超声辅助电镀的仿真与实验*

为了提高镀层的表面质量,提出了一种超声辅助电镀的方法。超声的空化与搅拌作用可以影响电镀的电沉积过程。设计了合理的换能器结构,并搭建了超声辅助电镀装置。通过对模型进行压电声学场与电镀场耦合仿真分析,结果表明：在硫酸铜电解液,镀铜时间60s,电压300V条件下,进行超声辅助电镀,镀层厚度分布均匀,镀层中部电流密度分布均匀,边缘最大电流密度是未加超声的2倍左右 。基于仿真结果,进行相同的实验测试,结果表明：超声辅助电镀可以提高镀层的均匀性,减少铜颗粒表面的杂质,提高表面的光洁度。阴极样品距离换能器头部位置在60mm左右,镀层质量良好。     

有限元/边界元耦合方法在海洋生物目标强度特性研究的应用*

目标强度特性是海洋生物声学识别与资源量评估的重要依据,其中,基于近似几何体和声阻抗特性的理论模型法是研究海洋生物目标强度的重要手段。由于对几何形态近似处理以及数值求解方法的限制,传统理论模型对声波频率、入射方位以及目标声阻抗、形态尺寸等均有各自不同的适用范围,单一模型难以满足不同种类或同一种类但不同尺寸海洋生物的目标强度求解。本文尝试将逐渐见诸应用的有限元/边界元耦合方法用于海洋生物目标强度特性研究,分别以球形生物、纺锤形鱼类尾明角灯鱼(Ceratoscopelus warmingii)和细长形浮游动物南极大磷虾(Euphausia superba)为例进行仿真计算,并与相适应的经典理论模型进行对比分析。结果表明,对于球形生物,有限元/边界元耦合方法与解析模型的目标强度频响曲线完全吻合;对于纺锤形鱼类,有限元/边界元耦合方法可有效弥补基于模态级数解的形变圆柱体模型在中低频和两端入射时的准确性问题;对于细长形浮游动物,有限元/边界元耦合方法与畸变波玻恩近似模型高度吻合。综上,有限元/边界元耦合方法对多种海洋生物目标强度求解均具有较好的适用性,未来有待进一步结合实验测定进行验证。     

非均匀流体介质内部散射声场重建的逐层计算方法*

入射声波激励下非均匀流体介质内部散射声场的重建方法对超声层析成像具有重要意义。以往采用矩量法求解,但该方法全域离散形成的复数满秩矩阵规模随着分辨率与计算精度的提高而急剧增大,对算力具有很高的要求,一定程度上限制了其在实际中的应用。为克服上述缺陷,本文以逐层离散、逐层计算为核心思想,以声散射基本公式与近场声全息理论为基础,推导出逐层计算非均匀流体介质内部散射声场的理论公式并给出对应的几何离散模型。为验证该方法的可行性,以矩量法为参照,对同样的介质模型进行介质内部声场重构仿真。结果表明,逐层算法不仅可以有效地重建非均匀流体介质内部散射声场,且大幅度减小了求解规模。     

Channel temporal correlation-based optimization method for imperfect underwater acoustic channel state information

The rapid time variations and large channel estimation errors in underwater acoustic (UWA) channels mean that transmitters for adaptive resource allocation quickly become outdated and provide inaccurate channel state information (CSI). This results in poor resource allocation efficiency. To address this issue, this paper proposes an optimization approach for imperfect CSI based on a Gauss–Markov model and the per-subcarrier channel temporal correlation (PSCTC) factor. The proposed scheme is applicable to downlink UWA orthogonal frequency division multiple access systems. The proposed PSCTC factors are measured, and their long-term stability is verified using data recorded in real-world sea tests. Simulation and experimental results show that the optimized CSI effectively mitigates the effects of the temporal variability of UWA channels. It demonstrates that the resource allocation scheme using optimized CSI achieves a higher effective throughput and a lower bit error rate than both imperfect CSI and the CSI predicted by the recursive least-squares (RLS) algorithm.     

用声信号识别构件模态频率

本文提出一种新的模态分析方法—用声信号识别构件模态频率.传声器不与结构表面接触,消除了附加质量的影响.同时,结合时间序列谱分析法改善并提高了响应谱的精度.     

Noise Reduction in Non-Premixed Lifted-Jet Flames

The characteristic changes in non-premixed lifted flames when excited by hole tones from a cavity, placed in the flow path of the fuel gas, were studied. A significant reduction of the sound pressure level was observed in the low-frequency noise at the flame base of the lifted flame when the hole tones were induced in the jet. The liftoff height and the mean diameter of the flame base decreased for a given jet Reynolds number. The blow-off velocities also increased suggesting improved flame stability in the presence of the hole tones induced by the cavity. Incorporation of the cavity upstream of a burner nozzle is demonstrated to give a quieter lifted flame with improved stability characteristics. This revised version was published online in July 2006 with corrections to the Cover Date.     

The effect of an acoustic field on a secondary convective flow in a layer

The effect of a traveling sonic wave on a convective flow in a horizontal layer with a fixed linear temperature distribution on the boundaries is investigated. Convective rolls with axes parallel to the basic flow (lengthwise rolls) are considered. On the basis of a weakly nonlinear analysis, it is shown that the lengthwise rolls appear smoothly and the regular flows are stable near the stability threshold. A direct numerical simulation is performed. Secondary near-critical flow regimes and regimes corresponding to finite supercriticalities are investigated.     

条形平板中裂纹识别的遗传算法

研究条形平板中平行于上下边界的单一裂纹的识别问题。给出了当一声波入射这一条形平板时，裂纹参数与反射、透射系数之间的关系式，并应用遗传算法对裂纹进行了定量识别。计算结果表明本文给出的方法具有较好的识别精度。     

A NOVEL SEMI-ANALYTICAL METHOD FOR SOLVING ACOUSTIC RADIATION FROM LONGITUDINALLY STIFFENED INFINITE NON-CIRCULAR CYLINDRICAL SHELLS IN WATER

Based on the extended homogeneous capacity high precision integration method and the spectrum method of virtual boundary with a complex radius vector, a novel semi-analytical method, which has satisfactory computation effectiveness and precision, is presented for solving the acoustic radiation from a submerged infinite non-circular cylindrical shell stiffened by longitudinal ribs by means of the Fourier integral transformation and stationary phase method. In this work,besides the normal interacting force, which is commonly adopted by some researchers, the other interacting forces and moments between the longitudinal ribs and the non-circular cylindrical shell are considered at the same time. The effects of the number and the size of the cross-section of longitudinal ribs on the characteristics of acoustic radiation are investigated. Numerical results show that the method proposed is more efficient than the existing mixed FE-BE method.     

定态火焰在可燃预混气中产生的压力波

火焰在可燃预混气中传播时，在火焰面前方产生一道压力波。忽略点火及火焰的初期加速，仅考虑火焰达到稳定传播速度的情况。用Ｏｐｅｎｈｅｉｍ自相似解分析流场，得到相应的控制方程及定解条体；用自适应步长的四阶Ｒｕｎｇｅ－Ｋｕｔｔａ法对方程积分，讨论了流场压力波结构及弱激波近似声波解；认为火焰为间断面，能量释放在火焰面后瞬时完成。利用火焰面两侧的能量关系，得到了火焰位置、燃速及对应Ｃ－Ｊ条件的火焰位置、Ｃ－Ｊ燃速。