Simplified and complex modeling of self-sustained discharge-pumped,Ne-buffered XeCl laser kinetics

Two simple kinetic models of a Ne-buffered XeCl laser discharge are presented based on different simplifications of the chemical kinetics of a complex model that recently appeared in the literature. When applied to the study of a small-volume XeCl laser, the results of both simple and complex models are in satisfactory agreement with the experiments. Shifting to a larger-volume laser, both models show problems due to loss of stability of the discharge. A one-dimensional modelling is performed, and it is found that different assumptions on the kinetics of the NeXe⁺ ion in the discharge lead to completely different results as regards the effect of a preionization-triggered instability.     

Geometry,stability and aromaticity of β-diketiminate-coordinated alkaline-earth compounds

Alkaline-earth (Ae) metals have attracted a wealth of interdependent research from synthetic chemists. In Ae-catalyzed organometallic reactions, β-diketiminate is a typical ligand used to stabilize Ae catalysts by forming six-membered rings comprising Ae metals. Herein, studies focusing on the configuration of β-diketiminate-coordinated Ae compounds observed that the CC and CN bonds are homogeneous and unchanged. Furthermore, energetic studies observed that the formation of the Ae-incorporated six-membered rings results in enhanced stability of >20 kcal/mol. The nucleus-independent chemical shifts, anisotropy of the induced current density, and molecular orbital analyses demonstrated the non-aromaticity of the β-diketiminate-coordinated Ae compounds. The improved stability of these compounds can be explained by the delocalization of the π electrons derived from the β-diketiminate moiety.     

乳液聚合共聚物玻璃化转变温度及其理论计算

从共聚单体的竞聚率、油相水相分布系数出发,通过动力学模拟计算了丙烯酸丁酯与醋酸乙烯酯乳液共聚物的链结构,并用Johnson公式对其玻璃化转变温度(T_g)进行了理论计算,给出了共聚物T_g及其对应聚合物的重量分布图。发现半连续共聚物有1个T_g,其值随共聚物组成而变化;但一步法共聚物有两个T_g:低温区T_g代表富丙烯酸丁酯共聚物,高温区T_g则代表PVA均聚物。计算结果与实验十分吻合。     

Principal component analysis of carbon-13 substituent-induced chemical shifts of some unsaturated compounds

Principal component analysis (PCA) is applied to 32 disubstituted unsaturated compounds (Y–CH₂–X): cyanides, oximes and propenes; bearing 12 -substituents: F, Cl, Br, I, OMe, OEt, SMe, SEt, NMe₂, NEt₂, Me, and Et. The experimental ¹³C chemical shifts for the -carbon and functional carbon atoms are correlated with theoretically derived molecular properties, i.e. partial charges, electronegativity, hardness, dipole moments and the nuclear repulsion energies. In the first PCA, the clustering of these three classes of organic compounds occurred mostly because of the chemical shifts and partial charges, and also of the dipole moments, hardness and electronegativity parameters as confirmed by loading graph. A strong grouping is observed in the second PCA, showing the chemical shift dependence on the type of heteroatom substituents. Therefore, sulfur, nitrogen, oxygen and neutral groups exhibit four types of C-13 SCS influences, indicating that the heteroatom (Y) properties play a significant role on the effects on chemical shifts. The -halogenated compounds represent a very heterogeneous group due to possible orbital interactions between the functional group and the substituent. The third PCA shows the grouping of F, Cl, Br and I derivatives, confirming the second PCA results that same halogen presents the same or very similar effects on the chemical shifts.     

牛血清白蛋白与甲基橙结合反应的研究

用分光光度法研究了牛血清白蛋白与甲基登在酸性溶液中的结合反应，认为两者通过非共价键结合，研究了溶液吸光 度与组分浓度的关系，对Ｓｃａｔｃｈａｒｄ模型用于自理蛋白质染色反应时存在的总是作了讨论，提出了表观结合常数的概念，推导了求算表观结合常数和最大结合数的线性回归公式。     

Theoretical Definition of a Functional Group and the Molecular Orbital Paradigm

It is the purpose of this review to demonstrate that the empirical classification of the observations of chemistry in terms of the properties assigned to functional groups is a consequence of and is predicted by physics. This is accomplished by showing that the atoms and functional groups of chemistry can be identified with bounded space-filling objects whose properties are defined by quantum mechanics. The quantum mechanical definition of a group is combined with a new pictorial representation of its form to obtain a unified picture which should make it eminently recognizable to chemists. This picture, when combined with the demonstrated ability of these groups to recover the measured properties of atoms in molecules, is offered as one which meets the expectations a chemist associates with the concept of a functional group. The manner in which this physical definition of a group differs fundamentally from models of functional groups based upon molecular orbital theory is discussed.     

主动冷却点阵夹层防热结构温度响应计算模型北大核心CSCD

针对点阵夹层结构主动热防护问题,建立了夹层结构面板和芯体导热与冷却剂对流耦合的非稳态传热理论模型,利用有限体积法离散控制方程并在MATLAB中进行了迭代求解.模型首次考虑了面板与夹芯杆之间的收缩热阻,并利用分离变量法得到了收缩热阻的近似解析解.基于单胞模型和周期性边界条件,模拟得到了模型所需的表面对流传热系数h_(b)和h_(fin).最后,选取多单胞计算工况进行数值模拟和理论模型对比,并讨论了收缩热阻对模型预测精度的影响.结果表明:理论模型能够准确预测夹层结构及内部流体的温度变化,理论与仿真之间的最大误差不超过1%;随着外加热流密度不断增大,忽略收缩热阻使得计算结果造成的误差不断增大;与数值模拟相比,理论模型可显著地减少计算时间并节省计算资源,尤其适用于非均匀、非稳态复杂热载荷下点阵夹层结构的温度响应计算.     

The theoretical basis of column chromatography in multicomponent separations. Part 2: Peak capacity. Column systems with good selectivity

The selectivity of a column system, S, defined by equation 28, includes a variation coefficient (β) of plate number with capacity ratio which has a large influence on the peak capacity, as shown in Fig. 18. Some typical chromatograms are given. In order to predict S for a column system from Kovat's Index, equations 40 and 41 are given to calculate the constant of the carbon number rule for squalane at different temperatures or for different stationary phases. The specific retention value of heptane on squalane at different temperatures can be calculated from equation 42. The nonpolarity index, defined by equation 43, was used to calculate the retention value of heptane on various stationary phases. In liquid chromatography, the order of elution may be reversed by changing the composition of the eluent on the same chemically bonded silica (manufactured in China). The linear relations between the log retention values of different kinds of solutes or of a single solute on the silicas of different surface areas when using the same eluent are given.     

Molecular Structures from Density Functional Calculations with Simulated Annealing

The geometrical structure of any aggregate of atoms is one of its basic properties and, in principle, straightforward to predict. One chooses a structure, determines the total energy E of the system of electrons and ions, and repeats the calculation for all possible geometries. The ground state structure is that with the lowest energy. A quantum mechanical calculation of the exact wave function Ψ would lead to the total energy, but this is practicable only in very small molecules. Furthermore, the number of local minima in the energy surface increases dramatically with increasing molecular size. While traditional ab initio methods have had many impressive successes, these difficulties have meant that they have focused on systems with relatively few local minima, or have used experiment or experience to limit the range of geometries studied. On the other hand, calculations for much larger molecules and extended systems are often forced to use simplifying assumptions about the interatomic forces that limit their predictive capability. The approach described here avoids both of these extremes: Total energies of predictive value are calculated without using semi-empirical force laws, and the problem of multiple minima in the energy surface is addressed. The density functional formalism, with a local density approximation for the exchange-correlation energy, allows one to calculate the total energy for a given geometry in an efficient, if approximate, manner. Calculations for heavier elements are not significantly more difficult than for those in the first row and provide an ideal way to study bonding trends. When coupled with finite-temperature molecular dynamics, this formalism can avoid many of the energetically unfavorable minima in the energy surface. We show here that the method leads to surprising and exciting results.     

Electrochromic properties of poly(alkoxy-terthiophenes): an experimental and theoretical investigation

Much effort has been made to synthesize novel compounds and enhance the optical properties of poly(terthiophenes). The electrochromic properties of poly(4,4′′-dimetoxy-3′-methyl-2′-5′,2′′-terthiophene) (PDMMT) and poly(4,4′′-dipentoxy-3′-methyl-2′-5′,2′′-terthiophene) (PDPMT) have been studied focusing on the differences in the alkoxy-group length. Theoretical calculations were employed to elucidate the structural and thermodynamic stability of the monomers and dimmers. The results showed that in this type of thiophenes large alkoxy chains assist positive charge dispersion through hyperconjugative effect. Thus, PDPMT is thermodynamically more stable than PDMMT in the oxidized state, leading to better electrochromic stability and optical memory.