Influence of solvent on solution processed Cu2ZnSnS4 nanocrystals and annealing induced changes in the optical,structural properties of CZTS film

The well-known quaternary Cu₂ZnSnS₄ (CZTS) chalcogenide thin films are playing an important role in modern technology. The CZTS nanocrystal were successfully prepared by solution method using water, ethylene glycol and ethylenediamine as different solvent. The pure phase material was used for thin film coating by thermal evaporation method. The prepared CZTS thin films were characterized by XRD, Raman spectroscopy, FESEM, XPS and FT-IR spectroscopy. The XRD and Raman spectroscopy analysis revealed the formation of polycrystalline CZTS thin film with tetragonal crystal structure after annealing at 450 ^°C. The oxidation state of the annealed film was studied by XPS. A direct band gap about 1.36 eV was estimated for the film from FT-IR studies, which is nearly close to the optimum value of band gap energy of CZTS materials for best solar cell efficiency. The CZTS annealed thin films are more suitable for using as a p-type absorber layer in a low-cost solar cell.     

Sensitivity analysis of thermal performances of flat plate solar air heaters

Sensitivity analysis is a mathematical tool, first developed for optimization methods, which aim is to characterize a system response through the variations of its output parameters following modifications imposed on the input parameters of the system. Such an analysis may quickly become laborious when the thermal model under consideration is complex or the number of input parameters is high. In this paper, we develop a mathematical model to analyse the heat exchanges in four different types of solar air collectors. When building this thermal model we show that for each collector, at quasi-steady state, the energy balance equations of the components of the collector cascade into a single first-order non-linear differential equation that is able to predict the thermal behaviour of the collector. Our heat transfer model clearly demonstrates the existence of an important dimensionless parameter, referred to as the thermal performance factor of the collector, that compares the useful thermal energy which can be extracted from the heater to the overall thermal losses of that collector for a given set of input parameters. A sensitivity analysis of our thermal model has been performed for the most significant input parameters such as the incident solar irradiation, the inlet fluid temperature, the air mass flow rate, the depth of the fluid channel, the number and nature of the transparent covers in order to measure the impact of each of these parameters on our model. An important result which can be drawn from this study is that the heat transfer model developed is robust enough to be used for thermal design studies of most known flat plate solar air heaters, but also of flat plate solar water collectors and linear solar concentrators.     

A semi-analytical numerical method for time-dependent radiative transfer problems in slab geometry with coherent isotropic scattering

We describe a semi-analytical numerical method for coherent isotropic scattering time-dependent radiative transfer problems in slab geometry. This numerical method is based on a combination of two classes of numerical methods: the spectral methods and the Laplace transform (LTS_N) methods applied to the radiative transfer equation in the discrete ordinates (S_N) formulation. The basic idea is to use the essence of the spectral methods and expand the intensity of radiation in a truncated series of Laguerre polynomials in the time variable and then solve recursively the resulting set of “time-independent” S_N problems by using the LTS_N method. We show some numerical experiments for a typical model problem.     

Theory of high temperature superconductivity in YBa2Cu3O7_δ

A theory of high temperature superconductivity in YBa₂Cu₃O₇__δ compound has been developed on the basis of the momentum pairing of electrons through the relativistic Darwin interaction. The transport behaviour of electrons is explained in terms of a mechanism of correlated electron transfer arising from the electron-phonon coupling. A model Hamiltonian has been developed to describe the superconducting properties of the system. This gives an energy gap which is higher than the BCS value. Attempts have been made to explain the absence of isotope effect, the linear dependence of specific heat, the presence of larger temperature-independent paramagnetism in the normal phase and the softening of some of the optic phonon modes observed in this system.     

A novel and efficient synthesis of porphine

meso-Tetra(n-hexyloxycarbonyl)porphyrin was found to be converted into porphine, the mother compound of porphyrins, in a 77% yield when heated in aqueous sulfuric acid at 180 °C over 30 min under an inert atmosphere. The observation demonstrates that the substituted porphyrin serves as a novel and useful precursor for porphine.     

Mass transport in metals under intensive impulse reactions

An unusually high mobility of atoms under intensive impulse reactions is explained by the behavior of point defects at the shock wave front. It is shown that either a shock wave front or moving dislocations can capture the interstitials, or they can be thermally activated in the direction of the shock wave propagation.     

Formation and hydrogenation of p(2 × 2)-N on Pt(1 1 1)

The formation of a well-ordered p(2 × 2) overlayer of atomic nitrogen on the Pt(1 1 1) surface and its reaction with hydrogen were characterized with reflection absorption infrared spectroscopy (RAIRS), temperature programmed desorption (TPD), low energy electron diffraction (LEED), Auger electron spectroscopy (AES), and X-ray photoelectron spectroscopy (XPS). The p(2 × 2)-N overlayer is formed by exposure of ammonia to a surface at 85 K that is covered with 0.44 monolayer (ML) of molecular oxygen and then heating to 400 K. The reaction between ammonia and oxygen produces water, which desorbs below 400 K. The only desorption product observed above 400 K is molecular nitrogen, which has a peak desorption temperature of 453 K. The absence of oxygen after the 400 K anneal is confirmed with AES. Although atomic nitrogen can also be produced on the surface through the reaction of ammonia with an atomic, rather than molecular, oxygen overlayer at a saturation coverage of 0.25 ML, the yield of surface nitrogen is significantly less, as indicated by the N₂ TPD peak area. Atomic nitrogen readily reacts with hydrogen to produce the NH species, which is characterized with RAIRS by an intense and narrow (FWHM ∼ 4 cm⁻¹) peak at 3322 cm⁻¹. The areas of the H₂ TPD peak associated with NH dissociation and the XPS N 1s peak associated with the NH species indicate that not all of the surface N atoms can be converted to NH by the methods used here.     

纳米MOSFET迁移率解析模型

从玻尔兹曼方程出发，重新计算了纳米MOSFET沟道内的载流子所服从的分布函数，特别是考虑了纳米MOSFET横向电场和纵向电场之间的相互作用，并且以得到的非平衡状态下的分布函数为基础，考虑载流子寿命和速度的统计分布，给出了纳米MOSFET载流子迁移率的解析表达式.通过与数值模拟结果进行比较和分析，该迁移率解析模型形式简洁、物理概念清晰，且具有相当精度. 关键词： 玻尔兹曼方程 纳米MOSFET 迁移率 沟道有效电场     

不同入射角度下强流脉冲电子束能量沉积剖面和束流传输系数模拟计算

 强流脉冲电子束在材料中的能量沉积剖面、能量沉积系数和束流传输系数受其入射角的影响很大，理论计算了0.5~2.0MeV的电子束以不同的入射角在Al材料中的能量沉积剖面和能量沉积系数，并且还计算了0.4~1.4MeV电子束以不同入射角穿透不同厚度C靶的束流传输系数。计算结果表明，随着入射角的增大，靶材表面层单位质量中沉积的能量增大，电子在靶材料中穿透深度减小，能量沉积系数减小，相应的束流传输系数也减小；能量为0.5~2.0MeV的电子束当入射角在60°~70°时在材料表面层单位质量中沉积的能量较大。     

Transport of Neutrally Buoyant and Dense Variably Sized Colloids in a Two-Dimensional Fracture with Anisotropic Aperture

The transport of monodisperse as well as polydisperse colloid suspensions in a two-dimensional, water saturated fracture with spatially variable and anisotropic aperture is investigated with a particle tracking model. Both neutrally buoyant and dense colloid suspensions are considered. Although flow and transport in fractured subsurface formations have been studied extensively by numerous investigators, the transport of dense, polydisperse colloid suspensions in a fracture with spatially variable and anisotropic aperture has not been previously explored. Simulated snapshots and breakthrough curves of ensemble averages of several realizations of a log-normally distributed aperture field show that polydisperse colloids exhibit greater spreading than monodisperse colloids, and dense colloids show greater retardation than neutrally buoyant colloids. Moreover, it is demonstrated that aperture anisotropy oriented along the flow direction substantially increases colloid spreading; whereas, aperture anisotropy oriented transverse to the flow direction retards colloid movement.