30J能量驱动类镍银X光激光的理论研究

 在1.2×10¹³W·cm^－2低功率密度下，对基频激光预主短脉冲驱动类镍银X光激光机理进行了数值模拟和理论分析。证实了在靶长23 mm范围内X光激光都能获得有效放大，取得了和实验相符合的结果。考虑了单柱面镜线聚焦沿靶长度方向功率密度的非均匀性对X光激光放大的影响，采用弯曲靶能有效克服折射以及单柱面镜线聚焦功率密度非均匀带来的不利影响。理论模拟给出的类镍银X光激光的出光下限泵浦功率密度也与实验符合得很好。理论模拟还表明，采用1%左右的预脉冲强度并对预主脉冲时间间隔进行优化，X光激光的输出能量和能量转换效率将获得大幅度提高。     

聚焦慢速高荷态重离子束微束斑X射线源

利用电子束离子源(EBIS)或者电子束离子陷阱(EBIT)产生的慢速高电荷态重离子束轰击金属靶面,离子束与靶面作用并复合辐射特征X射线;并将高荷态离子束采用离子光学系统会聚为微细束后再与靶面作用,能够辐射出微米甚至亚微米级、纳米级的微束斑X射线.本文介绍这一新型微束斑X射线源的结构、机理及其特性等.     

强流束晕-混沌的外部磁场开关控制

研究了强流离子束在周期聚焦磁场通道中束晕-混沌的外部磁场开关参数控制方法. 将该方法应用在多粒子模型中，实现了对5种不同初始分布质子束的束晕-混沌的有效控制，得到了消除束晕及其再生现象的理想结果.在强流加速器系统中，由于外部磁场是可测和可调 的物理量，因此该控制方法有利于实验研究，可为强流质子加速器中周期聚焦磁场的设计和实验提供参考. 关键词： 强流离子束 周期聚焦磁场通道 束晕_混沌 混沌控制 开 关控制     

旋光性与电光效应交互作用及其对旋光晶体电光Q开关的影响

研究了晶体的旋光性与电光效应的交互作用、以及此交互作用对 旋光晶体电光Q开关的影响. 关键词： 旋光性 电光效应 电光Q开关 3Ga₅SiO₁₄晶体')" href="#">La₃Ga₅SiO₁₄晶体     

19.6nm波长类氖锗X光激光光源理论模拟

 波长19.6nm的类氖锗X光激光适合作为诊断激光等离子体界面不稳定性的光源。用经过实验检验的系列程序对预-主短脉冲驱动类氖锗进行了系统的优化设计和理论分析。采用2%~3%的预脉冲强度，6~8ns的预-主脉冲时间间隔，在4×10¹³W/cm²功率密度驱动下, 波长19.6nm增益区的宽度可以超过60μm，增益区的维持时间可以达到90ps。对于16mm长的平板靶，增益系数可达11.8/cm；弯曲靶增益系数可达13.3/cm；单靶小增益长度积可达21.3，单靶就可以获得饱和增益。采用双靶对接，其小讯号增益可达38.4，可以获得深度饱和增益，能满足应用演示所需的X光激光光源。     

Microwave-accelerated conjugate addition of aldehydes to α,β-unsaturated ketones

Aldehydes undergo smooth conjugate addition to α,β-unsaturated ketones in the presence of 5-(2-hydroxyethyl)-1,3-thiazolium halides and DBU adsorbed onto the surface of basic alumina under microwave irradiation and solvent-free conditions to afford 1,4-diketones in enhanced yields and reduced reaction times compared to conventional methods.     

两相同部件温贮备可修的人机系统解的性质分析

本文首先用强连续算子半群理论证明了两相同部件温贮备可修的人机系统动态非负解的存在唯一性 ,然后证明了 0是系统主算子的本征值 ,并得到 0本征值对应的本征向量是正的 ,从而系统存在稳态正解 .     

高速色散补偿系统中喇曼放大器性能研究

利用喇曼放大器的非线性偏微分耦合方程组,对带喇曼放大器的色散补偿系统进行了仿真,并与传统的仿真方法进行了比较.结果表明:在色散完全补偿系统中,当传输速率较高时,忽略色散后的传统仿真方法的结果,与采用色散补偿技术后使整个系统色散为零的仿真结果有一定偏差,此时不能忽略色散的作用.还对前补偿系统和后补偿系统进行了研究,利用Q值性能判别法,分别得到了信号光脉冲的最佳占空比和最佳脉冲阶数.     

Local adsorption sites and bondlength changes in Ni(1 0 0)/H/CO and Ni(1 0 0)/CO

The local adsorption geometry of CO adsorbed in different states on Ni(1 0 0) and on Ni(1 0 0) precovered with atomic hydrogen has been determined by C 1s (and O 1s) scanned-energy mode photoelectron diffraction, using the photoelectron binding energy changes to characterise the different states. The results confirm previous spectroscopic assignments of local atop and bridge sites both with and without coadsorbed hydrogen. The measured Ni–C bondlengths for the Ni(1 0 0)/CO states show an increase of 0.16 ± 0.04 Å in going from atop to bridge sites, while comparison with similar results for Ni(1 1 1)/CO for threefold coordinated adsorption sites show a further lengthening of the bond by 0.05 ± 0.04 Å. These changes in the Ni–CO chemisorption bondlength with bond order (for approximately constant adsorption energy) are consistent with the standard Pauling rules. However, comparison of CO adsorbed in the atop geometry with and without coadsorbed hydrogen shows that the coadsorption increases the Ni–C bondlength by only 0.06 ± 0.04 Å, despite the decrease in adsorption energy of a factor of 2 or more. This result is also reproduced by density functional theory slab calculations. The results of both the experiments and the density functional theory calculations show that CO adsorption onto the Ni(1 0 0)/H surface is accompanied by significant structural modification; the low desorption energy may then be attributed to the energy cost of this restructuring rather than weak local bonding.     

Distribution results for lattices in SL(2,ℚ p )

In this paper we study the ergodic properties of the linear action of lattices Γ of SL(2,ℚ_p) on ℚ_p × ℚ_p and distribution results for orbits of Γ. Following Serre, one can define a “geodesic flow” for an associated tree (actually associated to GL(2,ℚ_p)). The approach we use is based on an extension of this approach to “frame flows” which are a natural compact group extension of the geodesic flow.