨鱼软骨质量的聚类分析法

用电感耦合等离子体原子发射光谱法（ＩＣＰ－ＡＥＳ）测定了１８个鲨鱼软骨真品中１３个元素含量，对测定结果进行分析和变量聚类分析，抽提５个特征指标，并以谱系数聚类建立了鉴别鲨鱼软骨真伪的数学模式，用３个假冒产品和一个鲨鱼软骨胶囊对其进行检验，结果表明，用无机元素所建立的数学模式不仅能鉴别鲨鱼软骨的真伪，还能区分鲨鱼软骨的部分及不同部位的混合物。     

甲醇／丙烷在ZSM－5分子筛上偶合转化过程的研究

考察了甲醇／低碳烷烃在ＺＳＭ－５分子筛上偶合转化为芳烃和低碳烯烃的反应过程。对特定的催化体系，存在一最佳原料配比，使反应的热效应近似为零。偶合转化时甲醇完全转化，低碳烷烃的转化率低；不同催化剂上偶合转化产物分布差别极大，与ＨＺＳＭ－５相比，Ｇａ改性后可获得较高的芳烃和低碳烯烃收率。     

Investigation of superconductivity effects in single-phase and multiphase Bi2Sr2CaCu2O8 single-crystals at 2-MM wavelengths

Experimental investigations of superconductivity effects in single-phase and multiphase Bi₂Sr₂CaCu₂O₈ single-crystals have been carried out at 142 GHz frequency by means of the standing wave profile method [1]. Josephson harmonic generation has been observed to be responsible for the appearence of additional peaks on the standing wave profile of the open dielectric resonator loaded with a properly orientated multiphase high-T_c superconductor specimen. This leads to the conclusion that most of the Josephson junctions in multiphase crystals are located in certain crystallographic planes. The investigations of temperature dependencies showed that sharp resonant peaks of conductivity observed earlier [2] at 60 GHz could also be observed at 142 GHz.     

Determination of Y,Sm, Eu,Gd, Dy,Ho, Er in high purity terbium oxide by ICP-AES

Inductively coupled plasma atomic emission spectrometry (ICP-AES) was employed to determine Y, Sm, Eu, Gd, Dy, Ho and Er in high purity terbium oxide. Terbium oxide was dissolved in 0.5 mol/l HNO₃ and nebulized into the plasma generated by a 56 MHz RF generator at 1.5 kW output power. Using a Jobin-Yvon 1-m Czenry-Turner high resolution, high dispersion scanning monochromator, lines mutually interference-free as well as free of interference from the matrix Tb were chosen for the seven analytes. A set of standards containing the analytes in the concentration range 0.01–1.0 gmg/ml with 1 mg/ml Tb was used for calibration. It was necessary to apply background correction to the gross analyte line intensities in order to obtain linear calibration plots for the analytes.     

Determination of trace elements in human serum by inductively coupled plasma atomic emission spectrometry with flow injection

An analytical method for the simultaneous determination of some trace elements (Au, Fe, Mg, Li, Sr, Zn) in human serum by inductively coupled plasma atomic emission spectrometry (ICP-AES) with flow injection is described. Physical interference caused by the change of sample viscosity is discussed. When 100 μl of serum was injected, the relevant recoveries of > 99% for Li, > 98% for Cu and Mg, > 95% for Fe were obtained for an NIST SRM with R.S.D. > 1.3% using optimized flow injection parameters. The prepared lyophilized control serum for routine analysis in clinical laboratories was analyzed and verified for the validity of the technique employed in this experiment using NIST SRM 909 as a primary reference material.     

Application of laser ablation–inductively coupled plasma-mass spectrometry (LA–ICP–MS) to investigate trace metal spatial distributions in human tooth enamel and dentine growth layers and pulp

Human tooth enamel provides a nearly permanent and chronological record of an individuals nutritional status and anthropogenic trace metal exposure during development; it might thus provide an excellent bio archive. We investigated the micro-spatial distribution of trace metals (Cu, Fe, Mg, Sr, Pb, and Zn) in 196×339 m² raster pattern areas (6.6×10⁴ m²) in a deciduous tooth using laser ablation-inductively coupled plasma-mass spectrometry (LA–ICP–MS). Ablated areas include prenatal and postnatal enamel, the neonatal line, the dentine–enamel junction (DEJ), dentine, and the dentine–pulp junction. Topographic variations in the surface elemental distribution of lead, zinc, strontium, and iron intensities in a deciduous tooth revealed heterogeneous distribution within and among regions. ⁴³Ca normalized elemental intensities showed the following order: Sr>Mg>>Zn>Pb>Fe>Cu. Elevated zinc and lead levels were present in the dental pulp region and at the neonatal line. This study demonstrates the ability of LA–ICP–MS to provide unique elemental distribution information in micro spatial areas of dental hard tissues. Elemental distribution plots could be useful in decoding nutrition and pollution information embedded in their bio apatite structure.Presented in part at the 2002 Winter Conference on Plasma Spectrochemistry, Scottsdale, AZ, January 6–12, 2002. The poster was selected as an outstanding poster presentation.     

New In-situ Sampling and Analysis of the Production of CeO<Subscript>2</Subscript> Powders from Liquid Precursors using a Novel Wet Collection System in a rf Inductively Coupled Thermal Plasma Reactor. Part 1: Reactor System and Sampling Probe

A new reactor and a novel in-situ sampling technique were developed for the study of the synthesis of CeO₂ powders produced from dissolved cerium nitrate salts. The conical reactor minimized particle recirculation and provided a highly symmetrical and undisturbed plasma flow suitable for the analysis of the phenomena affecting the formation of CeO₂ powders. Both a calorimetric study of the reactor and a thermodynamic analysis of CeO₂ formation were conducted. The sampling probe is described and near-isokinetic sampling was achieved. The sampled particles were collected using a miniature wet collection system, i.e. a mist atomizer and a custom-made spray chamber. A numerical simulation of the velocity and temperature fields of the plasma gas in the reactor was done using Fluent. A comprehensive droplet-to-particle formation mechanism presented elsewhere is revisited and expanded based on calorimetry, thermodynamics of CeO₂ formation, numerical simulations and collected particles. No traces of other oxidation states other than CeO₂ were found.