Tesla变压器型电子束加速器初步实验

 介绍了一种Tesla变压器型的强流电子束加速器。当变压器初级输入20kV左右的电压时，加速器二极管输出电压500kV，电流9kA，信号脉宽大约50ns，该装置具有结构简单，安装方便，运行可靠等特点。     

Pulsed laser deposition of nanostructured Ag films

Ultra-thin (0.5-5 nm) films of Ag have been prepared by pulsed laser deposition in vacuum using a 26 ns KrF excimer laser at 1 J cm⁻². The deposition was controlled using a Langmuir ion probe and a quartz crystal thickness monitor. Transmission electron microscopy showed that the films are not continuous, but are structured on nanometer size scales. Optical absorption spectra showed the expected surface plasmon resonance feature, which shifted to longer wavelength and increased in strength as the equivalent film thickness was increased. It is shown that Maxwell Garnett effective medium theory can be used to calculate the main features of optical absorption spectra.     

TRIUMF resonant ionization laser ion source

The range of isotopes available at the TRIUMF Isotope Separator Accelerator (ISAC) facility has been greatly enhanced by adding a Resonance Ionization Laser Ion Source (RILIS). A large wavelength range is accessible with the fundamental, second and third harmonic generation of titanium-sapphire laser light. In addition a dedicated laser is available for non-resonant laser ionization. The first on-line beam ⁶²Ga was delivered in Dec. 2004. In general RILIS improves the intensity, purity and emittance of ion beams. ⁶²Ga and ²⁶Al and Be beams have been delivered so far on-line. This work was financed by TRIUMF which is federally funded via a contribution agreement through the National Research Council of Canada.     

激光准直仪的设计性物理实验

介绍了激光准直仪的结构、工作原理及其在设计性物理实验中的应用     

High power diode single-end-pumped Nd:YVO4 laser

A fiber-coupled diode-single-end-pumped Nd:YVO₄ laser with an Nd:YVO₄ crystal of 0.3 at% doping concentration and 3×3×10 mm³ dimensions was reported. 14.850 W of continuous-wave output power in an M² factor of 1.12 was obtained under pump power of 27.365 W, with an optical conversion efficiency of 60.49%, and a slope efficiency of 64.5%.     

Laser spectroscopic investigation of a new precursor-type polyparaphenylenevinylene

Optical, structural and morphological properties of thin films of polyparaphenylenevinylene (PPV) formed by an alkyl sulfinyl precursor route have been studied. Thin films were fabricated on an optical glass and on quartz glass either by spin-coating of the precursor solution or by layer-by-layer deposition using Langmuir–Blodgett technique. PPV precursor films were also spin-coated on gold-coated glass in order to study thin-film optical parameters by surface plasmon spectroscopy. We have been successful in forming about 40 precursor mono layers on quartz glass by Langmuir–Blodgett technique using optimized surface pressure and dipping conditions. After thermal conversion of the precursor layers good quality fluorescent PPV films of yellow colour have been obtained. Optical characterization of the films was carried out by linear absorption and emission spectroscopy, ellipsometry, and surface plasmon spectroscopy. Structural and morphological studies on the thin films were carried out by using X-ray scattering and atomic force microscopy. Wave-guided travelling-wave laser action has been achieved in a PPV film on quartz glass. The sample was transversally pumped with picosecond laser pulses (wavelength 347.15 nm, duration 35 ps). Laser emission occurred at 550 nm for pump pulse energy densities above .     

Rugged distal tips for CO2 laser medicine

Low-loss and rugged distal tips for CO₂ laser have been proposed and fabricated based on a commercially available stainless steel (St) pipe. A method of smoothening the inner surface of the St pipe with a rough inner surface is put forward. Fabrication parameters, transmission properties, and mechanical strength of the cyclic olefin polymer-coated silver hollow St distal tip are experimentally discussed.     

高功率固体激光放大系统相位自校正方法研究

就光学元件间低频相位误差叠加提出用相关系数作为叠加相位结果的估计参量，并通过模拟计算和验证实验证明了相关系数能有效地对低频相位叠加结果进行比较估计，在此基础上就高功率固体激光放大系统中放大片的选取和安装提出了自校正方法并实现了自校正过程。     

激光水下扫描成像系统的图像修正机理

同步扫描系统可以克服后向散射，但同时也产生了两种非线性，一是扫描线速度的非线性，一是由于距离对光能衰减造成的非线性，两种非线性都需要修正，本文从原理上讨论水下激光成像时能量衰减的修正原理与修正方法，并给出仿真结果。     

中空光纤技术与应用特性

介绍一种采用环烯烃聚合物镀膜的中空光纤结构，阐述其传输特性，说明其使用特点，指出它在工业和医疗等领域中的应用前景。